Anadromous Fish Passage and Off-Site Mitigation Sample Clauses

Anadromous Fish Passage and Off-Site Mitigation. Maintain and/or restore native anadromous fish populations.
Sample 1
AutoNDA by SimpleDocs

Related to Anadromous Fish Passage and Off-Site Mitigation

  • Use of Interconnection Facilities by Third Parties 6551 Error! Hyperlink reference not valid.9.9.1 Purpose of Interconnection Facilities. 6551

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CSTC chooses to subtend a Verizon access Tandem, CSTC’s NPA/NXX must be assigned by CSTC to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG. 9.2.2 CSTC shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from CSTC’s Customers. 9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office CSTC utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA. 9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow CSTC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.

  • RECOVERY FROM THIRD PARTIES 11.1 If 11.1.1 the Seller makes a payment in respect of a Warranty Claim by the Purchaser (the “Damages Payment”); 11.1.2 any member of the Purchaser’s Group recovers from a third party (including pursuant to any insurance policy) any sum in cash or in kind which compensates it in respect of the Loss which is the subject matter to that Warranty Claim (the “Third Party Sum”); 11.1.3 the receipt of that Third Party Sum was not taken into account in calculating the Damages Payment; and 11.1.4 the aggregate of the Third Party Sum and the Damages Payment exceeds the amount required to compensate the Purchaser in full for the Loss or Liability which gave rise to the Warranty Claim in question, such excess being the “Excess Recovery”, then the Purchaser shall, promptly on receipt of the Third Party Sum by any member of the Purchaser’s Group, repay to the Seller an amount equal to the lower of (i) the Excess Recovery and (ii) the Damages Payment, after deducting (in either case) all additional Tax and any costs incurred by the Purchaser or the relevant member of the Purchaser’s Group in recovering that Third Party Sum. 11.2 If, before the Seller pays any amount in respect of any Warranty Claim under this Agreement, any EDS Entity is entitled to recover (whether by payment, discount, credit, relief, insurance or otherwise) from a third party a sum which indemnifies or compensates any relevant member of the Purchaser’s Group (in whole or in part) in respect of the Loss or Liability which is the subject matter of the Warranty Claim, the Purchaser shall procure that, before steps are taken against the Seller, the Purchaser will make reasonable efforts to enforce recovery against the third party and any actual recovery shall reduce or satisfy, as applicable, such Warranty Claim to the extent of such recovery, provided that the Seller first indemnifies the Purchaser’s Group and the EDS Entities against any Tax that may be suffered on receipt of any sum recovered thereunder, together with any costs or expenses incurred in recovering such sum.

  • Unbundled Loop Modifications (Line Conditioning 2.5.1 Line Conditioning is defined as routine network modification that BellSouth regularly undertakes to provide xDSL services to its own customers. This may include the removal of any device, from a copper Loop or copper Subloop that may diminish the capability of the Loop or Subloop to deliver high-speed switched wireline telecommunications capability, including xDSL service. Such devices include, load coils, excessive bridged taps, low pass filters, and range extenders. Excessive bridged taps are bridged taps that serves no network design purpose and that are beyond the limits set according to industry standards and/or the BellSouth’s TR 73600 Unbundled Local Loop Technical Specification. 2.5.2 BellSouth will remove load coils only on copper Loops and Subloops that are less than eighteen thousand (18,000) feet in length. 2.5.3 For any copper loop being ordered by NewPhone which has over six thousand (6,000) feet of combined bridged tap will be modified, upon request from NewPhone, so that the loop will have a maximum of six thousand (6,000) feet of bridged tap. This modification will be performed at no additional charge to NewPhone. Loop conditioning orders that require the removal of bridged tap that serves no network design purpose on a copper Loop that will result in a combined total of bridged tap between two thousand five hundred (2,500) and six thousand (6,000) feet will be performed at the rates set forth in Exhibit A. 2.5.4 NewPhone may request removal of any unnecessary and non-excessive bridged tap (bridged tap between zero (0) and two thousand five hundred (2,500) feet which serves no network design purpose), at rates pursuant to BellSouth’s SC Process as mutually agreed to by the Parties. 2.5.5 Rates for ULM are as set forth in Exhibit A. 2.5.6 BellSouth will not modify a Loop in such a way that it no longer meets the technical parameters of the original Loop type (e.g., voice grade, ADSL, etc.) being ordered. 2.5.7 If NewPhone requests ULM on a reserved facility for a new Loop order, BellSouth may perform a pair change and provision a different Loop facility in lieu of the reserved facility with ULM if feasible. The Loop provisioned will meet or exceed specifications of the requested Loop facility as modified. NewPhone will not be charged for ULM if a different Loop is provisioned. For Loops that require a DLR or its equivalent, BellSouth will provide LMU detail of the Loop provisioned. 2.5.8 NewPhone shall request Loop make up information pursuant to this Attachment prior to submitting a service inquiry and/or a LSR for the Loop type that NewPhone desires BellSouth to condition. 2.5.9 When requesting ULM for a Loop that BellSouth has previously provisioned for NewPhone, NewPhone will submit a SI to BellSouth. If a spare Loop facility that meets the Loop modification specifications requested by NewPhone is available at the location for which the ULM was requested, NewPhone will have the option to change the Loop facility to the qualifying spare facility rather than to provide ULM. In the event that BellSouth changes the Loop facility in lieu of providing ULM, NewPhone will not be charged for ULM but will only be charged the service order charges for submitting an order.

  • Convicted, Discriminatory, Antitrust Violator, and Suspended Vendor Lists In accordance with sections 287.133, 287.134, and 287.137, F.S., the Contractor is hereby informed of the provisions of sections 287.133(2)(a), 287.134(2)(a), and 287.137(2)(a), F.S. For purposes of this Contract, a person or affiliate who is on the Convicted Vendor List, the Discriminatory Vendor List, or the Antitrust Violator Vendor List may not perform work as a contractor, supplier, subcontractor, or consultant under the Contract. The Contractor must notify the Department if it or any of its suppliers, subcontractors, or consultants have been placed on the Convicted Vendor List, the Discriminatory Vendor List, or the Antitrust Violator Vendor List during the term of the Contract. In accordance with section 287.1351, F.S., a vendor placed on the Suspended Vendor List may not enter into or renew a contract to provide any goods or services to an agency after its placement on the Suspended Vendor List. A firm or individual placed on the Suspended Vendor List pursuant to section 287.1351, F.S., the Convicted Vendor List pursuant to section 287.133, F.S., the Antitrust Violator Vendor List pursuant to section 287.137, F.S., or the Discriminatory Vendor List pursuant to section 287.134, F.S., is immediately disqualified from Contract eligibility.

  • DELIVERY, STORAGE, AND HANDLING The Contractor shall be responsible to inspect all components on delivery to ensure that no damage occurred during shipping or handling for furnish and installation projects. For equipment only purchases, the ordering entity shall be responsible to inspect all components on delivery. Materials must be stored in original undamaged packaging in such a manner to ensure proper ventilation and drainage, and to protect against damage, weather, vandalism, and theft until ready for installation.

  • Set Off; Mitigation The Company’s obligation to pay Employee the amounts provided and to make the arrangements provided hereunder shall be subject to set-off, counterclaim, or recoupment of amounts owed by Employee to the Company or its affiliates; provided, however, that to the extent any amount so subject to set-off, counterclaim, or recoupment is payable in installments hereunder, such set-off, counterclaim, or recoupment shall not modify the applicable payment date of any installment, and to the extent an obligation cannot be satisfied by reduction of a single installment payment, any portion not satisfied shall remain an outstanding obligation of Employee and shall be applied to the next installment only at such time the installment is otherwise payable pursuant to the specified payment schedule. Employee shall not be required to mitigate the amount of any payment provided pursuant to this Agreement by seeking other employment or otherwise, and except as provided in Section 8(d)(iv) hereof, the amount of any payment provided for pursuant to this Agreement shall not be reduced by any compensation earned as a result of Employee’s other employment or otherwise.

  • Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.

  • Permitted and Required Uses/Disclosures of PHI 3.1 Except as limited in this Agreement, Business Associate may use or disclose PHI to perform Services, as specified in the underlying grant or contract with Covered Entity. The uses and disclosures of Business Associate are limited to the minimum necessary, to complete the tasks or to provide the services associated with the terms of the underlying agreement. Business Associate shall not use or disclose PHI in any manner that would constitute a violation of the Privacy Rule if used or disclosed by Covered Entity in that manner. Business Associate may not use or disclose PHI other than as permitted or required by this Agreement or as Required by Law. 3.2 Business Associate may make PHI available to its employees who need access to perform Services provided that Business Associate makes such employees aware of the use and disclosure restrictions in this Agreement and binds them to comply with such restrictions. Business Associate may only disclose PHI for the purposes authorized by this Agreement: (a) to its agents and Subcontractors in accordance with Sections 9 and 17 or, (b) as otherwise permitted by Section 3. 3.3 Business Associate shall be directly liable under HIPAA for impermissible uses and disclosures of the PHI it handles on behalf of Covered Entity, and for impermissible uses and disclosures, by Business Associate’s Subcontractor(s), of the PHI that Business Associate handles on behalf of Covered Entity and that it passes on to Subcontractors.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!