Daily Gross. Sample a) The Gross Sample collected as per clause 4.7.1(i) for determination of moisture, ash & GCV on equilibrated basis shall be reduced into laboratory sample on the date immediately following the date of collection. The final laboratory samples will be divided into two parts viz. Set – I and Set – II, as follows; Set – I shall be used for third party analysis to determine the ash, moisture and GCV as per BIS standards IS 1350 Part-I, 1984 and IS 1350 Part-II-1970 respectively.. Set – II shall be kept under joint seal of the Seller, Purchaser and the Third Party as referee sample in the safe custody of Third Party at the loading end for a period of fourteen (14) days or until the analysis results of Set – I are accepted without dispute, whichever is earlier. b) The sample in Set -I shall be analysed for ash, moisture and GCV on equilibrated basis {wherever required in accordance with IS: 1350 (Part –I) – 1984 and IS: 1350 (Part – II) – 1970}. c) Set-I of the laboratory sample as prepared shall be analyzed by the Third Party in the laboratory at the loading end as per relevant part of IS: 1350 (Part –I) – 1984 and IS: 1350 (Part – II) – 1970 within three-four (3-4) days from the date of preparation and distribution of laboratory sample for analysis of moisture and GCV. d) In the event of any dispute (which shall be raised not later than forty-eight (48) hours after analysis) at the time of Third Party analysis of Set-I, the referee sample as in Set- II shall be referred for analysis within seventy two (72) hours of the dispute but not later than eight (8) days of the collection of samples at any mutually agreed Government laboratory. The cost incurred for the analysis of the Referee sample including cost of transportation to the Government Laboratory shall be borne total by the Party raising the dispute e) The procedure for storage of referee sample shall be mutually agreed upon by both the Parties.
Appears in 1 contract
Samples: Coal Supply Agreement
Daily Gross. Sample
a) The Gross Sample collected as per clause 4.7.1(i) from a rake and/or day’s supply for determination of moisture, ash & and GCV on equilibrated basis shall be jointly reduced into laboratory sample on the date immediately following the date of collection. The final laboratory samples will be divided into two parts viz. Set – I and Set – II, as follows; follows Set – I shall be used for third party joint analysis to determine the ash, moisture and GCV as per BIS standards IS 1350 Part-I, I ,1984 and IS 1350 Part-II-1970 II- 1970 respectively.. . Set – II shall be kept under joint seal of the Seller, Purchaser and the Third Party as referee stand-by sample in the safe custody of Third Party at the loading end for a period of fourteen (14) days or until the analysis results of Set – I are accepted without dispute, whichever is earlier.
b) The sample in Set -I shall be analysed for ash, moisture and GCV on equilibrated basis {wherever required in accordance with IS: 1350 (Part –I) – 1984 and IS: 1350 (Part – II) – 1970}.
c) Set-I of the laboratory sample as prepared shall be analyzed by jointly analysed at the Third Party in the Seller’s laboratory at the loading end as per relevant part of IS: 1350 (Part –I) – 1984 and IS: 1350 (Part – II) – 1970 within three-four (3-4) days from the date of preparation and distribution of laboratory sample for analysis of ash,moisture and GCV.
d) In the event of any dispute (which shall be raised not later than forty-eight (48) hours after analysis) at on the time of Third Party joint analysis of Set-set - I, the referee stand-by sample as in Set- set - II shall be referred for analysis analysed jointly at the Seller’s Laboratory at the loading end within seventy two (72) hours of the dispute but not later than eight (8) days of the collection of samples at any mutually agreed Government laboratory. The cost incurred for the analysis of the Referee sample including cost of transportation to the Government Laboratory shall be borne total by the Party raising the disputesamples.
e) The procedure for storage of referee stand-by sample shall be mutually agreed upon by both the Parties.
Appears in 1 contract
Samples: Fuel Supply Agreement
Daily Gross. Sample
a) The Gross Sample collected as per clause 4.7.1(i5.7.1(i) for determination of moisture, ash & GCV on equilibrated basis shall be reduced into laboratory sample on the date immediately following the date of collection. The final laboratory samples will be divided into two parts viz. Set – I and Set – II, as follows; Set – I shall be used for third party analysis to determine the ash, moisture and GCV as per BIS standards IS 1350 Part-I, 1984 and IS 1350 Part-II-1970 respectively.. . Set – II shall be kept under joint seal of the Seller, Purchaser and the Third Party as referee sample in the safe custody of Third Party at the loading end for a period of fourteen (14) days or until the analysis results of Set – I are accepted without dispute, whichever is earlier.
b) The sample in Set -I shall be analysed for ash, moisture and GCV GCVcontent on equilibrated basis {wherever required in accordance with IS: 1350 (Part –I) – 1984 and IS: 1350 (Part – II) – 1970}.
c) Set-I of the laboratory sample as prepared shall be analyzed by the Third Party in the laboratory at the loading end as per relevant part of IS: 1350 (Part –I) – 1984 and IS: 1350 (Part – II) – 1970 within three-four (3-4) days from the date of preparation and distribution of laboratory sample for analysis of ash,moisture and GCV.
d) In the event of any dispute (which shall be raised not later than forty-eight (48) hours after analysis) at the time of Third Party analysis of Set-I, the referee sample as in Set- II shall be referred for analysis within seventy two (72) hours of the dispute but not later than eight (8) days of the collection of samples at any mutually agreed Government laboratory. The cost incurred for the analysis of the Referee sample including cost of transportation to the Government Laboratory shall be borne total by the Party raising the dispute
e) The procedure for storage of referee stand-by sample shall be mutually agreed upon by both the Parties.
Appears in 1 contract
Samples: Modified Model Fuel Supply Agreement
Daily Gross. Sample
a) The Gross Sample collected as per clause 4.7.1(i) from a rake and/or day’s supply for determination of moisture, ash & GCV on and GCVon equilibrated basis shall be jointly reduced into laboratory sample on the date immediately following the date of collection. The final laboratory samples will be divided into two parts viz. Set – I and Set – II, as follows; follows i Set – I shall be used for third party joint analysis to determine the ash, moisture and and GCV as per BIS standards IS 1350 Part-I, I ,1984 and IS 1350 Part-II-1970 II- 1970 respectively.. . • Set – II shall be kept under joint seal of the Seller, Purchaser and the Third Party as referee stand-by sample in the safe custody of Third Party at the loading end for a period of fourteen (14) days or until the analysis results of Set – I are accepted without dispute, whichever is earlier.
b) The sample in Set -I shall be analysed for ash, moisture and GCV on equilibrated basis {wherever required in accordance with IS: 1350 (Part –I) – 1984 and IS: 1350 (Part – II) – 1970}.
c) Set-I of the laboratory sample as prepared shall be analyzed by jointly analysed at the Third Party in the Seller’s laboratory at the loading end as per relevant part of IS: 1350 (Part –I) – 1984 and IS: 1350 (Part – II) – 1970 within three-four (3-4) days from the date of preparation and distribution of laboratory sample for analysis of ash,moisture and GCV.
d) In the event of any dispute (which shall be raised not later than forty-eight (48) hours after analysis) at on the time of Third Party joint analysis of Set-set - I, the referee stand-by sample as in Set- set - II shall be referred for analysis analysed jointly at the Seller’s Laboratory at the loading end within seventy two (72) hours of the dispute but not later than eight (8) days of the collection of samples at any mutually agreed Government laboratory. The cost incurred for the analysis of the Referee sample including cost of transportation to the Government Laboratory shall be borne total by the Party raising the disputesamples.
e) The procedure for storage of referee stand-by sample shall be mutually agreed upon by both the Parties.
Appears in 1 contract
Samples: Fuel Supply Agreement
Daily Gross. Sample
a) The Gross Sample collected as per clause 4.7.1(i) from a rake and/or day’s supply for determination of moisture, ash & GCV volatile matter on equilibrated basis shall be jointly reduced into laboratory sample on the date immediately following the date of collection. The final laboratory samples will be divided into two parts viz. Set – I and Set – II, as follows; Set – I shall be used for third party analysis to determine the ash, moisture and GCV as per BIS standards IS 1350 Part-I, 1984 and IS 1350 Part-II-1970 respectively.. follows • Set – II shall be kept under joint seal of the Seller, Purchaser and the Third Party as referee sample in the safe custody of Third Party at the loading end for a period of fourteen (14) days or until the analysis results of Set – I are accepted without dispute, whichever is earlier.
b) The sample in Set -I shall be analysed for ash, moisture and GCV volatile matter content on equilibrated basis {wherever required in accordance with IS: 1350 (Part –I) – 1984 and IS: 1350 (Part – II) – 1970}.
c) Set-I of the laboratory sample as prepared shall be analyzed by jointly analysed at the Third Party in the Seller’s laboratory at the loading end as per relevant part of IS: 1350 (Part –I) – 1984 and IS: 1350 (Part – II) – 1970 within three-four (3-4) days from the date of preparation and distribution of laboratory sample for analysis of moisture and GCVproximate analysis.
d) In the event of any dispute (which shall be raised not later than forty-eight (48) hours after analysis) at the time of Third Party analysis of Set-Ijoint analysis, the referee sample as in Set- II shall be referred for analysis within seventy two (72) hours of the dispute but not later than eight (8) days of the collection of samples at any mutually agreed Government laboratory. The cost incurred for the analysis of the Referee sample including cost of transportation to the Government Laboratory shall be borne total by the Party raising the dispute.
e) The procedure for storage of referee sample shall be mutually agreed upon by both the Parties.
Appears in 1 contract
Samples: Fuel Supply Agreement
Daily Gross. Sample
a) The Gross Sample collected as per clause 4.7.1(i) from a rake and/or day’s supply for determination of moisture, ash & GCV on and GCVon equilibrated basis shall be jointly reduced into laboratory sample on the date immediately following the date of collection. The final laboratory samples will be divided into two parts viz. Set – I and Set – II, as follows; follows Set – I shall be used for third party joint analysis to determine the ash, moisture and and GCV as per BIS standards IS 1350 Part-I, I ,1984 and IS 1350 Part-II-1970 II- 1970 respectively.. . Set – II shall be kept under joint seal of the Seller, Purchaser and the Third Party as referee stand-by sample in the safe custody of Third Party at the loading end for a period of fourteen (14) days or until the analysis results of Set – I are accepted without dispute, whichever is earlier.
b) The sample in Set -I shall be analysed for ash, moisture and GCV on equilibrated basis {wherever required in accordance with IS: 1350 (Part –I) – 1984 and IS: 1350 (Part – II) – 1970}.
c) Set-I of the laboratory sample as prepared shall be analyzed by jointly analysed at the Third Party in the Seller’s laboratory at the loading end as per relevant part of IS: 1350 (Part –I) – 1984 and IS: 1350 (Part – II) – 1970 within three-four (3-4) days from the date of preparation and distribution of laboratory sample for analysis of ash,moisture and GCV.
d) In the event of any dispute (which shall be raised not later than forty-eight (48) hours after analysis) at on the time of Third Party joint analysis of Set-set - I, the referee stand-by sample as in Set- set - II shall be referred for analysis analysed jointly at the Seller’s Laboratory at the loading end within seventy two (72) hours of the dispute but not later than eight (8) days of the collection of samples at any mutually agreed Government laboratory. The cost incurred for the analysis of the Referee sample including cost of transportation to the Government Laboratory shall be borne total by the Party raising the disputesamples.
e) The procedure for storage of referee stand-by sample shall be mutually agreed upon by both the Parties.
Appears in 1 contract
Samples: Fuel Supply Agreement