APPENDIX 2-LOW TEMPERATURE MEASUREMENTS. This Appendix describes the procedures for low temperature measurements on strands. Any alternative technique proposed by the Supplier is subject to approval by F4E.
APPENDIX 2-LOW TEMPERATURE MEASUREMENTS Sample Clauses
Related to APPENDIX 2-LOW TEMPERATURE MEASUREMENTS
Measurement and Monitoring Tools As of the Effective date, Vendor and Prudential will mutually agree on the measurements and service level management procedures, pursuant to the governance procedures set forth in Attachment G and performance standards set forth in Attachment E-1 and E-2, to measure Vendor's performance of the Services against the applicable Service Levels. Such measurement and monitoring tools and procedures will (a) for Attachment E-1, be implemented upon the Effective Date; (b) for Attachment E-2, be implemented after successful completion of all testing and written acceptance by Prudential of the Transition Services set forth in Attachment B-1; (c) permit reporting at a level of detail sufficient to verify compliance with the Service Levels; and (d) be subject to audit by Prudential or its designee in accordance with the Agreement, except such audit will not include the installation of any audit software on Vendor's network.
Service Levels (1) DTI shall perform the Services in accordance with the service levels (the "Service Levels") as may be agreed to from time to time in writing by DTI and the Funds (the "Service Level Agreement"). Failure to perform in a manner which equals or exceeds the Service Levels shall result in fee credits ("Fee Credits") or the Funds' right to terminate this Agreement, as set forth in the Service Level Agreement.
Cost of Metering The Issuer shall not be obligated to pay any costs associated with the routine metering duties set forth in this Section 2, including the costs of installing, replacing and maintaining meters, nor shall the Issuer be entitled to any credit against the Servicing Fee for any cost savings realized by the Servicer as a result of new metering and/or billing technologies.
Performance Measure The number of Performance Shares earned at the end of the three-year Performance Period will vary depending on the degree to which cumulative adjusted earnings per share performance goals for the Performance Period, as established by the Committee, are met.
Measurement All quantities of Products received or delivered by or into truck, rail, or marine vessel shall be measured and determined based upon the meter readings at each Terminal, as reflected by delivery tickets or bills of lading, or if such meters are unavailable, by applicable calibration tables. All quantities of Products received and delivered by pipeline shall be measured and determined based upon the meter readings of the pipeline operator, as reflected by delivery tickets, or if such meters are unavailable, by applicable calibration tables. Deliveries to a Terminal rack at Mandan, Salt Lake City or Wilmington from a Tesoro Refinery shall be deemed to be the same as the corresponding volumes delivered contemporaneously from the Terminal rack. Deliveries by book transfer shall be reflected by entries in the books of TLO. All quantities shall be adjusted to net gallons at 60° F in accordance with ASTM D-1250 Petroleum Measurement Tables, or latest revisions thereof. A barrel shall consist of 42 U.S. gallons and a gallon shall contain 231 cubic inches. Meters and temperature probes shall be calibrated according to applicable API standards. Tesoro shall have the right, at its sole expense, and in accordance with rack location procedure, to independently certify said calibration. Storage tank gauging shall be performed by TLO’s personnel. TLO’s gauging shall be deemed accurate unless challenged by an independent certified xxxxxx. Tesoro may perform joint gauging at its sole expense with TLO’s personnel at the time of delivery or receipt of Product, to verify the amount involved. If Tesoro should request an independent xxxxxx, such xxxxxx must be acceptable to TLO, and such gauging shall be at Tesoro’s sole expense.
Testing Procedure Limitations The Asset Representations Reviewer will only be required to perform the Tests, and will not be obligated to perform additional procedures on any Review Receivable or to provide any information other than a Review Report. However, the Asset Representations Reviewer may provide additional information in a Review Report about any Review Receivable that it determines in good faith to be material to the Asset Representations Review.
Technical Specifications Each Bloom System is an integrated system comprised of a fuel cell stack assembly and associated balance of plant components that converts a fuel into electricity using electrochemical means that (i) has a Nameplate Capacity of at least 0.5 kilowatts of electricity using an electrochemical process and (ii) has an electricity-only generation efficiency greater than thirty percent (30%).
Temperature The Committed Gas shall not have a temperature of less than forty degrees Fahrenheit (40°F) nor more than one hundred twenty degrees Fahrenheit (120°F).
Performance Measures The extent, if any, to which you shall have the right to payment of the Award shall depend upon your satisfying one of the continuous employment conditions set forth in Section 3 and the extent to which the applicable performance measure has been satisfied as of the Final Measurement Date, as specified below: The Award shall have the following performance measures during the Measurement Period:
Thresholds Each Restricted Fund has one or more thresholds at which point no further amounts may be allocated to that division. Compliance with a threshold is verified whenever there is a transaction initiated which is subject to such threshold (premium payments, transfers, withdrawals). A threshold is applied to the total Accumulation Value of each Restricted Fund. Thresholds may be changed by the Company for new premiums, transfers or withdrawals by Restricted Fund upon 30 day notice.
