MANAGEMENT OF EVALUATION OUTCOMES 12.1 Where the Employer is, any time during the Employee’s employment, not satisfied with the Employee’s performance with respect to any matter dealt with in this Agreement, the Employer will give notice to the Employee to attend a meeting;
12.2 The Employee will have the opportunity at the meeting to satisfy the Employer of the measures being taken to ensure that his performance becomes satisfactory and any programme, including any dates, for implementing these measures;
12.3 Where there is a dispute or difference as to the performance of the Employee under this Agreement, the Parties will confer with a view to resolving the dispute or difference; and
12.4 In the case of unacceptable performance, the Employer shall –
12.4.1 Provide systematic remedial or developmental support to assist the Employee to improve his performance; and
12.4.2 After appropriate performance counselling and having provided the necessary guidance and/or support as well as reasonable time for improvement in performance, the Employer may consider steps to terminate the contract of employment of the Employee on grounds of unfitness or incapacity to carry out his or her duties.
Musculoskeletal Injury Prevention and Control The hospital in consultation with the Joint Health and Safety Committee (JHSC) shall develop, establish and put into effect, musculoskeletal prevention and control measures, procedures, practices and training for the health and safety of employees.
CFR PART 200 Procurement of Recovered Materials A non-Federal entity that is a state agency or agency of a political subdivision of a state and its contractors must comply with section 6002 of the Solid Waste Disposal Act, as amended by the Resource Conservation and Recovery Act. The requirements of Section 6002 include procuring only items designated in guidelines of the Environmental Protection Agency (EPA) at 40 CFR part 247 that contain the highest percentage of recovered materials practicable, consistent with maintaining a satisfactory level of competition, where the purchase price of the item exceeds $10,000 or the value of the quantity acquired during the preceding fiscal year exceeded $10,000; procuring solid waste management services in a manner that maximizes energy and resource recovery; and establishing an affirmative procurement program for procurement of recovered materials identified in the EPA guidelines. Does vendor certify that it is in compliance with the Solid Waste Disposal Act as described above? Yes
Environmentally Preferable Procurement Policy The Environmentally Preferable Procurement Policy, along with a brief policy description, is located on the City’s website at the following link: xxxx://xxx.xxxxxxxxx.xxx/esd/natural-energy-resources/epp.htm. Environmental procurement policies and activities related to the completion of any Work will include, whenever practicable, but are not limited to: The use of recycled and/or recyclable products in daily operations (i.e. 30%, 50%, 100% PCW paper, chlorine process free, triclosan free hand cleaner, etc.); The use of energy-star compliant equipment; The use of alternative fuel and hybrid vehicles, and implementation of protocols aimed at increasing the efficiency of vehicle operation; The implementation of internal waste reduction and reuse protocol(s); and Water and resource conservation activities within facilities, including bans on individual serving bottled water and the use of compostable food service products.
Management of Special and Technical Environment Each certificated support person demonstrates an acceptable level of performance in managing and organizing the special materials, equipment and environment essential to the specialized programs.
Vulnerability Management BNY Mellon will maintain a documented process to identify and remediate security vulnerabilities affecting its systems used to provide the services. BNY Mellon will classify security vulnerabilities using industry recognized standards and conduct continuous monitoring and testing of its networks, hardware and software including regular penetration testing and ethical hack assessments. BNY Mellon will remediate identified security vulnerabilities in accordance with its process.
RECOGNITION OUTCOMES The receiving institution commits to provide the sending institution and the student with a Transcript of Records within a period stipulated in the inter-institutional agreement and normally not longer than five weeks after publication/proclamation of the student’s results at the receiving institution. The Transcript of Records from the receiving institution will contain at least the minimum information requested in this Learning Agreement template. Table E (or the representation that the institution makes of it) will include all the educational components agreed in table A and, if there were changes to the study programme abroad, in table C. In addition, grade distribution information should be included in the Transcript of Records or attached to it (a web link where this information can be found is enough). The actual start and end dates of the study period will be included according to the following definitions: The start date of the study period is the first day the student has been present at the receiving institution, for example, for the first course, for a welcoming event organised by the host institution or for language and intercultural courses. The end date of the study period is the last day the student has been present at the receiving institution and not his actual date of departure. This is, for example, the end of exams period, courses or mandatory sitting period. Following the receipt of the Transcript of Records from the receiving institution, the sending institution commits to provide to the student a Transcript of Records, without further requirements from the student, and normally within five weeks. The sending institution's Transcript of Records must include at least the information listed in table F (the recognition outcomes) and attach the receiving institution's Transcript of Record. In case of mobility windows, table F may be completed as follows: Component code (if any) Title of recognised component (as indicated in the course catalogue) at the sending institution Number of ECTS credits Sending institution grade, if applicable Mobility window Total: 30 ….. Where applicable, the sending institution will translate the grades received by the student abroad, taking into account the grade distribution information from the receiving institution (see the methodology described in the ECTS Users' Guide). In addition, all the educational components will appear as well in the student's Diploma Supplement. The exact titles from the receiving institution will also be included in the Transcript of Records that is attached to the Diploma Supplement. P Additional educational components above the number of ECTS credits required in his/her curriculum are listed in the LA and if the sending institution will not recognise them as counting towards their degree, this has to be agreed by all parties concerned and annexed to the LA
Virus Management DST shall maintain a malware protection program designed to deter malware infections, detect the presence of malware within DST environment.
Professional Development; Adverse Consequences of School Exclusion; Student Behavior The Board President or Superintendent, or their designees, will make reasonable efforts to provide ongoing professional development to Board members about the adverse consequences of school exclusion and justice-system involvement, effective classroom management strategies, culturally responsive discipline, appropriate and available supportive services for the promotion of student attendance and engagement, and developmentally appropriate disciplinary methods that promote positive and healthy school climates, i.e., Senate Bill 100 training topics. The Board will conduct periodic self-evaluations with the goal of continuous improvement. New Board Member Orientation The orientation process for newly elected or appointed Board members includes:
DEVELOPMENT OR ASSISTANCE IN DEVELOPMENT OF SPECIFICATIONS REQUIREMENTS/ STATEMENTS OF WORK
