Common use of AREA MEASUREMENT Clause in Contracts

AREA MEASUREMENT. The length of the sample shall be measured in three locations, 12.7 mm from each end and in the middle, and recorded as L1, L2 and L3 (Figure 3). In the same manner, the width shall be measured and recorded as W1, W2 and W3 (Figure 3). These measurements shall be taken on the centreline of the thickness. The crush area shall then be calculated as: A = (L1 + L2 + L3) x (W1 + W2 + W3)

Appears in 3 contracts

Samples: Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles, Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles, Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles

AutoNDA by SimpleDocs

AREA MEASUREMENT. The length of the sample shall be measured in three locations, 12.7 mm from each end and in the middle, and recorded as L1, L2 and L3 (Figure 33 of this annex). In the same manner, the width shall be measured and recorded as W1, W2 and W3 (Figure 33 of this annex). These measurements shall be taken on the centreline of the thickness. The crush area shall then be calculated as: A = (L1 +  L1  L2 + L3)  L3  x (W1 + W1  W2 + W3) W3 

Appears in 2 contracts

Samples: Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles, Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles

AREA MEASUREMENT. The length of the sample shall be measured in three locations, 12.7 locations,12.7 mm from each end and in the middle, and recorded as L1, L2 and L3 (Figure 3). In the same manner, the width shall be measured and recorded as W1, W2 and W3 (Figure 3). These measurements shall be taken betaken on the centreline of the thickness. The crush area shall then be calculated as: A = (L1 + L2 + L3) x (W1 + W2 + W3):

Appears in 1 contract

Samples: Regulation No. 94

AutoNDA by SimpleDocs

AREA MEASUREMENT. The length of the sample shall be measured in three locations, 12.7 mm from each end and in the middle, and recorded as L1, L2 and L3 (Figure 33 of this annex). In the same manner, the width shall be measured and recorded as W1, W2 and W3 (Figure 33 of this annex). These measurements shall be taken on the centreline of the thickness. The crush area shall then be calculated as: A = (L1 + L2 + L3L3 ) x (W1 + W2 + W3W3 )

Appears in 1 contract

Samples: Agreement Concerning the Adoption of Harmonized Technical United Nations Regulations for Wheeled Vehicles

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!