COMPLIANCE WITH TAX LAW SECTION 5-a The following provisions apply to Contractors that have entered into agreements in an amount exceeding $100,000 for the purchase of goods and services: a) Before such agreement can take effect, the Contractor must have on file with the New York State Department of Taxation and Finance a Contractor Certification form (ST-220-TD). b) Prior to entering into such an agreement, the Contractor is required to provide NYSERDA with a completed Contractor Certification to Covered Agency form (Form ST-220-CA). c) Prior to any renewal period (if applicable) under the agreement, the Contractor is required to provide NYSERDA with a completed Form ST-220-CA. Certifications referenced in paragraphs (b) and (c) above will be maintained by NYSERDA and made a part hereof and incorporated herein by reference. NYSERDA reserves the right to terminate this agreement in the event it is found that the certification filed by the Contractor in accordance with Tax Law Section 5-a was false when made.
Compliance with Agreements, Laws, Etc It shall (i) duly observe and comply in all material respects with all Applicable Laws relative to the conduct of its business or to its assets, (ii) preserve and keep in full force and effect its legal existence, (iii) preserve and keep in full force and effect its rights, privileges, qualifications and franchises, except where the failure to do so could not reasonably be expected to result in a Material Adverse Effect, (iv) comply with the terms and conditions of each Facility Document to which it is a party and its Constituent Documents and (v) obtain, maintain and keep in full force and effect all Governmental Authorizations, Private Authorizations and Governmental Filings which are necessary to properly carry out its business and the transactions contemplated to be performed by it under the Facility Documents to which it is a party and its Constituent Documents, except, in the case of this clause (v), where the failure to do so would not reasonably be expected to have a Material Adverse Effect.