Verification Testing definition

Verification Testing means testing by BT of a CP Device in accordance with BT SIN498 and as described in Schedule 2B. Verification Testing is also known as modem conformance testing (or MCT);
Sample 1Sample 2Sample 3
Verification Testing shall be defined as the systematic process of comparing the actual operation of engineering prototype units of the Product to the functional and engineering specifications.
Sample 1
Verification Testing. The Grantor shall perform a verification test on the Product manufactured in accordance with the Technology. If the verification test indicates that the manufacture of the Product is in conformity with the technical specifications of the Technology, the verification test shall be considered to have been successfully completed. In the event that the verification is not successfully completed, the Grantor shall analyze the causes and take the necessary measures to eliminate the defects.
Sample 1

Examples of Verification Testing in a sentence

  • Amendments required the approval of Battelle’s Verification Testing Leader and Center Manager.

  • Summary of Daily Values for the Measured Meteorological Parameters During Phase I of Verification Testing Average3.350.09 Table 6-2.

  • Verification Testing of Air Pollution Control Technology – Quality Management Plan.

  • GDOT will perform Verification Testing at the asphalt plant as a part of the existing QPL process.

  • The Verification Testing Coordinator reviewed the raw data and the data sheets that were generated each day.

  • Any deviation required the approval signature of Battelle’s Verification Testing Leader.

  • Laboratory record notebooks were also signed and dated by testing staff and reviewed by the Verification Testing Leader.

  • Task 3 Signal Timing Development and ImplementationThe Consultant will implement new signal timing plans once ATSPM Verification, Testing, and Training procedures are complete.

  • The Verification Testing Leader reviewed the raw data and data sheets that were generated each day.

  • CDOT, or its representative, will perform Owner Verification Testing (OVT).


More Definitions of Verification Testing

Verification Testing means near simultaneous indoor and outdoor particulate
Sample 1

Related to Verification Testing

  • Test means such test as is prescribed by the particulars or considered necessary by the Inspecting Officer whether performed or made by the Inspecting Officer or any agency acting under the direction of the Inspecting Officer;

  • Verification Report As defined in Section 4.19.

  • Independent Verification means that an evaluation is undertaken and reported by an individual or body whose organisation, systems and procedures conform to ISO Guide 65:1996 (EN 45011:1998) General requirements for bodies operating product certification systems (as amended form time to time) or equivalent, and who is accredited to audit against forest management standards by a body whose organisation, systems and procedures conform to ISO 17011: 2004 General Requirements for Providing Assessment and Accreditation of Conformity Assessment Bodies (as amended from time to time) or equivalent.

  • Verification means the process of comparing sets of data to establish the validity of a claimed identity (one-to-one check);

  • Testing means that element of inspection that determines the properties or elements, including functional operation of materials, equipment, or their components, by the application of established scientific principles and procedures.

  • Penetration Testing means security testing in which assessors mimic real-world attacks to identify methods for circumventing the security features of an application, system, or network. (NIST SP 800-115)

  • Acceptance Testing mean the tests, reviews and other activities that are performed by or on behalf of Agency to determine whether the Deliverables meet the Acceptance Criteria or otherwise satisfy the Agency, as determined by the Agency in its sole discretion.

  • Start-Up Testing means the completion of applicable required factory and start-up tests as set forth in Exhibit C.

  • Commissioning Tests means all of the procedures and tests which, in accordance with the Reasonable and Prudent Standard, and in compliance with industry guidelines, practices and standards, are:

  • Screening Test means a drug or alcohol test which uses a method of analysis allowed by the Minnesota Drug and Alcohol Testing in the Workplace Act to be used for such purposes.

  • Root Cause Analysis Report means a report addressing a problem or non-conformance, in order to get to the ‘root cause’ of the problem, which thereby assists in correcting or eliminating the cause, and prevent the problem from recurring.

  • Commissioning test means tests applied to a distributed generation facility by the applicant after construction is completed to verify that the facility does not create adverse system impacts and performs to the submitted specifications. At a minimum, the scope of the commissioning tests performed shall include the commissioning test specified in Institute of Electrical and Electronics Engineers, Inc. (IEEE) Standard 1547 Section 5.4 "Commissioning tests".

  • Confirmation test means a drug or alcohol test on a sample to substantiate the results of a prior drug or alcohol test on the same sample and which uses different chemical principles and is of equal or greater accuracy than the prior drug or alcohol test;

  • Verification system means the system maintained by the department under section 19-24.1-31 for verification of registry identification cards.

  • Maintenance Test means the maintenance test set out in Clause 12.1 (Maintenance Test).

  • Percolation test means a subsurface soil test at the depth of a proposed absorption system or similar component of an OWTS to determine the water absorption capability of the soil, the results of which are normally expressed as the rate at which one inch of water is absorbed. The rate is expressed in minutes per inch.

  • Drug test means a test designed to detect the illegal use of a controlled substance.

  • Acceptance Tests means those tests performed during the Performance Period which are intended to determine compliance of Equipment and Software with the specifications and all other Attachments incorporated herein by reference and to determine the reliability of the Equipment.

  • Drug use test means a scientifically substantiated method to test for the presence of illegal or performance-enhancing drugs or the metabolites thereof in a person’s urine.

  • Busy Line Verification (BLV) means a service whereby an End User requests an operator to confirm the busy status of a line.

  • Acceptance Test is a test of the Features executed by the Customer to prepare the acceptance.

  • RDDS test Means one query sent to a particular “IP address” of one of the servers of one of the RDDS services. Queries shall be about existing objects in the Registry System and the responses must contain the corresponding information otherwise the query will be considered unanswered. Queries with an RTT 5 times higher than the corresponding SLR will be considered as unanswered. The possible results to an RDDS test are: a number in milliseconds corresponding to the RTT or undefined/unanswered.

  • Tests means and include such test or tests to be carried out on the part of the contractor as are prescribed in the contract or considered necessary by BHEL, in order to ascertain the quality, workmanship, performance and efficiency of the contractor or part thereof.

  • Independent testing laboratory means an independent organization, accepted by the Contracting Officer, engaged to perform specific inspections or tests of the work, either at the site or elsewhere, and report the results of these inspections or tests.

  • COVID-19 test means a viral test for SARS-CoV-2 that is:

  • CEC Certification and Verification means that the CEC has certified (or, with respect to periods before the Project has commenced commercial operation (as such term is defined by and according to the CEC), that the CEC has pre-certified) that the Project is an ERR for purposes of the California Renewables Portfolio Standard and that all Energy produced by the Project qualifies as generation from an ERR for purposes of the Project.