Common use of Hot performance Clause in Contracts

Hot performance. Not later than 60 seconds after completion of the heating procedure the hot performance shall be measured under the conditions of speed and brake actuating pressure applied in the Type 0 test. 4.1.1. of this annex) or the mean brake torque based on the braking distance equivalent the mean fully developed deceleration, including the rolling resistance (see paragraph 3.4.1.1. of this annex) must not be less than 3.75 m/s2.

Hot performance. Not later than 60 seconds after completion of the heating procedure procedure, the hot performance shall be measured under at a rotational speed equivalent to 60 km/h using the conditions of speed and same brake actuating actuation pressure applied in that was used for the Type 0 test.test at 60 km/h. 4.1.1. of this annex) or the a mean brake torque based on the braking distance equivalent to the mean fully developed deceleration, including the rolling resistance (see paragraph 3.4.1.1. of this annex) must not be less than 3.75 60 per cent of the value achieved with the cold brake in the Type 0 test nor less than 4.0 m/s2.

Hot performance. Not later than 60 seconds after completion of the heating procedure procedure, the hot performance shall be measured under at a rotational speed equivalent to 60 km/h using the conditions of speed and same brake actuating actuation pressure applied in that was used for the Type 0 test.test at 60km/h. The mean fully developed deceleration, including the rolling resistance (see paragraph 4.1.13.4.1.1. of this annex) or the a mean brake torque based on the braking distance equivalent to the mean fully developed deceleration, including the rolling resistance (see paragraph paragraph 3.4.1.1. of this annex) must not be less than 3.75 60 per cent of the value achieved with the cold brake in the Type 0 test nor less than 4.0 m/s2.

Hot performance. Not later than 60 seconds after completion of the heating procedure procedure, the hot performance shall be measured under at a rotational speed equivalent to 60 km/h using the conditions of speed and same brake actuating actuation pressure applied in that was used for the Type 0 test.test at 60km/h. The mean fully developed deceleration, including the rolling resistance (see paragraph 4.1.13.4.1.1. of this annex) or the a mean brake torque based on the braking distance equivalent to the mean fully developed deceleration, including the rolling resistance (see paragraph 3.4.1.1. of this annex) must not be less than 3.75 60 per cent of the value achieved with the cold brake in the Type 0 test nor less than 4.0 m/s2.