100 Shopping and Dining
100 Shopping and Dining Sample Clauses
Related to 100 Shopping and Dining
Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.
Employee Training and Discipline Contractor agrees to advise its personnel who have access to Medi-Cal PII of the confidentiality of the information, the safeguards required to protect the information, and the civil and criminal sanctions for non-compliance contained in applicable Federal and State laws. Contractor shall:
Directory Listing and Directory Distribution 41 5. Voice Information Service Traffic 43 6. Intercept and Referral Announcements 44 7. Originating Line Number Screening (OLNS) 44 8. Operations Support Systems (OSS) Services 44 9. Poles, Ducts, Conduits and Xxxxxx-xx-Xxx 00 00. Telephone Numbers 51 11. Routing for Operator Services and Directory Assistance Traffic 51 12. Unauthorized Carrier Change Charges 52 13. Good Faith Performance 52 INTERCONNECTION ATTACHMENT. 53 1. General 53 2. Points of Interconnection and Trunk Types 53 3. Alternative Interconnection Arrangements 57 4. Initiating Interconnection 58 5. Transmission and Routing of Telephone Exchange Service Traffic 59
Justice and Dignity The Parties agree that in certain situations, it may be in the best interest of both Employer and employees that employees be reassigned or removed from all job sites during an investigation of conduct. In cases where an employee cannot be reassigned, the employee shall be considered to be on a leave of absence without loss of pay until the Employer makes a decision relative to imposing discipline.
Printing and Distribution The School District will, at its own expense, print sufficient copies of this Agreement for present and new employees.
Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. Purchaser may buck out cull material when necessary to produce pieces meeting Utilization Standards. Such bucked out material shall contain a minimum amount of sound wood, not in excess of the net scale in percentage of gross scale, or based on the merchantability factor, whichever is stated in A2. If necessary to assess extent of defect, Purchaser shall make sample saw cuts or wedges. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.
SHIPPING AND AIR TRANSPORT 1. Profits of an enterprise of a Contracting State from the operation of ships or aircraft in international traffic shall be taxable only in that State.
Branding for Operator Call Processing and Directory Assistance 8.4.1 BellSouth's branding feature provides a definable announcement to Telepak Networks end users using Directory Assistance (DA)/ Operator Call Processing (OCP) prior to placing such end users in queue or connecting them to an available operator or automated operator system. This feature allows Telepak Networks’ name on whose behalf BellSouth is providing Directory Assistance and/or Operator Call Processing. Rates for the branding features are set forth in Exhibit D.
Gaming, betting and lotteries The Hirer shall ensure that nothing is done on or in relation to the premises in contravention of the law relating to gaming, betting and lotteries.
Switching and Tagging Rules Each Party shall provide the other Parties a copy of its switching and tagging rules that are applicable to the other Parties’ activities. Such switching and tagging rules shall be developed on a non-discriminatory basis. The Parties shall comply with applicable switching and tagging rules, as amended from time to time, in obtaining clearances for work or for switching operations on equipment.
