Cost Out Methodologies and Source Documents
Cost Out Methodologies and Source Documents Sample Clauses
Related to Cost Out Methodologies and Source Documents
Originating Switched Access Detail Usage Data A category 1101XX record as defined in the EMI Telcordia Practice BR-010-200- 010.
SHOP DRAWINGS, PRODUCT DATA AND SAMPLES 4.12.1 Shop Drawings are drawings, diagrams, schedules and other, data specially prepared for the Work by the Contractor or any Subcontractor, manufacturer, supplier or distributor to illustrate some portion of the Work. 4.12.2 Product Data are illustrations, standard schedules, performance charts, instructions, brochures, diagrams and other information furnished by the Contractor to illustrate a material, product or system for some portion of the Work. 4.12.3 Samples are physical examples which illustrate materials, equipment or workmanship and establish standards by which the Work will be judged. 4.12.4 The Contractor shall review, approve and submit, with reasonable promptness and in such sequence as to cause no delay in the Work or in the work of the State or any separate contractor, all Shop Drawings, Product Data and Samples required by the Contract Documents. 4.12.5 By approving and submitting Shop Drawings, Product Data and Samples, the Contractor represents that he / she has determined and verified all materials, field measurements, and field construction criteria related thereto, or will do so, and that he / she has checked and coordinated the information contained within such submittals with the requirements of the Work and of the Contract Documents. 4.12.6 The Contractor shall not be relieved of responsibility for any deviation from the requirements of the Contract Documents by the Architect's approval of Shop Drawings, Product Data or Samples under Subparagraph 2.2.7 of these General Conditions unless the Contractor has specifically informed the Architect and the State in writing of such deviation at the time of sub- mission and the Architect and the State has given written approval to the specific deviation. The Contractor shall not be relieved from responsibility for errors or omissions in the Shop Drawings, Product Data or Samples by the Architect's approval thereof. 4.12.7 The Contractor shall direct specific attention, in writing or on resubmitted Shop Drawings, Product Data or Samples, to revisions other than those requested by the Architect on previous submittals. 4.12.8 No portion of the Work requiring submission of a Shop Drawing, Product Data or Sample shall be commenced until the submittal has been approved by the Architect as provided in Subparagraph 2.2.7 of these General Conditions. All such portions of the Work shall be in accordance with approved submittals.
Proposed Policies and Procedures Regarding New Online Content and Functionality By October 31, 2017, the School will submit to OCR for its review and approval proposed policies and procedures (“the Plan for New Content”) to ensure that all new, newly-added, or modified online content and functionality will be accessible to people with disabilities as measured by conformance to the Benchmarks for Measuring Accessibility set forth above, except where doing so would impose a fundamental alteration or undue burden. a) When fundamental alteration or undue burden defenses apply, the Plan for New Content will require the School to provide equally effective alternative access. The Plan for New Content will require the School, in providing equally effective alternate access, to take any actions that do not result in a fundamental alteration or undue financial and administrative burdens, but nevertheless ensure that, to the maximum extent possible, individuals with disabilities receive the same benefits or services as their nondisabled peers. To provide equally effective alternate access, alternates are not required to produce the identical result or level of achievement for persons with and without disabilities, but must afford persons with disabilities equal opportunity to obtain the same result, to gain the same benefit, or to reach the same level of achievement, in the most integrated setting appropriate to the person’s needs. b) The Plan for New Content must include sufficient quality assurance procedures, backed by adequate personnel and financial resources, for full implementation. This provision also applies to the School’s online content and functionality developed by, maintained by, or offered through a third-party vendor or by using open sources. c) Within thirty (30) days of receiving OCR’s approval of the Plan for New Content, the School will officially adopt, and fully implement the amended policies and procedures.
Procurement of Recovered Materials In the performance of this contract, the Contractor shall make maximum use of products containing recovered materials that are EPA-designated items unless the product cannot be acquired
MSAA Indicator Technical Specification Document This Agreement shall be interpreted with reference to the MSAA Indicator Technical Specifications document.
Software License Terms (a) Software that is made available by a Provider to Recipient in connection with any Service (any such Software being referred to herein as “TSA-Licensed Software”) provided hereunder will be subject to the terms set forth in this Section 3.5 except as otherwise provided in the applicable Service Schedule. The Provider hereby grants to the Recipient a non-exclusive, non-transferable license to use, in object code form, any TSA-Licensed Software that is made available by the Provider pursuant to a Service Schedule. For the avoidance of doubt, the Provider that makes available any TSA-Licensed Software in connection with the provision of any Service retains the unrestricted right to enhance or otherwise modify such TSA-Licensed Software at any time, provided that such enhancements or other modifications do not disrupt the provision of such Service to the Recipient. (b) The Recipient may not exceed the number of licenses, agents, tiers, nodes, seats, or other use restrictions or authorizations, if any, specified in the applicable Service Schedule. Some TSA-Licensed Software may require license keys or contain other technical protection measures. The Recipient acknowledges that the Provider may monitor the Recipient’s compliance with use restrictions and authorizations remotely, or otherwise. If the Provider makes a license management program available which records and reports license usage information, the Recipient agrees to appropriately install, configure and execute such license management program. (c) Unless otherwise permitted by the Provider, the Recipient may only make copies or adaptations of the TSA-Licensed Software for archival purposes or when copying or adaptation is an essential step in the authorized use of TSA-Licensed Software. If the Recipient makes a copy for backup purposes and installs such copy on a backup device, the Recipient may not operate such backup installation of the TSA-Licensed Software without paying an additional license fee, except in cases where the original device becomes inoperable. If a copy is activated on a backup device in response to failure of the original device, the use on the backup device must be discontinued when the original or replacement device becomes operable. The Recipient may not copy the TSA-Licensed Software onto or otherwise use or make it available on, to, or through any public or external distributed network. Licenses that allow use over the Recipient’s intranet require restricted access by authorized users only. (d) The Recipient must reproduce all copyright notices that appear in or on the TSA-Licensed Software (including documentation) on all permitted copies or adaptations. Copies of documentation are limited to internal use. (e) Notwithstanding anything to the contrary herein, certain TSA-Licensed Software may be licensed under the applicable Service Schedule for use only on a computer system owned, controlled, or operated by or solely on behalf of the Recipient and may be further identified by the Provider by the combination of a unique number and a specific system type (“Designated System”) and such license will terminate in the event of a change in either the system number or system type, an unauthorized relocation, or if the Designated System ceases to be within the possession or control of the Recipient. (f) The Recipient will not modify, reverse engineer, disassemble, decrypt, decompile, or make derivative works of the TSA-Licensed Software. Where the Recipient has other rights mandated under statute, the Recipient will provide the Provider with reasonably detailed information regarding any intended modifications, reverse engineering, disassembly, decryption, or decompilation and the purposes therefor. (g) The Recipient may permit a consultant or subcontractor to use TSA-Licensed Software at the licensed location for the sole purpose of providing services to the Recipient. (h) Upon expiration or termination of the Service Schedule under which TSA-Licensed Software is made available, the Recipient will destroy the TSA-Licensed Software. The Recipient will remove and destroy or return to the Provider any copies of the TSA-Licensed Software that are merged into adaptations, except for individual pieces of data in the Recipient’s database. The Recipient will provide certification of the destruction of TSA-Licensed Software, and copies thereof, to the Provider. The Recipient may retain one copy of the TSA-Licensed Software subsequent to expiration or termination solely for archival purposes. (i) The Recipient may not sublicense, assign, transfer, rent, or lease the TSA-Licensed Software to any other person except as permitted in this Section 3.5. (j) The Recipient agrees that the Provider may engage a third party designated by the Provider and approved by the Recipient (such approval not to be unreasonably withheld) to audit the Recipient’s compliance with the Software License terms. Any such audit will be at the Provider’s expense, require reasonable notice, and will be performed during normal business hours. Such third party will be required to execute a non-disclosure agreement that restricts such third party from disclosing confidential information of the Recipient to the Provider, except to the extent required to report on the extent to which the Recipient is not in compliance with the Software License terms.
Interconnection Customer Drawings Within one hundred twenty (120) days after the date of Initial Operation, unless the Interconnection Parties agree on another mutually acceptable deadline, the Interconnection Customer shall deliver to the Transmission Provider and the Interconnected Transmission Owner final, “as-built” drawings, information and documents regarding the Customer Interconnection Facilities, including, as and to the extent applicable: a one-line diagram, a site plan showing the Customer Facility and the Customer Interconnection Facilities, plan and elevation drawings showing the layout of the Customer Interconnection Facilities, a relay functional diagram, relaying AC and DC schematic wiring diagrams and relay settings for all facilities associated with the Interconnection Customer's step-up transformers, the facilities connecting the Customer Facility to the step-up transformers and the Customer Interconnection Facilities, and the impedances (determined by factory tests) for the associated step-up transformers and the Customer Facility. As applicable, the Interconnection Customer shall provide Transmission Provider and the Interconnected Transmission Owner specifications for the excitation system, automatic voltage regulator, Customer Facility control and protection settings, transformer tap settings, and communications.
Competitive Supplier’s Standard Credit Policy The Competitive Supplier will not require a credit review for any consumer participating in the Program, nor does Competitive Supplier require any consumer to post any security deposit as a condition for participation in the Program. The Competitive Supplier may terminate service to a Participating Consumer and return such consumer to Basic Service in the event that the consumer fails to pay to Competitive Supplier amounts past-due greater than sixty (60) days.
System Upgrade Facilities and System Deliverability Upgrades Connecting Transmission Owner shall design, procure, construct, install, and own the System Upgrade Facilities and System Deliverability Upgrades described in Appendix A hereto. The responsibility of the Developer for costs related to System Upgrade Facilities and System Deliverability Upgrades shall be determined in accordance with the provisions of Attachment S to the NYISO OATT.
Loop Testing/Trouble Reporting 2.1.6.1 Telepak Networks will be responsible for testing and isolating troubles on the Loops. Telepak Networks must test and isolate trouble to the BellSouth portion of a designed/non-designed unbundled Loop (e.g., UVL-SL2, UCL-D, UVL-SL1, UCL-ND, etc.) before reporting repair to the UNE Customer Wholesale Interconnection Network Services (CWINS) Center. Upon request from BellSouth at the time of the trouble report, Telepak Networks will be required to provide the results of the Telepak Networks test which indicate a problem on the BellSouth provided Loop. 2.1.6.2 Once Telepak Networks has isolated a trouble to the BellSouth provided Loop, and had issued a trouble report to BellSouth on the Loop, BellSouth will take the actions necessary to repair the Loop if a trouble actually exists. BellSouth will repair these Loops in the same time frames that BellSouth repairs similarly situated Loops to its End Users. 2.1.6.3 If Telepak Networks reports a trouble on a non-designed or designed Loop and no trouble actually exists, BellSouth will charge Telepak Networks for any dispatching and testing (both inside and outside the CO) required by BellSouth in order to confirm the Loop’s working status. 2.1.6.4 In the event BellSouth must dispatch to the end-user’s location more than once due to incorrect or incomplete information provided by Telepak Networks (e.g., incomplete address, incorrect contact name/number, etc.), BellSouth will xxxx Xxxxxxx Networks for each additional dispatch required to repair the circuit due to the incorrect/incomplete information provided. BellSouth will assess the applicable Trouble Determination rates from BellSouth’s FCC or state tariffs.
