Technical or Contractual Problems Contractor shall meet with the Department's personnel, or designated representatives, to resolve technical or contractual problems occurring during the contract term or to discuss the progress made by Contractor and the Department in the performance of their respective obligations, at no additional cost to the Department. The Department may request the meetings as problems arise and will be coordinated by the Department. The Department shall provide Contractor a minimum of three full working days notice of meeting date, time, and location. Face-to-face meetings are desired; however, at Contractor's option and expense, a conference call meeting may be substituted. Contractor’s consistent failure to participate in problem resolution meetings, Contractor missing or rescheduling two consecutive meetings, or Contractor’s failure to make a good faith effort to resolve problems may result in termination of the contract.
Commercial or Marketing Use Prohibition Contractor agrees that it will not sell PII or use or disclose PII for a Commercial or Marketing Purpose.
Consistent Treatment Unless and until there has been a Final Determination to the contrary, each Party agrees not to take any position on any Tax Return, in connection with any Tax Contest or otherwise that is inconsistent with (i) the treatment of payments between the Parent Group and the SpinCo Group as set forth in Section 5.4, (ii) the Tax Materials or (iii) the Intended Tax Treatment.
Xxx Treatment We have not promised you any particular tax outcome from buying or holding the Note.
National Treatment and Most-favoured-nation Treatment (1) Each Contracting Party shall accord to investments of investors of the other Contracting Party, treatment which shall not be less favourable than that accorded either to investments of its own or investments of investors of any third State. (2) In addition, each Contracting Party shall accord to investors of the other Contracting Party, including in respect of returns on their investments, treatment which shall not be less favourable than that accorded to investors of any third State. (3) The provisions of paragraphs (1) and (2) above shall not be construed so as to oblige one Contracting Party to extend to the investors of the other the benefit of any treatment, preference or privilege resulting from: (a) Any existing or future free trade area, customs unions, monetary union or similar international agreement or other forms of regional cooperation to which one of the Contracting Parties is or may become a party, or (b) Any matter pertaining wholly or mainly to taxation.
Product ACCEPTANCE Unless otherwise provided by mutual agreement of the Authorized User and the Contractor, Authorized User(s) shall have thirty (30) days from the date of delivery to accept hardware products and sixty (60) days from the date of delivery to accept all other Product. Where the Contractor is responsible for installation, acceptance shall be from completion of installation. Failure to provide notice of acceptance or rejection or a deficiency statement to the Contractor by the end of the period provided for under this clause constitutes acceptance by the Authorized User(s) as of the expiration of that period. The License Term shall be extended by the time periods allowed for trial use, testing and acceptance unless the Commissioner or Authorized User agrees to accept the Product at completion of trial use. Unless otherwise provided by mutual agreement of the Authorized User and the Contractor, Authorized User shall have the option to run testing on the Product prior to acceptance, such tests and data sets to be specified by User. Where using its own data or tests, Authorized User must have the tests or representative set of data available upon delivery. This demonstration will take the form of a documented installation test, capable of observation by the Authorized User, and shall be made part of the Contractor’s standard documentation. The test data shall remain accessible to the Authorized User after completion of the test. In the event that the documented installation test cannot be completed successfully within the specified acceptance period, and the Contractor or Product is responsible for the delay, Authorized User shall have the option to cancel the order in whole or in part, or to extend the testing period for an additional thirty (30) day increment. Authorized User shall notify Contractor of acceptance upon successful completion of the documented installation test. Such cancellation shall not give rise to any cause of action against the Authorized User for damages, loss of profits, expenses, or other remuneration of any kind. If the Authorized User elects to provide a deficiency statement specifying how the Product fails to meet the specifications within the testing period, Contractor shall have thirty (30) days to correct the deficiency, and the Authorized User shall have an additional sixty (60) days to evaluate the Product as provided herein. If the Product does not meet the specifications at the end of the extended testing period, Authorized User, upon prior written notice to Contractor, may then reject the Product and return all defective Product to Contractor, and Contractor shall refund any monies paid by the Authorized User to Contractor therefor. Costs and liabilities associated with a failure of the Product to perform in accordance with the functionality tests or product specifications during the acceptance period shall be borne fully by Contractor to the extent that said costs or liabilities shall not have been caused by negligent or willful acts or omissions of the Authorized User’s agents or employees. Said costs shall be limited to the amounts set forth in the Limitation of Liability Clause for any liability for costs incurred at the direction or recommendation of Contractor.
FDA As to each product subject to the jurisdiction of the U.S. Food and Drug Administration (“FDA”) under the Federal Food, Drug and Cosmetic Act, as amended, and the regulations thereunder (“FDCA”) that is manufactured, packaged, labeled, tested, distributed, sold, and/or marketed by the Company or any of its Subsidiaries (each such product, a “Pharmaceutical Product”), such Pharmaceutical Product is being manufactured, packaged, labeled, tested, distributed, sold and/or marketed by the Company in compliance with all applicable requirements under FDCA and similar laws, rules and regulations relating to registration, investigational use, premarket clearance, licensure, or application approval, good manufacturing practices, good laboratory practices, good clinical practices, product listing, quotas, labeling, advertising, record keeping and filing of reports, except where the failure to be in compliance would not have a Material Adverse Effect. There is no pending, completed or, to the Company's knowledge, threatened, action (including any lawsuit, arbitration, or legal or administrative or regulatory proceeding, charge, complaint, or investigation) against the Company or any of its Subsidiaries, and none of the Company or any of its Subsidiaries has received any notice, warning letter or other communication from the FDA or any other governmental entity, which (i) contests the premarket clearance, licensure, registration, or approval of, the uses of, the distribution of, the manufacturing or packaging of, the testing of, the sale of, or the labeling and promotion of any Pharmaceutical Product, (ii) withdraws its approval of, requests the recall, suspension, or seizure of, or withdraws or orders the withdrawal of advertising or sales promotional materials relating to, any Pharmaceutical Product, (iii) imposes a clinical hold on any clinical investigation by the Company or any of its Subsidiaries, (iv) enjoins production at any facility of the Company or any of its Subsidiaries, (v) enters or proposes to enter into a consent decree of permanent injunction with the Company or any of its Subsidiaries, or (vi) otherwise alleges any violation of any laws, rules or regulations by the Company or any of its Subsidiaries, and which, either individually or in the aggregate, would have a Material Adverse Effect. The properties, business and operations of the Company have been and are being conducted in all material respects in accordance with all applicable laws, rules and regulations of the FDA. The Company has not been informed by the FDA that the FDA will prohibit the marketing, sale, license or use in the United States of any product proposed to be developed, produced or marketed by the Company nor has the FDA expressed any concern as to approving or clearing for marketing any product being developed or proposed to be developed by the Company.
Capacity; Authority; Validity Allseas has all necessary capacity, power and authority to enter into this Agreement and to perform all the obligations to be performed by Allseas’ hereunder; this Agreement and the consummation by Allseas of the transactions contemplated hereby has been duly and validly authorized by all necessary action of Allseas; this Agreement has been duly executed and delivered by Allseas; and assuming the due execution and delivery of this Agreement by the Company, this Agreement constitutes the legal, valid and binding obligation of the Company enforceable against Allseas in accordance with its terms.
Regulatory Approval 25.1 The Parties understand and agree that this Agreement and any amendment or modification hereto will be filed with the Commission for approval in accordance with Section 252 of the Act and may thereafter be filed with the FCC. The Parties believe in good faith and agree that the services to be provided under this Agreement are in the public interest. Each Party covenants and agrees to fully support approval of this Agreement by the Commission or the FCC under Section 252 of the Act without modification.
Regulatory Limitation In the event, as a result of increases in the value of Alternative Currencies against the Dollar or for any other reason, the obligation of any of the Lenders to make Loans (taking into account the Dollar Amount of the Obligations and all other indebtedness required to be aggregated under 12 U.S.C.A. §84, as amended, the regulations promulgated thereunder and any other Applicable Law) is determined by such Lender to exceed its then applicable legal lending limit under 12 U.S.C.A. §84, as amended, and the regulations promulgated thereunder, or any other Applicable Law, the amount of additional Extensions of Credit such Lender shall be obligated to make or issue or participate in hereunder shall immediately be reduced to the maximum amount which such Lender may legally advance (as determined by such Lender), the obligation of each of the remaining Lenders hereunder shall be proportionately reduced, based on their applicable Commitment Percentages to the relevant Credit Facility and, to the extent necessary under such laws and regulations (as determined by each of the Lenders, with respect to the applicability of such laws and regulations to itself), and the Company shall reduce, or cause to be reduced, complying to the extent practicable with the remaining provisions hereof, the Obligations outstanding hereunder by an amount sufficient to comply with such maximum amounts.
