Unbundled Copper Loop – Non-Designed (UCL-ND 2.4.3.1 The UCL–ND is provisioned as a dedicated 2-wire metallic transmission facility from BellSouth’s Main Distribution Frame to a customer’s premises (including the NID). The UCL-ND will be a “dry copper” facility in that it will not have any intervening equipment such as load coils, repeaters, or digital access main lines (“DAMLs”), and may have up to 6,000 feet of bridged tap between the end user’s premises and the serving wire center. The UCL-ND typically will be 1300 Ohms resistance and in most cases will not exceed 18,000 feet in length, although the UCL-ND will not have a specific length limitation. For loops less than 18,000 feet and with less than 1300 Ohms resistance, the loop will provide a voice grade transmission channel suitable for loop start signaling and the transport of analog voice grade signals. The UCL-ND will not be designed and will not be provisioned with either a DLR or a test point. 2.4.3.2 The UCL-ND facilities may be mechanically assigned using BellSouth’s assignment systems. Therefore, the Loop Make Up process is not required to order and provision the UCL-ND. However, Lightyear can request Loop Make Up for which additional charges would apply. 2.4.3.3 At an additional charge, BellSouth also will make available Loop Testing so that Lightyear may request further testing on the UCL-ND. Rates for Loop Testing are as set forth in Exhibit B of this Attachment. 2.4.3.4 UCL-ND loops are not intended to support any particular service and may be utilized by Lightyear to provide a wide-range of telecommunications services so long as those services do not adversely affect BellSouth’s network. The UCL-ND will include a Network Interface Device (NID) at the customer’s location for the purpose of connecting the loop to the customer’s inside wire. 2.4.3.5 Order Coordination (OC) will be provided as a chargeable option and may be utilized when the UCL-ND provisioning is associated with the reuse of BellSouth facilities. Order Coordination -Time Specific (OC-TS) does not apply to this product. 2.4.3.6 Lightyear may use BellSouth’s Unbundled Loop Modification (ULM) offering to remove bridge tap and/or load coils from any loop within the BellSouth network. Therefore, some loops that would not qualify as UCL-ND could be transformed into loops that do qualify, using the ULM process.
International Olympic Committee; International Red Cross and Red Crescent Movement As instructed from time to time by ICANN, the names (including their IDN variants, where applicable) relating to the International Olympic Committee, International Red Cross and Red Crescent Movement listed at xxxx://xxx.xxxxx.xxx/en/resources/registries/reserved shall be withheld from registration or allocated to Registry Operator at the second level within the TLD. Additional International Olympic Committee, International Red Cross and Red Crescent Movement names (including their IDN variants) may be added to the list upon ten (10) calendar days notice from ICANN to Registry Operator. Such names may not be activated in the DNS, and may not be released for registration to any person or entity other than Registry Operator. Upon conclusion of Registry Operator’s designation as operator of the registry for the TLD, all such names withheld from registration or allocated to Registry Operator shall be transferred as specified by ICANN. Registry Operator may self-‐allocate and renew such names without use of an ICANN accredited registrar, which will not be considered Transactions for purposes of Section 6.1 of the Agreement.
Unbundled Copper Loop – Designed (UCL-D) 2.4.2.1 The UCL-D will be provisioned as a dry copper twisted pair (2- or 4-wire) Loop that is unencumbered by any intervening equipment (e.g., filters, load coils, range extenders, digital loop carrier, or repeaters). 2.4.2.2 A UCL-D will be 18,000 feet or less in length and is provisioned according to Resistance Design parameters, may have up to 6,000 feet of bridged tap and will have up to 1300 Ohms of resistance. 2.4.2.3 The UCL-D is a designed circuit, is provisioned with a test point, and comes standard with a DLR. OC is a chargeable option for a UCL-D; however, OC is always required on UCLs where a reuse of existing facilities has been requested by Telepak Networks. 2.4.2.4 These Loops are not intended to support any particular services and may be utilized by Telepak Networks to provide a wide-range of telecommunications services as long as those services do not adversely affect BellSouth’s network. This facility will include a Network Interface Device (NID) at the customer’s location for the purpose of connecting the Loop to the customer’s inside wire. 2.4.2.5 Upon the Effective Date of this Agreement, Unbundled Copper Loop – Long (UCL-L) elements will no longer be offered by BellSouth and no new orders for UCL-L will be accepted. Any existing UCL-Ls that were provisioned prior to the Effective Date of this Agreement will be grandfathered at the rates set forth in the Parties’ interconnection agreement that was in effect immediately prior to the Effective Date of this Agreement. Existing UCL-Ls that were provisioned prior to the Effective Date of this Agreement may remain connected, maintained and repaired according to BellSouth’s TR73600 and may remain connected until such time as they are disconnected by Telepak Networks or BellSouth provides ninety
Description of Vendor Entity and Vendor's Goods & Services If awarded, this description of Vendor and Vendor's goods and services will appear on the TIPS website for customer/public viewing. Technology solutions value-added reseller and installer of all things technology. Please identify the individual who will be primarily responsible for all TIPS matters and inquiries for the duration of the contract. Xxxx Xxxxxxx Primary Contact Title VP of Sales Please enter a valid email address that will definitely reach the Primary Contact. xxxx@xxxxxxxxxx.xxx Numbers only, no symbols or spaces (Ex. 8668398477). The system will auto-populate your entry with commas once submitted which is appropriate and expected (Ex. 8,668,398,477). Please provide the accurate and current phone number where the individual who will be primarily responsible for all TIPS matters and inquiries for the duration of the contract can be reached directly. 0000000000 Numbers only, no symbols or spaces (Ex. 8668398477). The system will auto-populate your entry with commas once submitted which is appropriate and expected (Ex. 8,668,398,477). 0000000000 Numbers only, no symbols or spaces (Ex. 8668398477). The system will auto-populate your entry with commas once submitted which is appropriate and expected (Ex. 8,668,398,477). 0000000000
LIABILITY OF FOREIGN SUB-CUSTODIANS AND FOREIGN SECURITIES SYSTEMS Each agreement pursuant to which the Custodian employs as a Foreign Sub-Custodian shall, to the extent possible, require the Foreign Sub-Custodian to exercise reasonable care in the performance of its duties and, to the extent possible, to indemnify, and hold harmless, the Custodian from and against any loss, damage, cost, expense, liability or claim arising out of or in connection with the Foreign Sub-Custodian’s performance of such obligations. At the Fund’s election, the Funds shall be entitled to be subrogated to the rights of the Custodian with respect to any claims against a Foreign Sub-Custodian as a consequence of any such loss, damage, cost, expense, liability or claim if and to the extent that the Funds have not been made whole for any such loss, damage, cost, expense, liability or claim.
Vendor Encouraging Members to bypass TIPS agreement Encouraging entities to purchase directly from the Vendor or through another agreement, when the Member has requested using the TIPS cooperative Agreement or price, and thereby bypassing the TIPS Agreement is a violation of the terms and conditions of this Agreement and will result in removal of the Vendor from the TIPS Program.
Preference for domestically manufactured goods The provisions of paragraphs 2.54 and 2.55 of the Guidelines and Appendix 2 thereto shall apply to goods manufactured in the territory of the Borrower.
Employee Data Privacy Pursuant to applicable personal data protection laws, the Company hereby notifies you of the following in relation to your personal data and the collection, use, processing and transfer (collectively, the “Use”) of such data in relation to the Company’s grant of the RSUs and your participation in the Plan. The Use of your personal data is necessary for the Company’s administration of the Plan and your participation in the Plan. Your denial and/or objection to the Use of personal data may affect your participation in the Plan. As such, you voluntarily acknowledge, consent and agree (where required by applicable law) to the Use of personal data as described in this Paragraph 8. The Company and the Employer hold certain personal information about you, which may include your name, home address and telephone number, date of birth, social security number or other employee identification number, salary, nationality, job title, any Shares held by you, details of all RSUs or any other entitlement to Shares awarded in your favor, for the purpose of managing and administering the Plan (“Data”). The Data may be provided by you or collected, where lawful, from the Company, Affiliates or third parties, and the Company or Employer will process the Data for the exclusive purpose of implementing, administering and managing your participation in the Plan. The data processing will take place through electronic and non-electronic means according to logics and procedures strictly correlated to the purposes for which Data are collected and with confidentiality and security provisions as set forth by applicable laws and regulations in your country of residence (and country of employment, if different). Data processing operations will be performed minimizing the use of personal and identification data when such data are unnecessary for the processing purposes sought. Data will be accessible within the Company’s organization only by those persons requiring access for purposes of the implementation, administration and operation of the Plan and for your participation in the Plan. The Company and the Employer will transfer Data amongst themselves as necessary for the purpose of implementation, administration and management of your participation in the Plan, and the Company and the Employer may each further transfer Data to any third parties assisting the Company in the implementation, administration and management of the Plan. These recipients may be located in the European Economic Area, or elsewhere throughout the world, such as the United States. You hereby authorize them to receive, possess, use, retain and transfer the Data, in electronic or other form, for purposes of implementing, administering and managing your participation in the Plan, including any requisite transfer of such Data as may be required for the administration of the Plan and/or the subsequent holding of Shares on your behalf to a broker or other third party with whom you may elect to deposit any Shares acquired pursuant to the Plan. You may, at any time, exercise your rights provided under applicable personal data protection laws, which may include the right to (a) obtain confirmation as to the existence of the Data, (b) verify the content, origin and accuracy of the Data, (c) request the integration, update, amendment, deletion, or blockage (for breach of applicable laws) of the Data, and (d) oppose, for legal reasons, the Use of the Data that is not necessary or required for the implementation, administration and/or operation of the Plan and your participation in the Plan. You may seek to exercise these rights by contacting your Employer’s human resources manager or Invesco, Ltd., Manager, Executive Compensation, 0000 Xxxxxxxxx Xxxxxx, XX, Xxxxxxx, Xxxxxxx 00000.
Distribution of UDP and TCP queries DNS probes will send UDP or TCP “DNS test” approximating the distribution of these queries.
Automatic Renewal Clauses Incorporated in Awarded Vendor Agreements with TIPS Members Resulting from the Solicitation and with the Vendor Named in this Agreement.
