Installation of Equipment You represent that there are no legal, contractual or similar restrictions on the installation of the Equipment in the location(s) you have authorized. It is your responsibility to ensure compliance with all applicable building codes, zoning ordinances, homeowners’ association rules, covenants, conditions, and restrictions related to the Service, to pay any fees or other charges, and to obtain any permits or authorizations necessary for the installation or use of the Service (collectively "Legal Requirements"). You are solely responsible for any fines or similar charges for violation of any applicable Legal Requirements. You acknowledge and agree that Viasat or its designated service provider will be required to access your premises and computer to install and maintain the Equipment, including, without limitation, the antenna and its components. Standard Equipment installations performed by Viasat-authorized installers include: (i) installation of the antenna to an outside wall or sloped roof; (ii) travel to and from your Service location within 50 miles of the installer’s office; (iii) cable routed through one exterior wall and one interior wall or floor; (iv) connection of the antenna to the modem using up to 150 feet of cable; (v) connection of the modem to one computer using up to 7 feet of cable; and (vi) required mounting and cabling hardware. Any different or additional installation services or hardware are non-standard and may result in additional charges to be agreed upon between you and the installer. All installations include attaching the Equipment to your computer, installing software on your computer and configuring your computer to optimize the performance of the Internet Service. You confirm that you have reviewed the installation plan and agreed to any associated charges. If you approved a roof mount, you acknowledge the potential risks associated with this type of installation (including, without limitation, with respect to any warranty that applies to your roof or roof membrane). By signing this Agreement, scheduling a service or installation visit, and permitting us or our service provider to enter your home, you are authorizing Viasat and its service provider to perform all of the above actions. You are responsible for backing up the data on your computer and we highly recommend that you do so prior to permitting access to us or one of our designated service providers. NEITHER VIASAT NOR ITS SERVICE PROVIDER SHALL HAVE ANY LIABILITY WHATSOEVER FOR ANY LOSSES RESULTING FROM THE EQUIPMENT OR ANY INSTALLATION, REPAIR OR OTHER SERVICES ASSOCIATED WITH THE EQUIPMENT, INCLUDING WITHOUT LIMITATION, DAMAGE TO YOUR PREMISES OR LOSS OF SOFTWARE, DATA OR OTHER INFORMATION FROM YOUR COMPUTER. This limitation does not apply to any damages arising from the gross negligence or willful misconduct of us or one of our designated service providers. Time frames for installation, if any, are not guaranteed and may vary depending on the types of services requested and other factors.
Trade Fixtures The following trade fixtures are included: 233 The Trade Fixtures to be conveyed at closing must be conveyed by Seller, free and clear of all taxes (except personal property 234 taxes for the year of closing), liens and encumbrances, except . 235 Conveyance will be by bill of sale or other applicable legal instrument.
Furniture, Fixtures and Equipment Sublessee shall have the right to use during the Term the office furnishings and equipment within the Subleased Premises that are identified on Exhibit C attached hereto, as such exhibit may be adjusted by mutual agreement of the parties prior to the Third Floor Premises Delivery Date (the “Furniture”), provided Sublessee may only use the Furniture located in the Second Floor Premises after the Second Floor Commencement Date. The Furniture is provided in its “AS IS, WHERE IS” condition, without representation or warranty whatsoever. Sublessee shall insure the Furniture under the property insurance policy required under the Master Lease, as incorporated herein, and pay all taxes with respect to the Furniture. Sublessee shall maintain the Furniture in good condition and repair, reasonable wear and tear excepted, and shall be responsible for any loss or damage to the same occurring during the Term. Sublessee shall surrender the Furniture to Sublessor upon the termination of this Sublease in the same condition as exists as of the applicable Delivery Date, reasonable wear and tear excepted. Sublessee shall not remove any of the Furniture from the Subleased Premises. Notwithstanding anything to the contrary herein, Sublessee may provide Sublessor with written notice one (1) time not less than forty-five (45) days prior to the Third Floor Premises Delivery Date that lists any items of Furniture that Sublessee does not want to use and Sublessor shall, at no cost to Sublessee, remove such items from the Subleased Premises prior to the Third Floor Premises Delivery Date and such items shall no longer be considered Furniture hereunder. Notwithstanding the foregoing, provided Sublessee is not in default beyond the expiration of any applicable cure or grace period as of the date of the expiration or earlier termination of this Sublease, which condition may be waived by Sublessor in its sole discretion, then upon the expiration or earlier termination of this Sublease, the Furniture shall become the property of Sublessee, and Sublessee shall accept the same in its “AS IS, WHERE IS” condition, without representation or warranty whatsoever except as provided in the Bill of Sale referred to in the following sentence. In the event the Furniture is to become the property of Sublessee upon the expiration or earlier termination of this Sublease pursuant to the terms of the immediately preceding sentence, then Sublessor agrees to execute and deliver to Sublessee a Bill of Sale in the form of Exhibit D attached hereto conveying and transferring to Sublessee the Furniture.
Fixtures All Equipment now owned, or the ownership of which is hereafter acquired, by Borrower which is so related to the Land and Improvements forming part of the Property that it is deemed fixtures or real property under the law of the particular state in which the Equipment is located, including, without limitation, all building or construction materials intended for construction, reconstruction, alteration or repair of or installation on the Property, construction equipment, appliances, machinery, plant equipment, fittings, apparatuses, fixtures and other items now or hereafter attached to, installed in or used in connection with (temporarily or permanently) any of the Improvements or the Land, including, but not limited to, engines, devices for the operation of pumps, pipes, plumbing, cleaning, call and sprinkler systems, fire extinguishing apparatuses and equipment, heating, ventilating, plumbing, laundry, incinerating, electrical, air conditioning and air cooling equipment and systems, gas and electric machinery, appurtenances and equipment, pollution control equipment, security systems, disposals, dishwashers, refrigerators and ranges, recreational equipment and facilities of all kinds, and water, gas, electrical, storm and sanitary sewer facilities, utility lines and equipment (whether owned individually or jointly with others, and, if owned jointly, to the extent of Borrower's interest therein) and all other utilities whether or not situated in easements, all water tanks, water supply, water power sites, fuel stations, fuel tanks, fuel supply, and all other structures, together with all accessions, appurtenances, additions, replacements, betterments and substitutions for any of the foregoing and the proceeds thereof (collectively, the "FIXTURES"). Notwithstanding the foregoing, "Fixtures" shall not include any property which tenants are entitled to remove pursuant to leases except to the extent that Borrower shall have any right or interest therein;
LOCATION OF EQUIPMENT The Customer shall not remove the Equipment from the location shown herein as the place of use of the equipment, without prior written approval of the Company. The Customer shall inform the Company by email upon demand of the exact location of the Equipment while it is in the Customer’s possession.
Relocation of Equipment Lessee shall at all times keep the Equipment within its exclusive possession and control. Upon Lessor’s prior written consent, which shall not be unreasonably withheld, Lessee may move the Equipment to another location of Lessee within the continental United States, provided (i) Lessee is not in default on any Schedule,
Premises and equipment 6.1 If necessary, the Customer shall provide the Supplier with reasonable access at reasonable times to its premises for the purpose of supplying the Services. All equipment, tools and vehicles brought onto the Customer’s premises by the Supplier or the Staff shall be at the Supplier’s risk.
Fixtures and Alterations After taking occupancy of the Designated Space, AGENCY shall not, without the COUNTY’S prior written consent, attach any fixtures in or to the Designated Space or change, alter, or make additions to the Designated Space, nor attach or affix any article hereto, nor permit any annoying sound device, overload any floor, or deface the Designated Space. Such prior written consent shall not be unreasonably withheld. Where the COUNTY has approved AGENCY’S modifications to the Designated Space, the AGENCY shall only be required to remove its modifications and restore the Designated Space to its original condition upon the AGENCY’S vacating of the Designated Space should the COUNTY’S approval make such restoration a requirement of its approval. If, however, AGENCY elects to remove its modifications upon vacating the Designated Space, then AGENCY, at its expense, shall restore the Designated Space to its original condition, ordinary wear and tear excepted.
Operation of Equipment The Host shall not be required to operate machinery including but not limited to lawn mowers, weed-whackers and chain-saws.
Installations 2.1. This test shall be conducted with either the complete REESS or with a related REESS subsystem(s) including the cells and their electrical connections. If the manufacturer chooses to test with related subsystem(s), the manufacturer shall demonstrate that the test result can reasonably represent the performance of the complete REESS with respect to its safety performance under the same conditions. If the electronic management unit for the REESS is not integrated in the casing enclosing the cells, then the electronic management unit may be omitted from installation on the Tested-Device if so requested by the manufacturer.
