Correction Factor Equations Sample Clauses

Correction Factor Equations. The following correction curves, to be provided in APPENDIX D, will provide the equations and the correction factors to use in the above correction equations. Note that the ∆i corrections are additive in units of kW, while ai and ßi corrections are multiplicative and are dimensionless. The correction curves are based on Combustion Turbine and Steam Turbine correction curves provided by GE. Exhibit 4.2-29
AutoNDA by SimpleDocs

Related to Correction Factor Equations

  • Rounding of Calculations; Minimum Adjustments All calculations under this Section 13 shall be made to the nearest one-tenth (1/10th) of a cent or to the nearest one- hundredth (1/100th) of a share, as the case may be. Any provision of this Section 13 to the contrary notwithstanding, no adjustment in the Exercise Price or the number of Shares into which this Warrant is exercisable shall be made if the amount of such adjustment would be less than $0.01 or one-tenth (1/10th) of a share of Common Stock, but any such amount shall be carried forward and an adjustment with respect thereto shall be made at the time of and together with any subsequent adjustment which, together with such amount and any other amount or amounts so carried forward, shall aggregate $0.01 or 1/10th of a share of Common Stock, or more.

  • ADJUSTMENT FACTORS The Contractor will perform any or all Tasks in the Construction Task Catalog for the Unit Price appearing therein multiplied by the following Adjustment Factors. See the General Terms and Conditions for additional information.

  • Non pre-priced Adjustment Factor To be applied to Work determined not to be included in the CTC but within the general scope of the work: 1.6500.

  • Utility Adjustments DB Contractor shall not commence or permit or suffer commencement of construction of a Utility Adjustment included in the Construction Work until TxDOT issues NTP2, all of the conditions set forth in Section 4.4.1 that are applicable to the Utility Adjustment (reading such provisions as if they referred to the Utility Adjustment) have been satisfied, and the following additional requirements have been satisfied: (a) If applicable, the Alternate Procedure List has been approved by FHWA, and either the affected Utility or the Utility Owner is on the approved Alternate Procedure List, as supplemented. (b) The Utility Adjustment is covered by an executed Utility Agreement. (c) The review and comment process has been completed and any required approvals have been obtained for the Utility Assembly covering the Utility Adjustment.

  • Power Factor Design Criteria Developer shall design the Large Generating Facility to maintain an effective power delivery at demonstrated maximum net capability at the Point of Interconnection at a power factor within the range established by the Connecting Transmission Owner on a comparable basis, until NYISO has established different requirements that apply to all generators in the New York Control Area on a comparable basis. The Developer shall design and maintain the plant auxiliary systems to operate safely throughout the entire real and reactive power design range. The Connecting Transmission Owner shall not unreasonably restrict or condition the reactive power production or absorption of the Large Generating Facility in accordance with Good Utility Practice.

  • Linear Interpolation Where Linear Interpolation is specified as applicable in respect of an Interest Period in the applicable Final Terms, the Rate of Interest for such Interest Period shall be calculated by the Agent by straight line linear interpolation by reference to two rates based on the relevant Reference Rate (where Screen Rate Determination is specified as applicable in the applicable Final Terms) or the relevant Floating Rate Option (where ISDA Determination is specified as applicable in the applicable Final Terms), one of which shall be determined as if the Designated Maturity were the period of time for which rates are available next shorter than the length of the relevant Interest Period and the other of which shall be determined as if the Designated Maturity were the period of time for which rates are available next longer than the length of the relevant Interest Period provided however that if there is no rate available for a period of time next shorter or, as the case may be, next longer, then the Agent shall determine such rate at such time and by reference to such sources as it determines appropriate.

  • Calculation Dates The interest rate applicable to each Interest Reset Period will be determined by the Calculation Agent on or prior to the Calculation Date (as defined below), except with respect to LIBOR, which will be determined on the particular Interest Determination Date. Upon request of the Holder of a Floating Rate Note, the Calculation Agent will disclose the interest rate then in effect and, if determined, the interest rate that will become effective as a result of a determination made for the next succeeding Interest Reset Date with respect to such Floating Rate Note. The “Calculation Date”, if applicable, pertaining to any Interest Determination Date will be the earlier of: (1) the tenth calendar day after the particular Interest Determination Date or, if such day is not a Business Day, the next succeeding Business Day; or (2) the Business Day immediately preceding the applicable Interest Payment Date or the Maturity Date, as the case may be.

  • Performance Adjustment Rate Except as otherwise provided in sub-paragraph (e) of this paragraph 3, the Performance Adjustment Rate is 0.02% for each percentage point (the performance of the Portfolio and the Index each being calculated to the nearest .01%) that the Portfolio's investment performance for the performance period was better or worse than the record of the Index as then constituted. The maximum performance adjustment rate is 0.20%. For purposes of calculating the performance adjustment of the portfolio, the portfolio's investment performance will be based on the performance of the retail class. The performance period will commence with the first day of the first full month following the retail class's commencement of operations. During the first eleven months of the performance period for the retail class, there will be no performance adjustment. Starting with the twelfth month of the performance period, the performance adjustment will take effect. Following the twelfth month a new month will be added to the performance period until the performance period equals 36 months. Thereafter the performance period will consist of the current month plus the previous 35 months. The Portfolio's investment performance will be measured by comparing (i) the opening net asset value of one share of the retail class of the Portfolio on the first business day of the performance period with (ii) the closing net asset value of one share of the retail class of the Portfolio as of the last business day of such period. In computing the investment performance of the retail class of the Portfolio and the investment record of the Index, distributions of realized capital gains, the value of capital gains taxes per share paid or payable on undistributed realized long-term capital gains accumulated to the end of such period and dividends paid out of investment income on the part of the Portfolio, and all cash distributions of the securities included in the Index, will be treated as reinvested in accordance with Rule 205-1 or any other applicable rules under the Investment Advisers Act of 1940, as the same from time to time may be amended.

  • True-Up Adjustments From time to time, until the Retirement of the Recovery Bonds, the Servicer shall identify the need for True-Up Adjustments and shall take all reasonable action to obtain and implement such True-Up Adjustments, all in accordance with the following:

  • Workplace adjustment An employer wishing to employ a person under the provisions of this clause shall take reasonable steps to make changes in the workplace to enhance the employee’s capacity to do the job. Changes may involve re-design of job duties, working time arrangements and work organisation in consultation with other employees in the area.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!