Maximum Impervious Surface Ratio Sample Clauses

Maximum Impervious Surface Ratio. (“ISR”) – The maximum ISR for the Project shall be 0.70.
AutoNDA by SimpleDocs

Related to Maximum Impervious Surface Ratio

  • Maximum Senior Leverage Ratio Permit the Senior Leverage Ratio on the last day of any fiscal quarter during any period set forth below to be greater than the ratio set forth opposite such date or period below: Period Ratio ------ ----- September 30, 2001 2.50:1.0 December 31, 2001 2.00:1.0 March 31, 2002 through June 30, 2002 2.50:1.0 September 30, 2002 2.00:1.0 December 31, 2002 1.50:1.0 March 31, 2003 through June 30, 2003 2.00:1.0 September 30, 2003 1.50:1.0 December 31, 2003 and thereafter 1.25:1.0

  • Maximum Total Leverage Ratio The Borrower shall maintain, on the last day of each fiscal quarter set forth below, a Total Leverage Ratio of not more than the maximum ratio set forth below opposite such fiscal quarter: October 31, 2007, January 31, 2008, April 30, 2008, July 31, 2008, October 31, 2008 and January 31, 2009 4.7 to 1 April 30, 2009, July 31, 2009, October 31, 2009 and January 31, 2010 4.2 to 1 April 30, 2010 and each fiscal quarter thereafter 4.0 to 1

  • Intent to Limit Charges to Maximum Lawful Rate In no event shall the interest rate or rates payable under this Agreement, plus any other amounts paid in connection herewith, exceed the highest rate permissible under any law that a court of competent jurisdiction shall, in a final determination, deem applicable. Borrower and the Lender Group, in executing and delivering this Agreement, intend legally to agree upon the rate or rates of interest and manner of payment stated within it; provided, however, that, anything contained herein to the contrary notwithstanding, if said rate or rates of interest or manner of payment exceeds the maximum allowable under applicable law, then, ipso facto, as of the date of this Agreement, Borrower is and shall be liable only for the payment of such maximum as allowed by law, and payment received from Borrower in excess of such legal maximum, whenever received, shall be applied to reduce the principal balance of the Obligations to the extent of such excess.

  • Maximum Leverage Ratio The Borrower will not permit the Leverage Ratio as of the end of any fiscal quarter to be greater than 0.55 to 1.00.

  • Maximum Leverage Permit, as of any fiscal quarter end, the ratio of (a) Adjusted Portfolio Equity as of such fiscal quarter end to (b) Funded Debt as of such fiscal quarter end, to be less than 5.00 to 1.00.

  • Underground Tanks If underground or other storage tanks storing Hazardous Materials located on the Premises or the Project are used by Tenant or are hereafter placed on the Premises or the Project by Tenant, Tenant shall install, use, monitor, operate, maintain, upgrade and manage such storage tanks, maintain appropriate records, obtain and maintain appropriate insurance, implement reporting procedures, properly close any underground storage tanks, and take or cause to be taken all other actions necessary or required under applicable state and federal Legal Requirements, as such now exists or may hereafter be adopted or amended in connection with the installation, use, maintenance, management, operation, upgrading and closure of such storage tanks.

  • Minimum Interest Coverage Ratio The Borrowers shall not permit the Interest Coverage Ratio, calculated as of the end of each fiscal quarter for the four fiscal quarters then ended, to be less than 3.50 to 1.00.

  • Clean-Up Period (a) Notwithstanding anything to the contrary set forth herein or in any other Loan Document, during the Clean-Up Period, the occurrence of any breach of a representation, covenant or an Event of Default (other than an Event of Default set out in Section 9.1(a)) will be deemed not to be a breach of a representation or warranty or a breach of a covenant or an Event of Default, as the case may be, if it would have been (if it were not for this provision) a breach of representation or warranty or a breach of a covenant or an Event of Default only by reason of circumstances relating exclusively to, with respect to any Permitted Acquisition or other Permitted Clean-Up Investment (or the subsidiaries of such target), the target of such Permitted Acquisition or Permitted Clean-Up Investment, and provided that such breach or Event of Default: (i) is capable of being remedied within the Clean-Up Period and the Loan Parties are taking appropriate steps to remedy such breach or Event of Default; (ii) does not have and is not reasonably likely to have a Material Adverse Effect; and (iii) was not procured by or approved by Holdings or the Borrowers. (b) Notwithstanding Section 9.6(a), if the relevant circumstances are continuing on or after the expiry of the Clean-Up Period, there shall be a breach of representation or warranty, breach of covenant or Event of Default, as the case may be, notwithstanding the above (and without prejudice to the rights and remedies of the Agents and the Lenders). (c) For the avoidance of doubt, if any breach of representation or warranty, breach of covenant or Event of Default shall be deemed to not exist due to Section 9.6(a) during the Clean-Up Period, then such breach of representation or warranty, breach of covenant or Event of Default shall be deemed not to exist for purposes of Section 5.2 for so long as (but in no event later than the end of the Clean-Up Period) such breach of representation or warranty, breach of covenant or Event of Default shall be deemed not to exist due to the provisions of Section 9.6(a).

  • Maximum Consolidated Leverage Ratio The Consolidated Leverage Ratio at any time may not exceed 0.75 to 1.00; and

  • Minimum Consolidated Fixed Charge Coverage Ratio The Consolidated Fixed Charge Coverage Ratio shall not be less than 1.50 to 1.00, determined based on information for the most recent fiscal quarter annualized.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!