Injection- and/or Off-take Points. 11.1. 1Allocation to the Balancing Perimeter
Injection- and/or Off-take Points
Injection- and/or Off-take Points Sample Clauses
Related to Injection- and/or Off-take Points
Trunk Group Connections and Ordering 5.2.1 For both One-Way and Two-Way Interconnection Trunks, if Onvoy wishes to use a technically feasible interface other than a DS1 or a DS3 facility at the POI, the Parties shall negotiate reasonable terms and conditions (including, without limitation, rates and implementation timeframes) for such arrangement; and, if the Parties cannot agree to such terms and conditions (including, without limitation, rates and implementation timeframes), either Party may utilize the Agreement’s dispute resolution procedures. 5.2.2 When One-Way or Two-Way Interconnection Trunks are provisioned using a DS3 interface facility, if Onvoy orders the multiplexed DS3 facilities to a Frontier Central Office that is not designated in the NECA 4 Tariff as the appropriate Intermediate Hub location (i.e., the Intermediate Hub location in the appropriate Tandem subtending area based on the LERG), and the provision of such facilities to the subject Central Office is technically feasible, the Parties shall negotiate in good faith reasonable terms and conditions (including, without limitation, rates and implementation timeframes) for such arrangement; and, if the Parties cannot agree to such terms and conditions (including, without limitation, rates and implementation timeframes), either Party may utilize the Agreement’s dispute resolution procedures. 5.2.3 Each Party will identify its Carrier Identification Code, a three or four digit numeric code obtained from Telcordia, to the other Party when ordering a trunk group. 5.2.4 For multi-frequency (MF) signaling each Party will out pulse ten (10) digits to the other Party, unless the Parties mutually agree otherwise. 5.2.5 Each Party will use commercially reasonable efforts to monitor trunk groups under its control and to augment those groups using generally accepted trunk- engineering standards so as to not exceed blocking objectives. Each Party agrees to use modular trunk-engineering techniques for trunks subject to this Attachment.
Interconnection Customer’s Interconnection Facilities The Interconnection Customer shall design, procure, construct, install, own and/or control the Interconnection Customer’s Interconnection Facilities described in Appendix A at its sole expense.
Location and Facilities The Executive will be furnished with the working facilities and staff customary for executive officers with the title and duties set forth in Section 1 and as are necessary for him to perform his duties. The location of such facilities and staff shall be at the principal administrative offices of the Company and the Bank, or at such other site or sites customary for such offices.
Interconnection Customer Provided Services The services provided by Interconnection Customer under this LGIA are set forth in Article 9.6 and Article 13.5. 1. Interconnection Customer shall be paid for such services in accordance with Article 11.6.
Underground Facilities All underground pipelines, conduits, ducts, cables, wires, manholes, vaults, tanks, tunnels, or other such facilities or attachments, and any encasements containing such facilities, including without limitation those that convey electricity, gases, steam, liquid petroleum products, telephone or other communications, cable television, water, wastewater, storm water, other liquids or chemicals, or traffic or other control systems.
The Properties Attached hereto as Schedule I is the description of certain Land (the "Subject Property"). Effective upon the execution and delivery of this Lease Supplement by Lessor and Lessee, such Land, together with any Building and other improvements thereon or which thereafter may be constructed thereon shall be subject to the terms and provisions of the Lease and Lessor hereby grants, conveys, transfers and assigns to the Related Lessee those interests, rights, titles, estates, powers and privileges provided for in the Lease with respect to the Subject Property.
BUYER'S FACILITIES 1. Buyer will maintain at its own expense facilities from the delivery point to the point of use and the burners and equipment for using gas, and Buyer will at all times keep gas-using equipment on said premises in a condition conforming with such reasonable rules and regulations as may be prescribed therefore by regulatory authority having jurisdiction thereover and with the requirements of any valid law thereto appertaining. In the event that rules are not prescribed by a regulatory authority, Buyer will abide by codes as used in the gas industry. 2. Seller shall not approve sale of gas on an interruptible basis to Buyer until and unless Seller is satisfied that Buyer has, or will, install adequate stand-by facilities to meet its full fuel requirements during periods of sustained interruptions. 3. Seller shall not approve sales of gas to Buyer unless Seller is satisfied that Buyer has not, or will not interconnect downstream fuel piping of natural gas for use in different priority-of• service categories.
POSSESSION AND OCCUPATION 3.1 The CONTRACTOR, its agents, servants and subcontractors shall at all times until the Works have been completed and the OWNER has signed and handed to the CONTRACTOR the final completion form, be entitled to enter and be present on the property for construction purposes. The CONTRACTOR shall further be entitled to enter into and be present on the property for purposes of completing minor works and snags listed on the snag list. 3.2 At no time whatsoever shall the OWNER be entitled to make claim, attach or in any way claim possession or retention of any of the CONTRACTOR's tools, equipment or building material and by signature hereof the OWNER waives all or any right which he may have acquired in this regard. 3.3 The OWNER shall be obliged to take occupation and possession of the Works at a date agreed upon between the parties but not later than 14 (fourteen) days after the handover date and it shall be incumbent on the OWNER to monitor progress of the Works in order to enable him to make whatever arrangements which may be necessary or required by him to: 3.3.1 take possession and occupation of the Works; 3.3.2 make payment of all or any amounts which may then still be due by him to the CONTRACTOR. 3.4 Should the OWNER fail to take occupation and possession of the Works as provided in clause 3.3 OR on such other date as may be agreed between the parties in writing – 3.4.1 it shall irrevocably be deemed for all purposes hereunder, that the OWNER has effectively and fully taken occupation and possession of the property and Works as set out in clause 3.3 and that all items on the snag list have been completed and accepted by the OWNER; 3.4.2 the CONTRACTOR shall not be responsible for any damages to the property after the deemed occupation date and the OWNER shall at his own cost provide security for the property against any vandalism and/or theft and/or any other damages thereto. 3.5 The CONTRACTOR shall, within 14 (fourteen) days from the commencement date as defined in clause 1.1.12, inform the OWNER of the estimated occupation date in writing. It is recorded that - 3.5.1 subject to the bond being registered and/or required proof regarding payment arrangements being submitted by the estimated building commencement date, the date on which the OWNER shall be able to occupy the property is estimated to be approximately 150 (one hundred and fifty) days after the commencement date, subject to the provisions of clause 5.6. 3.5.2 should the CONTRACTOR be unable to meet the estimated occupation date defined in clause 1.1.12 and referred to in clause 3.5.1, he shall be obliged to inform the OWNER in writing thereof at least 30 (thirty) days in advance.
Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.
Interconnection Customer (1) Interconnection Customer shall construct and, unless otherwise indicated, shall own, the following Interconnection Facilities: None (2) In the event that, in accordance with the Interconnection Construction Service Agreement, Interconnection Customer has exercised the Option to Build, it is hereby permitted to build in accordance with and subject to the conditions and limitations set forth in that Section, the following portions of the Transmission Owner Interconnection Facilities which constitute or are part of the Customer Facility: None Ownership of the facilities built by Interconnection Customer pursuant to the Option to Build shall be as provided in the Interconnection Construction Service Agreement.
