Access Toll Connecting Trunk Group Architecture 9.2.1 If CSTC chooses to subtend a Verizon access Tandem, CSTC’s NPA/NXX must be assigned by CSTC to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG.
9.2.2 CSTC shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from CSTC’s Customers.
9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office CSTC utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA.
9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow CSTC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.
Programming Processor is not responsible for programming or reprogramming of fuel dispensers.
Programming Phase Schematic Design Phase: 2.2.1.3. Design Development Phase:
Unbundled Network Element Combinations 5.1. Unbundled Network Element Combinations shall include: 1) Enhanced Extended Links (EELs); 2) UNE Loops/Special Access Combinations; 3) Loop/Port Combinations; and 4)
Television Equipment Recycling Program If this Contract is for the purchase or lease of covered television equipment, then Contractor certifies that it is compliance with Subchapter Z, Chapter 361 of the Texas Health and Safety Code related to the Television Equipment Recycling Program.
Two-Way Interconnection Trunks 2.4.1 Where the Parties have agreed to use Two-Way Interconnection Trunks for the exchange of traffic between Verizon and PCS, PCS shall order from Verizon, and Verizon shall provide, the Two-Way Interconnection Trunks and the Entrance Facility, on which such Trunks will ride, and transport and multiplexing, in accordance with the rates, terms and conditions set forth in this Agreement and Verizon’s applicable Tariffs.
2.4.2 Prior to ordering any Two-Way Interconnection Trunks from Verizon, PCS shall meet with Verizon to conduct a joint planning meeting (“Joint Planning Meeting”). At that Joint Planning Meeting, each Party shall provide to the other Party originating Centium Call Second (Hundred Call Second) information, and the Parties shall mutually agree on the appropriate initial number of Two-Way End Office and Tandem Interconnection Trunks and the interface specifications at the Point of Interconnection (POI). Where the Parties have agreed to convert existing One-Way Interconnection Trunks to Two-Way Interconnection Trunks, at the Joint Planning Meeting, the Parties shall also mutually agree on the conversion process and project intervals for conversion of such One-Way Interconnection Trunks to Two-Way Interconnection Trunks.
2.4.3 Two-Way Interconnection Trunks shall be from a Verizon End Office or Tandem to a mutually agreed upon POI.
2.4.4 On a semi-annual basis, PCS shall submit a good faith forecast to Verizon of the number of End Office and Tandem Two-Way Interconnection Trunks that PCS anticipates Verizon will need to provide during the ensuing two (2) year period to carry traffic from PCS to Verizon and from Verizon to PCS. PCS’s trunk forecasts shall conform to the Verizon CLEC trunk forecasting guidelines as in effect at that time.
2.4.5 The Parties shall meet (telephonically or in person) from time to time, as needed, to review data on End Office and Tandem Two-Way Interconnection Trunks to determine the need for new trunk groups and to plan any necessary changes in the number of Two-Way Interconnection Trunks.
2.4.6 Two-Way Interconnection Trunks shall have SS7 Common Channel Signaling. The Parties agree to utilize B8ZS and Extended Super Frame (ESF) DS1 facilities, where available.
2.4.7 With respect to End Office Two-Way Interconnection Trunks, both Parties shall use an economic Centium Call Second (Hundred Call Second) equal to five (5).
2.4.8 Two-Way Interconnection Trunk groups that connect to a Verizon access Tandem shall be engineered using a design blocking objective of Xxxx-Xxxxxxxxx B.005 during the average time consistent busy hour. Two-Way Interconnection Trunk groups that connect to a Verizon local Tandem shall be engineered using a design blocking objective of Xxxx-Xxxxxxxxx B.01 during the average time consistent busy hour. Verizon and PCS shall engineer Two-Way Interconnection Trunks using BOC Notes on the LEC Networks SR-TSV-002275.
2.4.9 The performance standard for final Two-Way Interconnection Trunk groups shall be that no such Interconnection Trunk group will exceed its design blocking objective (B.005 or B.01, as applicable) for three
Video This restriction includes, but is not limited to, use of the Beat and/or New Song in television, commercials, film/movies, theatrical works, video games, and in any other form on the Internet which is not expressly permitted herein.
Network Interface Device 4.1 The NID is defined as any means of interconnection of end-user customer premises wiring to BellSouth’s distribution plant, such as a cross-connect device used for that purpose. The NID is a single-line termination device or that portion of a multiple-line termination device required to terminate a single line or circuit at the premises. The NID features two independent xxxxxxxx or divisions that separate the service provider’s network from the End User’s on-premises wiring. Each chamber or division contains the appropriate connection points or posts to which the service provider and the End User each make their connections. The NID provides a protective ground connection and is capable of terminating cables such as twisted pair cable.
4.1.1 BellSouth shall permit Al-Call to connect Al-Call ’s loop facilities to on-premises wiring through the BellSouth NID or at any other technically feasible point.
Games The Private Party shall not be entitled to introduce any arcade type amusement or gaming machines into the Restaurant Facility without the prior written approval of SANParks.
User Generated Content 10.1 As a user to this website, You may be allowed to post any User Generated Content (“User Content”) and You agree, by submitting your contribution, you xxxxx XX Group a perpetual, royalty-free, non-exclusive, sublicensable right and license to use, reproduce, edit, modify, adapt, publish, translate, create derivate works from, distribute, perform, play, make available to the public, and exercise all copyright and publicity rights with respect to your contribution worldwide and/or to incorporate your contribution in other works in any media, now known or later developed, for the full terms of any rights that may exist in your contribution.
10.2 You also hereby grant other user of TM Website a non-exclusive license to access your User Content through the access and/or use of TM Website, and to use such User Content only as permitted through the functionality of TM Website.
10.3 You understand and agree that TM may retain and store, but not display, distribute, or perform, server copies of User Content that has been removed or deleted. The above licenses granted to TM, by You in User Content is irrevocable.
10.4 Further to the foregoing paragraph, by submitting your User Content to us, You warrant that:-
(a) your User Content is your own original work or have the necessary license, rights, consents, and permissions to use and authorize us to use all patent, trademark, trade secret, copyright or other proprietary rights in and to any and all User Content to enable TM to use of the User Content in the manner required by us and that you have the right to make it available to us for all the purposes specified above;
(b) your User Content is not defamatory, threatening, injurious, insulting character, offensive, abusive, offensive on moral, menacing, religious or political grounds, impair your confidentiality obligations;
(c) your User Content does not infringe the law;
(d) You shall be solely responsible for your own User Content and the consequences of posting or publishing them;
(e) You will not submit material that is copyrighted, protected by trade secret or otherwise subject to third party proprietary rights, including privacy and publicity rights, unless you are the owner of such rights or have permission from their rightful owner to post material and to grant us all of the license rights granted herein; and/or
(f) waive any moral rights in your User Content for the purposes of its submission to and publication in TM Website and the purposes specified above.
10.5 You understand that whether or not such User Content is posted, TM does not guarantee any confidentiality with respect to any User Content. TM does not endorse any User Content or any opinion, recommendation, or advice expressed therein, and expressly disclaims any and all liability in connection with User Content. We do not permit activities which will infringe any Intellectual Property Rights including copyright and we will remove all infringing contents and User Content upon notification that such Content or User Content infringes on another’s Intellectual Property Rights. We further reserve the right to remove any Content or User Content without prior notice.
10.6 You understand and agree that we may review and delete any User Content that you posted at any time without notice, without liability and for any reason whatsoever, especially if you breach the terms and conditions herein.
10.7 We reserve the right to investigate and take appropriate legal action, in our sole discretion, against You for the User Content especially if it violates TM policy and report you to the Appropriate Authority.
