Geographic Area and Sector Specific Allowances, Conditions and Exceptions The following allowances and conditions shall apply where relevant. Where the Employer does work which falls under the following headings, the Employer agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.
Covenants and Conditions All provisions of this Lease to be observed or performed by Lessee are both covenants and conditions.
GENERAL WORKING CONDITIONS Section 18-1. Employment begins and ends at each project site. Section 18-2. The selection of craft foremen and/or general foremen and the number of foremen required shall be entirely the responsibility of the Employer, it being understood that in the selection of such foremen and/or general foremen the Employer will give primary consideration to the qualified individuals available in the local area. After giving such consideration, the Employer may select such individuals from other areas. All foremen shall take orders from the designated Employer representatives. Craft foremen shall be designated working foremen at the request of the Employer. Section 18-3. There shall be no limit on production by employees nor restrictions on the full use of tools or equipment. Employees using tools shall perform any of the work of the trade and shall work under the direction of the craft foremen. There shall be no restrictions on efficient use of manpower other than as may be required by safety regulations. Section 18-4. Employees shall be at their place of work at the starting time and shall remain at their place of work performing their assigned functions under the supervision of the Employer until quitting time. The parties reaffirm their policy of a fair day’s work for a fair day’s wage. Section 18-5. All equipment assigned to a project shall be under the control of the Employer. The Employer shall have the right to determine how many pieces of equipment an individual employee shall operate. In an emergency, foremen shall operate any equipment assigned by the Employer, and there shall be no restriction on foremen in the use of the tools of his or her craft in such emergency. The foremen shall be from the craft normally operating the equipment. In accordance with currently recognized craft jurisdiction, the Employer shall determine the assignment of employees to start, stop, and maintain small portable construction equipment. Such work may be assigned to craft employees within a reasonable distance of their primary duties or an employee may be assigned full time to start, stop and maintain the Employer’s small, portable equipment on the job site. There shall be no over xxxxxxx of this type of equipment. The number of employees assigned to rigging and scaffolding operations shall be at the sole discretion of the Employer. The ratio of journeyperson to welders shall be determined solely by the Employer. Section 18-6. The Employer may utilize the most efficient methods or techniques of construction, tools or other labor saving devices to accomplish the work. Practices not a part of the terms and conditions of this Agreement, stand by crews and feather bedding practices will not be recognized. Section 18-7. It is recognized that specialized or unusual equipment may be installed and/ or serviced by individuals who have special training, skill, or qualifications and are not covered by this Agreement. Testing, inspection, or service performed on plant equipment under warranty may be performed by the vendor’s personnel. Section 18-8. Neither the Union nor its local unions shall coerce or in any way interfere with the Owner’s personnel, operation or facilities at the plant site. The Owner’s right to contract directly with other companies for work at the plant site shall not be limited, and the Union shall cooperate and not interfere with the Employer’s operations. Section 18-9. It is agreed that overtime is undesirable and not in the best interest of the industry or the employees; therefore, except in unusual circumstances, overtime will not be worked. Where unusual circumstances do exist, however, the Employer will have the right to assign specific employees and/or crews to perform such overtime work as is necessary to accomplish the job. Section 18-10. There will be no rest periods, organized coffee breaks or other non-working time established during working hours. Section 18-11. Individual seniority shall not be recognized or applied to employees working on projects under this Agreement. Section 18-12. The Employer shall establish such reasonable project rules as the Employer deems appropriate. These rules will be reviewed at the pre-job conference and posted at the project site by the Employer, and may be amended thereafter as necessary.
Conditions to Xxxxx’x Obligations The obligations of Xxxxx hereunder with respect to a Placement will be subject to the continuing accuracy and completeness of the representations and warranties made by the Company herein, to the due performance by the Company of its obligations hereunder, to the completion by Xxxxx of a due diligence review satisfactory to Xxxxx in its reasonable judgment, and to the continuing satisfaction (or waiver by Xxxxx in its sole discretion) of the following additional conditions:
Exception to Obligations Neither Party's obligations under this Section shall apply to the extent the infringement is caused by: (i) modification of the facilities or equipment (including software) by the indemnitee; (ii) use by the indemnitee of the facilities or equipment (including software) in combination with equipment or facilities (including software) not provided or authorized by the indemnitor, provided the facilities or equipment (including software) would not be infringing if used alone; (iii) conformance to specifications of the indemnitee which would necessarily result in infringement; or (iv) continued use by the indemnitee of the affected facilities or equipment (including software) after being placed on notice to discontinue use as set forth herein.
Agreements and Conditions On or before the Closing Date, Seller shall have complied with and duly performed and satisfied in all material respects all agreements and conditions on its part to be complied with and performed by such date pursuant to this Agreement.
CONDITIONS TO EACH BUYER’S OBLIGATION TO PURCHASE The obligation of each Buyer hereunder to purchase the Notes and Warrants at the Closing is subject to the satisfaction, at or before the Closing Date of each of the following conditions, provided that these conditions are for such Buyer’s sole benefit and may be waived by such Buyer at any time in its sole discretion: a. The Company shall have executed this Agreement and the Registration Rights Agreement, and delivered the same to the Buyer. b. The Company shall have delivered to such Buyer duly executed Notes (in such denominations as the Buyer shall request) and Warrants in accordance with Section 1(b) above. c. The Irrevocable Transfer Agent Instructions, in form and substance satisfactory to a majority-in-interest of the Buyers, shall have been delivered to and acknowledged in writing by the Company’s Transfer Agent. d. The representations and warranties of the Company shall be true and correct in all material respects as of the date when made and as of the Closing Date as though made at such time (except for representations and warranties that speak as of a specific date) and the Company shall have performed, satisfied and complied in all material respects with the covenants, agreements and conditions required by this Agreement to be performed, satisfied or complied with by the Company at or prior to the Closing Date. The Buyer shall have received a certificate or certificates, executed by the chief executive officer of the Company, dated as of the Closing Date, to the foregoing effect and as to such other matters as may be reasonably requested by such Buyer including, but not limited to certificates with respect to the Company’s Certificate of Incorporation, By-laws and Board of Directors’ resolutions relating to the transactions contemplated hereby. e. No litigation, statute, rule, regulation, executive order, decree, ruling or injunction shall have been enacted, entered, promulgated or endorsed by or in any court or governmental authority of competent jurisdiction or any self-regulatory organization having authority over the matters contemplated hereby which prohibits the consummation of any of the transactions contemplated by this Agreement. f. No event shall have occurred which could reasonably be expected to have a Material Adverse Effect on the Company. g. The Conversion Shares and Warrant Shares shall have been authorized for quotation on the OTCBB and trading in the Common Stock on the OTCBB shall not have been suspended by the SEC or the OTCBB. h. The Buyer shall have received an opinion of the Company’s counsel, dated as of the Closing Date, in form, scope and substance reasonably satisfactory to the Buyer and in substantially the same form as Exhibit “D” attached hereto. i. The Buyer shall have received an officer’s certificate described in Section 3(c) above, dated as of the Closing Date.
Covenants and Conditions; Construction of Agreement All provisions of this Lease to be observed or performed by Lessee are both covenants and conditions. In construing this Lease, all headings and titles are for the convenience of the Parties only and shall not be considered a part of this Lease. Whenever required by the context, the singular shall include the plural and vice versa. This Lease shall not be construed as if prepared by one of the Parties, but rather according to its fair meaning as a whole, as if both Parties had prepared it.
GENERAL COVENANTS, CONDITIONS AND AGREEMENTS The Company hereby further covenants and agrees with each Purchaser as follows:
Conditions to All Parties’ Obligations Notwithstanding any other provision of this Agreement to the contrary, the obligations of each of the parties to this Agreement to consummate the transactions described herein shall be conditioned upon the satisfaction of each of the following conditions precedent on or prior to the Closing Date: