Application Procedure 7.4.1. Application Priority........................................ 7.4.2. [Reserved].................................................. 7.4.3. Advance Payments............................................
Application Procedures i) An employee applies for a listing on the system-wide registry through the employee’s Human Resources Department by completing the form in Appendix A.
ii) The institution will immediately forward the completed form to the PSEA who will list eligible employees on the system-wide registry.
iii) A registrant is responsible to ensure the information is current and to immediately notify the Employer and the local Union if the registrant is no longer available for employment through the Registry.
Application Process The employees wishing to enter into a job share arrangement will apply in writing to the Employer and forward a copy to the Union outlining the proposed commencement date of the job share, how the hours and days of work will be shared and how communication and continuity of work will be maintained. The Employer shall communicate a decision on a job share request in writing to the applicants. Applications to Job Sharing shall not be unreasonably denied.
Mobile Application If Red Hat offers products and services through applications available on your wireless or other mobile Device (such as a mobile phone) (the "Mobile Application Services"), these Mobile Application Services are governed by the applicable additional terms governing such Mobile Application Service. Red Hat does not charge for these Mobile Application Services unless otherwise provided in the applicable additional terms. However, your wireless carrier's standard messaging rates and other messaging, data and other rates and charges will apply to certain Mobile Application Services. You should check with your carrier to find out what plans your carrier offers and how much the plans cost. In addition, the use or availability of certain Mobile Application Services may be prohibited or restricted by your wireless carrier, and not all Mobile Application Services may work with all wireless carriers or Devices. Therefore, you should check with your wireless carrier to find out if the Mobile Application Services are available for your wireless Device, and what restrictions, if any, may be applicable to your use of such Mobile Application Services.
Scope of Application Except as otherwise provided in this Agreement, the dispute settlement provisions of this Chapter shall apply with respect to the settlement of all disputes between the Parties regarding the interpretation or application of this Agreement, whenever a Party considers that the other Party has failed to carry out its obligations under this Agreement.
Application Form To apply for a pole attachment or conduit occupancy license under this Agreement, Applicant shall submit to SWBT two signed copies of the appropriate application forms. SWBT represents that the forms specified in subsections (a)-(b) are forms in use prior to the effective date of this Agreement and that SWBT is in the process of revising such forms to conform to the provisions of this Agreement and to streamline the application process. The parties therefore agree that the forms specified in subsections (a) and (b) will be interim forms only. SWBT reserves the right to change the format and content of these forms upon 60 days written notice to Applicant.
(a) To apply for a pole attachment license, Applicant shall submit to SWBT two signed copies of SWBT’s Form SW-9434 (“Access Application and Make- Ready Authorization”) together with completed Form SW-9433 (“Pole Attachments”). An application for a pole attachment license will not be complete or subject to processing by SWBT until these forms have been submitted to SWBT; provided, however, that such forms will be deemed to be substantially complete if they contain the information specified in subsections (c)-(h) below, as applicable. Copies of Forms SW-9433 and SW-9434 are attached to this Agreement as parts of APPENDIX III.
(b) To apply for a conduit occupancy license, Applicant shall submit to SWBT two signed copies of SWBT’s Form SW-9434 (“Access Application and Make-Ready Authorization”) together with completed Form SW-9435 (“Conduit Occupancy”). An application for a conduit occupancy license will not be complete or subject to processing by SWBT until these forms have been submitted to SWBT; provided, however, that such forms will be deemed to be substantially complete if they contain the information specified in subsections (c)-(h) below, as applicable. Copies of Forms SW-9434 and SW-9435 are attached to this Agreement as parts of APPENDIX III.
(c) Each application for a license under this Agreement shall include, at a minimum, the following information:
(1) the poles, ducts, and conduits (including all manholes) along Applicant’s proposed route to or within which Applicant desires to attach or place its facilities;
(2) a description of the facilities to be attached to SWBT’s poles and a description of the facilities to be placed within each component of SWBT’s conduit system (including but not limited to ducts, conduits, manholes, and handholes) along the proposed route;
(3) for poles, the proposed points of attachment;
(4) for building entrance or building distribution ducts or conduits or other space within a building, a conspicuous statement, as required by Section 5.06 of this Agreement, that the application pertains to a building entrance or building distribution duct or conduit or other space within a building;
(5) if applicable, a conspicuous notation that the space requested is not to be assigned (or billed) to Applicant until SWBT has received Applicant’s written instruction to make such assignment or issued a license authorizing Applicant to occupy the space requested; and
(6) if applicable, a conspicuous statement that Applicant intends to occupy the space before the issuance of a license, as provided in Section 8.03 of this Agreement.
(d) Facilities descriptions which apply to multiple pole attachments or conduit occupancies need only be described once on any form. Facilities descriptions shall include, at a minimum, the following information:
(1) the number and types of cables, including the physical size (diameter) and weight (weight per foot);
(2) the number and types of strands, if any, which will be used to support the cables, including the rated holding capacity expressed in thousand pound increments (e.g., 2.2M) of such strands; and
(3) sufficient information to identify and describe the physical characteristics (size, dimensions, and weight) of apparatus enclosures and other facilities to be attached to SWBT’s poles or placed in SWBT’s conduit system.
(e) When it appears to Applicant that facilities modification, capacity expansion, or make-ready work may be required to accommodate Applicant’s access requests, Applicant shall describe the facilities modification, capacity expansion, or make-ready work which Applicant proposes. Applicant shall also describe its plans, if any, to use any infrequent construction technique or connectivity solution authorized under Section 6.03 to avoid high or unusual expenditures and state its reasons for the use of such technique or solution.
(f) Applicant acknowledges that the poles along a particular pole line or route may include poles owned by firms (such as electric utilities) other than SWBT, that it may be necessary for SWBT to rearrange its facilities or perform other make-ready work on poles other than poles it owns or controls in order to accommodate Applicant’s request for access to SWBT’s poles and that, at the time an application is submitted, it may be difficult for Applicant to determine with certainty whether a particular pole is owned or controlled by SWBT or by another entity. Accordingly, the application shall, to the extent feasible, identify all poles utilized by SWBT (without regard to ownership) along Applicant’s proposed route.
(g) Each application for a license under this Agreement shall be accompanied by a construction schedule showing Applicant’s projected dates for beginning and completing construction at the sites specified in the application. Information on this schedule may be used by SWBT’s engineering and outside plant construction personnel in scheduling work required to process Applicant’s applications and scheduling such capacity expansions, make- ready work, and facilities modifications, if any, as may be necessary to accommodate Applicant’s facilities.
(h) Applicant may include multiple cables in a single license application and may provide multiple services (e.g., CATV and non-CATV services) under the same cable sheath or jacket. When both CATV and non-CATV services are provided under the same cable sheath or jacket, or CATV and non-CATV services are provided using different cables attached or lashed to the same strand or otherwise occupying the same space on a pole or the same duct or inner duct within a conduit, Applicant will so advise SWBT and SWBT shall, if permitted by law, adjust its charges to enable SWBT to charge Applicant the rate applicable to telecommunications carriers rather than the rate applicable to cable television systems solely to provide cable service.
Application of Agreement If the Company has secured work outside of the County of Cumberland, an employee whom normally works within the County of Cumberland:
i) Will be paid at the rates outlined in this agreement if specifically requested by the Company to work on that site.
ii) May be offered work at that location at the rates that apply for that area and if applicable, taking into account clause 27, Distant Work.
iii) May determine that redundancy would be more appropriate. Where there is any inconsistency between this Agreement and the Parent Award, the Agreement shall prevail to the extent of the inconsistency.
Application of Policy The policy is to apply to everyone on site without distinction.
General Application The rules set forth below in this Article VI shall apply for the purposes of determining each Member’s allocable share of the items of income, gain, loss and expense of the Company comprising Net Income or Net Loss for each Fiscal Year, determining special allocations of other items of income, gain, loss and expense, and adjusting the balance of each Member’s Capital Account to reflect the aforementioned general and special allocations. For each Fiscal Year, the special allocations in Section 6.03 hereof shall be made immediately prior to the general allocations of Section 6.02 hereof.
Application of Code Section 409A 8.1 Notwithstanding anything in this Agreement to the contrary, the receipt of any benefits under this Agreement as a result of a termination of employment will be subject to satisfaction of the condition precedent that you undergo a “separation from service” within the meaning of Treas. Reg. § 1.409A-1(h) or any successor thereto. In addition, if you are deemed to be a “specified employee” within the meaning of that term under Code Section 409A(a)(2)(B), then with regard to any payment or the provisions of any benefit that is required to be delayed pursuant to Code Section 409A(a)(2)(B), such payment or benefit will not be made or provided prior to the earlier of (i) the expiration of the six (6) month period measured from the date of your “separation from service” (as such term is defined in Treas. Reg. § 1.409A-1(h)), or (ii) the date of your death (the “Delay Period”). Within 10 days following the expiration of the Delay Period, all payments and benefits delayed pursuant to this Section (whether they would have otherwise been payable in a single sum or in installments in the absence of such delay) will be paid or reimbursed to you in a lump sum, and any remaining payments and benefits due under this Agreement will be paid or provided in accordance with the normal payment dates specified for them herein. To the extent that the foregoing applies to the provision of any ongoing welfare benefits to you that would not be required to be delayed if the premiums therefore were paid by you, you will pay the full costs of premiums for such welfare benefits during the Delay Period and the Corporation or the Bank will pay you an amount equal to the amount of such premiums paid by you during the Delay Period within 10 days after the conclusion of such Delay Period.
8.2 Except as otherwise expressly provided herein, to the extent any expense reimbursement or other in-kind benefit is determined to be subject to Code Section 409A, the amount of any such expenses eligible for reimbursement or in-kind benefits in one calendar year will not affect the expenses eligible for reimbursement or in-kind benefits in any other taxable year (except under any lifetime limit applicable to expenses for medical care), in no event will any expenses be reimbursed or in-kind benefits be provided after the last day of the calendar year following the calendar year in which you incurred such expenses or received such benefits, and in no event will any right to reimbursement or in-kind benefits be subject to liquidation or exchange for another benefit.
8.3 Any payments made pursuant to Section 2.1, to the extent of payments made from the date of termination through March 15th of the calendar year following such date, are intended to constitute separate payments for purposes of Treas. Reg. §1.409A-2(b)(2) and thus payable pursuant to the “short-term deferral” rule set forth in Treas. Reg. §1.409A-1(b)(4); to the extent such payments are made following said March 15th, they are intended to constitute separate payments for purposes of Treas. Reg. §1.409A-2(b)(2) made upon an involuntary termination from service and payable pursuant to Treas. Reg. §1.409A-1(b)(9)(iii), to the maximum extent permitted by said provision.
8.4 To the extent it is determined that any benefits described in Section 2.1(b) are taxable to you, they are intended to be payable pursuant to Treas. Reg. §1.409A-1(b)(9)(v), to the maximum extent permitted by said provision.
