Limitation of Vendor Indemnification and Similar Clauses This is a requirement of the TIPS Contract and is non-negotiable TIPS, a department of Region 8 Education Service Center, a political subdivision, and local government entity of the State of Texas, is prohibited from indemnifying third-parties (pursuant to the Article 3, Section 52 of the Texas Constitution) except as otherwise specifically provided for by law or as ordered by a court of competent jurisdiction. Article 3, Section 52 of the Texas Constitution states that "no debt shall be created by or on behalf of the State … " and the Texas Attorney General has opined that a contractually imposed obligation of indemnity creates a "debt" in the constitutional sense. Tex. Att'y Gen. Op. No. MW-475 (1982). Thus, contract clauses which require TIPS to indemnify Vendor, pay liquidated damages, pay attorney's fees, waive Vendor's liability, or waive any applicable statute of limitations must be deleted or qualified with ''to the extent permitted by the Constitution and Laws of the State of Texas." Does Vendor agree? Yes, I Agree Alternative Dispute Resolution Limitations This is a requirement of the TIPS Contract and is non-negotiable. TIPS, a department of Region 8 Education Service Center, a political subdivision, and local government entity of the State of Texas, does not agree to binding arbitration as a remedy to dispute and no such provision shall be permitted in this Agreement with TIPS. Vendor agrees that any claim arising out of or related to this Agreement, except those specifically and expressly waived or negotiated within this Agreement, may be subject to non-binding mediation at the request of either party to be conducted by a mutually agreed upon mediator as prerequisite to the filing of any lawsuit arising out of or related to this Agreement. Mediation shall be held in either Camp or Titus County, Texas. Agreements reached in mediation will be subject to the approval by the Region 8 ESC's Board of Directors, authorized signature of the Parties if approved by the Board of Directors, and, once approved by the Board of Directors and properly signed, shall thereafter be enforceable as provided by the laws of the State of Texas. Does Vendor agree? Yes, Vendor agrees Does Vendor agree? Yes, Vendor agrees No Waiver of TIPS Immunity This is a requirement of the TIPS Contract and is non-negotiable. Vendor agrees that nothing in this Agreement shall be construed as a waiver of sovereign or government immunity; nor constitute or be construed as a waiver of any of the privileges, rights, defenses, remedies, or immunities available to Region 8 Education Service Center or its TIPS Department. The failure to enforce, or any delay in the enforcement, of any privileges, rights, defenses, remedies, or immunities available to Region 8 Education Service Center or its TIPS Department under this Agreement or under applicable law shall not constitute a waiver of such privileges, rights, defenses, remedies, or immunities or be considered as a basis for estoppel. 5 Does Vendor agree? Yes, Vendor agrees Payment Terms and Funding Out Clause This is a requirement of the TIPS Contract and is non-negotiable. Vendor agrees that TIPS and TIPS Members shall not be liable for interest or late-payment fees on past-due balances at a rate higher than permitted by the laws or regulations of the jurisdiction of the TIPS Member. Funding-Out Clause: Vendor agrees to abide by the applicable laws and regulations, including but not limited to Texas Local Government Code § 271.903, or any other statutory or regulatory limitation of the jurisdiction of any TIPS Member, which requires that contracts approved by TIPS or a TIPS Member are subject to the budgeting and appropriation of currently available funds by the entity or its governing body. 2
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
Exceptions to Limitations These limitations of liability do not apply to breaches of confidentiality obligations, violations of a party’s Intellectual Property Rights by the other party, indemnification obligations, or Customer's payment obligations.
Limitations and Exceptions In calculating a Recovery, the following shall not be included:
Exceptions and Limitations For the avoidance of doubt, where Exceptions and Limitations apply to Your use, this Public License does not apply, and You do not need to comply with its terms and conditions.
Securities Law Matters Employee acknowledges that the Shares to be received by him or her upon exercise of the Option may have not been registered under the Securities Act of 1933 or the Blue Sky laws of any state (collectively, the “Securities Acts”). If such Shares have not been so registered, Employee acknowledges and understands that the Company is under no obligation to register, under the Securities Acts, the Shares received by him or her or to assist him or her in complying with any exemption from such registration if he or she should at a later date wish to dispose of the Shares. Employee acknowledges that if not then registered under the Securities Acts, the Shares shall bear a legend restricting the transferability thereof, such legend to be substantially in the following form: “The shares represented by this certificate have not been registered or qualified under federal or state securities laws. The shares may not be offered for sale, sold, pledged or otherwise disposed of unless so registered or qualified, unless an exemption exists or unless such disposition is not subject to the federal or state securities laws, and the Company may require that the availability or any exemption or the inapplicability of such securities laws be established by an opinion of counsel, which opinion of counsel shall be reasonably satisfactory to the Company.”
Requirements Pertaining Only to Federal Grants and Subrecipient Agreements If this Agreement is a grant that is funded in whole or in part by Federal funds:
Transaction Limitations The Account balance may never be less than the principal owed on the obligation secured by this Account plus all accrued interest and fees. If You exceed these limitations, Your Account may be subject to closure by the Credit Union. SPECIFIC TERMS APPLICABLE TO YOUR MONEY MARKET ACCOUNT Tiered Variable Rate Information. This Account is subject to a Tiered Variable Rate. For the current dividend rate and corresponding APY, refer to the accompanying Account Disclosure Rate Supplement which We have included with and made a part of this Disclosure. Minimum Balance Requirements. The minimum balance required to open this Account is $1,000.00. SPECIFIC TERMS APPLICABLE TO YOUR HIGH YIELD MONEY MARKET ACCOUNT Tiered Variable Rate Information. This Account is subject to a Tiered Variable Rate. For the current dividend rate and corresponding APY, refer to the accompanying Account Disclosure Rate Supplement which We have included with and made a part of this Disclosure. Minimum Balance Requirements. The minimum balance required to open this Account is $25,000.00. SPECIFIC TERMS APPLICABLE TO YOUR BASIC BUSINESS CHECKING ACCOUNT Dividend Information. No dividends are paid on this Account. Minimum Balance Requirements. No minimum balance requirements apply to this Account. Transaction Limitations. No transaction limitations apply to this Account. SPECIFIC TERMS APPLICABLE TO YOUR BUSINESS MONEY MARKET CHECKING ACCOUNT Tiered Variable Rate Information. These Accounts are subject to a Tiered Variable Rate. For the current dividend rate and corresponding APY, refer to the accompanying Account Disclosure Rate Supplement which We have included with and made a part of this Disclosure. Minimum Balance Requirements. No minimum balance requirements apply to this Account. Transaction Limitations. No transaction limitations apply to this Account. SPECIFIC TERMS APPLICABLE TO YOUR ONE TIME BUMP CERTIFICATE ACCOUNT Fixed Rate Information. This Account is subject to a Fixed Rate. For the current dividend rate and corresponding APY, refer to the accompanying Account Disclosure Rate Supplement which We have included with and made a part of this Disclosure. After establishing Your Account, You may make one request to have Your One Time Bump Certificate Account rate increased to a rate equal to that of a regular Certificate Account having the same term to maturity as Your original term. In that event, Your original term to maturity will remain unchanged, and the increased rate will only apply to the remaining term of Your Account.
