Quality Management Grantee will: 1. comply with quality management requirements as directed by the System Agency. 2. develop and implement a Quality Management Plan (QMP) that conforms with 25 TAC § 448.504 and make the QMP available to System Agency upon request. The QMP must be developed no later than the end of the first quarter of the Contract term. 3. update and revise the QMP each biennium or sooner, if necessary. Xxxxxxx’s governing body will review and approve the initial QMP, within the first quarter of the Contract term, and each updated and revised QMP thereafter. The QMP must describe Xxxxxxx’s methods to measure, assess, and improve - i. Implementation of evidence-based practices, programs and research-based approaches to service delivery; ii. Client/participant satisfaction with the services provided by Xxxxxxx; iii. Service capacity and access to services; iv. Client/participant continuum of care; and v. Accuracy of data reported to the state. 4. participate in continuous quality improvement (CQI) activities as defined and scheduled by the state including, but not limited to data verification, performing self-reviews; submitting self-review results and supporting documentation for the state’s desk reviews; and participating in the state’s onsite or desk reviews. 5. submit plan of improvement or corrective action plan and supporting documentation as requested by System Agency. 6. participate in and actively pursue CQI activities that support performance and outcomes improvement. 7. respond to consultation recommendations by System Agency, which may include, but are not limited to the following: i. Staff training; ii. Self-monitoring activities guided by System Agency, including use of quality management tools to self-identify compliance issues; and iii. Monitoring of performance reports in the System Agency electronic clinical management system.
Technical Cooperation In order to facilitate the implementation of this Agreement, developed country Members shall provide, on request and on mutually agreed terms and conditions, technical and financial cooperation in favour of developing and least-developed country Members. Such cooperation shall include assistance in the preparation of laws and regulations on the protection and enforcement of intellectual property rights as well as on the prevention of their abuse, and shall include support regarding the establishment or reinforcement of domestic offices and agencies relevant to these matters, including the training of personnel.
Manufacturing (a) The Supplier shall without limitation be responsible, at no additional cost to the Purchaser, for: sourcing and procuring all raw materials for the Products; obtaining all necessary approvals, permits and licenses for the manufacturing of the Products; providing sufficient qualified staff and workers to perform the obligations under this Purchase Agreement; implementing and maintaining effective inventory and production control procedures with respect to the Products; and handling other matters as reasonably requested by the Purchaser from time to time. (b) The Supplier shall not change any process, material, component, packaging or manufacturing location without the Purchaser’s express prior written approval.
Goods and Services Tax (GST (a) For the purposes of clause 9:
OCCUPATIONAL HEALTH & SAFETY (a) It is a mutual interest of the parties to promote health and safety in workplaces and to prevent and reduce the occurrence of workplace injuries and occupational diseases. The parties agree that health and safety is of the utmost importance and agree to promote health and safety and wellness throughout the organization. The employer shall provide orientation and training in health and safety to new and current employees on an ongoing basis, and employees shall attend required health and safety training sessions. Accordingly, the parties fully endorse the responsibilities of employer and employee under the Occupational Health and Safety Act, making particular reference to the following:
OCCUPATIONAL HEALTH AND SAFETY 34.01 The parties recognize the need for a safe and healthy workplace. The Employer shall be responsible for providing safe and healthy working conditions. The Employer and Employees will take all reasonable steps to eliminate, reduce or minimize all workplace safety hazards. Occupational health and safety education, training and instruction provided by the Employer, shall be paid at the Basic Rate of Pay, to fulfill the requirements for training, instruction or education set out in the Occupational Health and Safety Act, Regulation or Code. (a) There shall be an Occupational Health and Safety Committee (Committee), which shall be composed of representatives of the Employer and representatives of the Local and may include others representing recognized functional bargaining units. This Committee shall meet once a month, and in addition shall meet within 10 days of receiving a written complaint regarding occupational health or safety. An Employee shall be paid the Employee’s Basic Rate of Pay for attendance at Committee meetings. A request to establish separate committees for each site or grouping of sites shall not be unreasonably denied. The Employer shall provide training at no cost to all Employees on the Committee to assist them in performing their duties on the Committee. Training shall be paid at the Employee’s Basic Rate of Pay. (b) Minutes of each meeting shall be taken and shall be approved by the Employer, the Local, and other bargaining groups, referred to in (a), prior to circulation. (c) The purpose of the Committee is to consider such matters as occupational health and safety and the Local may make recommendations to the Employer in that regard. (d) If an issue arises regarding occupational health or safety, the Employee or the Local shall first seek to resolve the issue through discussion with the applicable immediate supervisor in an excluded management position. If the issue is not resolved satisfactorily, it may then be forwarded in writing to the Committee. (e) The Committee shall also consider measures necessary to ensure the security of each Employee on the Employer’s premises and the Local may make recommendations to the Employer in that regard. (f) (i) Should an issue not be resolved by the Committee, the issue shall be referred to the Chief Executive Officer (CEO). A resolution meeting between the Local and the CEO, or designate(s), shall take place within 21 calendar days of the issue being referred to the CEO. The CEO or designate(s) shall reply in writing to the Local within seven (7) calendar days of the resolution meeting.
Quality Management System Supplier hereby undertakes, warrants and confirms, and will ensue same for its subcontractors, to remain certified in accordance with ISO 9001 standard or equivalent. At any time during the term of this Agreement, the Supplier shall, if so instructed by ISR, provide evidence of such certifications. In any event, Supplier must notify ISR, in writing, in the event said certification is suspended and/or canceled and/or not continued.
Industrial cooperation Cooperation shall aim to promote the modernisation and restructuring of industry and individual sectors in Serbia. It shall also cover industrial cooperation between economic operators, with the objective of strengthening the private sector under conditions which ensure that the environment is protected. Industrial cooperation initiatives shall reflect the priorities determined by both Parties. They shall take into account the regional aspects of industrial development, promoting trans-national partnerships when relevant. The initiatives should seek in particular to establish a suitable framework for undertakings, to improve management, know-how and to promote markets, market transparency and the business environment. Special attention shall be devoted to the establishment of efficient export promotion activities in Serbia. Cooperation shall take due account of the Community acquis in the field of industrial policy.
Electrical appliance safety The Hirer shall ensure that any electrical appliances brought by them to the premises and used there shall be safe, in good working order, and used in a safe manner in accordance with the Electricity at Work Regulations 1989. Where a residual circuit breaker is provided the hirer must make use of it in the interests of public safety.
Procurement Planning Prior to the issuance of any invitations to bid for contracts, the proposed procurement plan for the Project shall be furnished to the Association for its review and approval, in accordance with the provisions of paragraph 1 of Appendix 1 to the Guidelines. Procurement of all goods and works shall be undertaken in accordance with such procurement plan as shall have been approved by the Association, and with the provisions of said paragraph 1.