Dimensional Measurements Sample Clauses

Dimensional Measurements. The allowable deviation from the ordered thickness shall be ***. However, ***. The nominal ingot thickness shall be marked on the ingot (see specific requirements in Appendix B: Order Specifications) and the actual thickness shall not exceed the acceptable deviation from the thickness marked. When commissioning new molds, a thickness profile shall be completed and supplied to the Hot Mill Process Group or other designated technical contact at the purchasing plant and to the Novelis Molten Metal Processing (MMP) Group. Before ordering new molds that are different in either design or technology, ingot suppliers ***. However, it remains the responsibility of ingot suppliers to meet the thickness, width and convexity/concavity specifications.
AutoNDA by SimpleDocs
Dimensional Measurements. With this test, axial misalignment, angular deviation and length variations in welded assemblies are measured. For tubular specimens: • Coaxial alignment – before welding • Quantification of angular errors – after welding • Measurement of the diameter and roundness For sheet metal specimens: • Assure the flatness of the sheets after welding

Related to Dimensional Measurements

  • Measurement Should the State terminate this contract as herein provided, no fees other than fees due and payable at the time of termination shall thereafter be paid to the Engineer. In determining the value of the work performed by the Engineer prior to termination, the State shall be the sole judge. Compensation for work at termination will be based on a percentage of the work completed at that time. Should the State terminate this contract under paragraph (4) or (5) above, the Engineer shall not incur costs during the thirty-day notice period in excess of the amount incurred during the preceding thirty days.

  • Performance Measure The specific representation of a process or outcome that is relevant to the assessment of performance; it is quantifiable and can be documented

  • Performance Measures The System Agency will monitor the Grantee’s performance of the requirements in Attachment A and compliance with the Contract’s terms and conditions.

  • Measurement and Monitoring Tools Contractor shall implement measurement and monitoring tools and procedures reasonably designed to measure its performance of the Services and assess such performance against any applicable service levels. Contractor shall provide LAUSD with a monthly report of service level performance under any applicable Work Order. Upon LAUSD’s request, Contractor shall provide LAUSD with access to the measurement and monitoring tools described herein, and to any information that they generate.

  • Targets a) Seller’s supplier diversity spending target for Work supporting the construction of the Project prior to the Commercial Operation Date is ____ percent (___%) as measured relative to Seller’s total expenditures on construction of the Project prior to the Commercial Operation Date, and;

  • Components Patheon will purchase and test all Components (with the exception of Client-Supplied Components) at Patheon’s expense and as required by the Specifications.

  • Cost of Metering The Issuer shall not be obligated to pay any costs associated with the routine metering duties set forth in this Section 2, including the costs of installing, replacing and maintaining meters, nor shall the Issuer be entitled to any credit against the Servicing Fee for any cost savings realized by the Servicer as a result of new metering and/or billing technologies.

  • Acceptance Criteria 6.7.2.1. During the test there shall be no evidence of:

  • Performance Targets Threshold, target and maximum performance levels for each performance measure of the performance period are contained in Appendix B.

  • Performance Criteria The Performance Criteria are set forth in Exhibit A to this Agreement.

Time is Money Join Law Insider Premium to draft better contracts faster.