Common use of Certification audit Clause in Contracts

Certification audit. 2.2.1 The certification audit is conducted in two stages. Stage 1 is designed to provide an overview of the management system and the implementation status. Using this information, stage 2 of the audit may then be performed, where the implementation and compliance of the management system is verified. 2.2.2 The stage 1 and stage 2 audits may be performed immediately one after the other. However, if the stage 1 audit shows that certification readiness has not yet been 2.2.3 Stage 1 and stage 2 audits must not be more than 90 days apart for IATF 16949 standard. If there are more than 90 days between stage 1 and stage 2, the stage 1 audit must be repeated. 2.2.4 For determining the time between the stage 1 and stage 2 audits, client requirements as well as the necessary time for correcting weaknesses are considered. In general, the focus in terms of time is on the stage 2 audit. 2.2.5 If the Contractor is not able to review and accept the implementation of corrections and corrective actions of any major/ minor nonconformity including a special audit for Major non-conformity within 90 days after the last day of stage 2, the certification decision is negative and the client shall start over with an initial certification audit (stage 1 readiness review and stage 2).

Certification audit. 2.2.1 The certification audit is conducted in two stages. Stage 1 is designed to provide pro-vide an overview of the management system and the implementation status. Using this information, stage 2 of the audit may then be performed, where the implementation implementa-tion and compliance of the management system is verified. 2.2.2 The stage 1 and stage 2 audits may be performed immediately one after the other. However, if the stage 1 audit shows that certification readiness has not yet been 2.2.3 Stage 1 and stage 2 audits must not be more than 90 days apart for IATF 16949 standard. If there are more than 90 days between stage 1 and stage 2, the stage 1 audit must be repeated. 2.2.4 For determining the time between the stage 1 and stage 2 audits, client requirements re-quirements as well as the necessary time for correcting weaknesses are considered. In general, the focus in terms of time is on the stage 2 audit. 2.2.5 If the Contractor is not able to review and accept the implementation of corrections and corrective actions of any major/ minor nonconformity including a special audit for Major non-conformity within 90 days after the last day of stage 2, the certification decision is negative and the client shall start over with an initial certification audit (stage 1 readiness review and stage 2).