Voice Grade Unbundled Copper Sub-Loop Unbundled Sub-Loop Distribution – Intrabuilding Network Cable (aka riser cable)
Power Factor Design Criteria (Reactive Power A wind generating plant shall maintain a power factor within the range of 0.95 leading to 0.95 lagging, measured at the Point of Interconnection as defined in this LGIA, if the ISO’s System Reliability Impact Study shows that such a requirement is necessary to ensure safety or reliability. The power factor range standards can be met using, for example without limitation, power electronics designed to supply this level of reactive capability (taking into account any limitations due to voltage level, real power output, etc.) or fixed and switched capacitors if agreed to by the Connecting Transmission Owner for the Transmission District to which the wind generating plant will be interconnected, or a combination of the two. The Developer shall not disable power factor equipment while the wind plant is in operation. Wind plants shall also be able to provide sufficient dynamic voltage support in lieu of the power system stabilizer and automatic voltage regulation at the generator excitation system if the System Reliability Impact Study shows this to be required for system safety or reliability.
Reactive Power and Primary Frequency Response 9.6.1 Power Factor Design Criteria
Non-Synchronous Generation The Interconnection Customer shall design its Small Generating Facility to maintain a composite power delivery at continuous rated power output at the high-side of the generator substation at a power factor within the range of 0.95 leading to 0.95 lagging, unless the NYISO or the Transmission Owner in whose Transmission District the Small Generating Facility interconnects has established a different power factor range that applies to all similarly situated non-synchronous generators in the control area or Transmission District (as applicable) on a comparable basis, in accordance with Good Utility Practice. This power factor range standard shall be dynamic and can be met using, for example, power electronics designed to supply this level of reactive capability (taking into account any limitations due to voltage level, real power output, etc.) or fixed and switched capacitors, or a combination of the two. This requirement shall only apply to newly interconnecting non-synchronous generators that have not yet executed a Facilities Study Agreement as of September 21, 2016.
Operation of Properties The Borrower will and will cause each Subsidiary to operate its Properties or cause such Properties to be operated in a careful and efficient manner in accordance with the practices of the industry and in compliance with all applicable contracts and agreements and in compliance in all material respects with all Governmental Requirements.
Minimum Site Requirements for TIPS Sales (when applicable to TIPS Sale). Cleanup: When performing work on site at a TIPS Member’s property, Vendor shall clean up and remove all debris and rubbish resulting from their work as required or directed by the TIPS Member or as agreed by the parties. Upon completion of work, the premises shall be left in good repair and an orderly, neat, clean and unobstructed condition. Preparation: Vendor shall not begin a project for which a TIPS Member has not prepared the site, unless Vendor does the preparation work at no cost, or until TIPS Member includes the cost of site preparation in the TIPS Sale Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre‐installation requirements. Registered Sex Offender Restrictions: For work to be performed at schools, Vendor agrees that no employee of Vendor or a subcontractor who has been adjudicated to be a registered sex offender will perform work at any time when students are, or reasonably expected to be, present unless otherwise agreed by the TIPS Member. Vendor agrees that a violation of this condition shall be considered a material breach and may result in the cancellation of the TIPS Sale at the TIPS Member’s discretion. Vendor must identify any additional costs associated with compliance of this term. If no costs are specified, compliance with this term will be provided at no additional charge. Safety Measures: Vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage. Smoking: Persons working under Agreement shall adhere to the TIPS Member’s or local smoking statutes, codes, ordinances, and policies.
Condition of Properties All facilities, machinery, equipment, fixtures and other properties owned, leased or used by the Company are in reasonably good operating condition and repair, subject to ordinary wear and tear, and are adequate and sufficient for the Company’s business.
Cloud Computing State Risk and Authorization Management Program In accordance with Senate Bill 475, Acts 2021, 87th Leg., R.S., pursuant to Texas Government Code, Section 2054.0593, Contractor acknowledges and agrees that, if providing cloud computing services for System Agency, Contractor must comply with the requirements of the state risk and authorization management program and that System Agency may not enter or renew a contract with Contractor to purchase cloud computing services for the agency that are subject to the state risk and authorization management program unless Contractor demonstrates compliance with program requirements. If providing cloud computing services for System Agency that are subject to the state risk and authorization management program, Contractor certifies it will maintain program compliance and certification throughout the term of the Contract.
Minimum Shipping Requirements for TIPS Sales Vendor shall ship, deliver, or provide ordered goods and services within a commercially reasonable time after acceptance of the order. If a delay in delivery is anticipated, Vendor shall notify the TIPS Member as to why delivery is delayed and provide an updated estimated time for completion. The TIPS Member may cancel the order if the delay is not commercially acceptable or not consistent with the Supplemental Agreement applicable to the order.
PARTICULARS OF PROPERTY MASTER TITLE NO. AND LOT PT NO. : Master Title No. H.S.(M) 18672, Parent Lot No. PT 31376 SECTION/TOWN/DISTRICT/STATE : Mukim of Batu, District of Gambak, Selangor Darul Ehsan APPROXIMATE FLOOR AREA : 486.53 sq. feet. (45.20 sq. metres.) TENURE : Leasehold DEVELOPER / REGISTERED PROPRIETOR : Xxxx Xxxx Properties Berhad ENCUMBRANCE : Assigned to MALAYSIA BUILDING SOCIETY BERHAD The subject property is a Two (2) Bedroom Low Cost Flat identified as Parcel No. G-1-15, Storey No. 1, Building No. G Bandar Baru Selayangandbearing postal address at No. G-000, Xxxx X, Apartment Xxxxx, Xxxxx 0/0, Xxxxxx Xxxx Xxxxxxxx, 00000 Xxxx Xxxxx, Xxxxxxxx. The property will be sold on an “as is where is” basis and subject to a reserve price of RM 60,000.00 (RINGGIT MALAYSIA SIXTY THOUSAND ONLY), subject to the Conditions of Sale as printed in the Proclamation of Sale by way of an Assignment from the above Assignee/Lender subject to necessary confirmations/consent being obtained by the successful bidder (“the Purchaser”) from the Developer and/or other relevant authorities. Any arrears of quit rent, assessment, taxes, rates, maintenance charges and all other outgoing charges which are lawfully and rightfully due and payable to the Developer and/or other relevant authorities up to the date of the auction sale shall be paid out of the purchase money. All intending bidders are required to deposit with the Auctioneer 10% of the fixed reserve price for the said property by BANK DRAFT or CASHIER’S ORDERonly in favour of MALAYSIA BUILDING SOCIETY BERHADbefore the commencement of the auctionprior to the auction sale and pay the difference between the initial deposit and the sum equivalent to 10% of the successful bid price either in cash or bay way of credit card (Master / Visa) or bank draft or cashier’s orderand the balance of the purchase price (90%) shall be paid within one hundred and twenty (120) days from the date of the auction sale. For further particulars, please contact Messrs. Xxxx Xxxxxx & AssociatesSolicitors for the Assignee/Lender at Unit No. B-11-12, Blk B, 11th Floor, Xxxx 00, Xxxxx Xxxxxx XX, Xx. 00, Xxxxx Xxx Xxxx Xxxx, 50450 Kuala Lumpur.. Tel: 03-27155119Fax: 03-27157119 (Ref: Penang Office (Main): Xx. 000, Xxxxx Xxxxxx Xxxxxx, 00000 Xxxxxx. KL Office: No. B-3A-0, Xxxxx Xxxxxx XX, Xxxxx Xxx Xxxx Xxxx, 50450 Kuala Lumpur. Tel. No.: (PG): 00-000 0000, (KL) 00-0000 0000, H/P: 000-000 0000 / 000-000 0000 Fax No.: (PG): 00-000 0000 / (KL): 00-0000 0000 Email: xxxxx@xxx.xxx.xx Ref. No.: MNP/MBSB/KL/APR15/4 Licensed Auctioneer Menurut kuasa xxx xxx xxxx telah diberikan kepada Pihak Pemegang Xxxxx Xxx/Pemberi Pinjaman di bawah Perjanjian Pinjaman, Suratikatan Penyerahhakkan Xxx Surat Kuasa Wakil Kesemuanya Bertarikh 6hb Ogos 2001di antara Pihak Pemegang Xxxxx Xxx/Pemberi Pinjaman xxx Pihak-Pihak Penyerah Hak/Peminjam xxx berkenaan dengan Perjanjian Jual Beli di antara (“Penjual”) xxx Pihak-Pihak Penyerahhak/Peminjam yang bertarikh19hb Mei 1995adalah dengan ini diisytiharkan bahawa Pihak Pemegang Xxxxx Xxx/Pemberi Pinjaman tersebut dengan bantuan Pelelong yang tersebut di bawah NOTA:-Xxxxx-xxxxx pembeli adalah dinasihatkan agar:- (i) meminta nasihat bebas daripada Pihak Xxxxxx mengenai Syarat-Syarat Jualan di sini (ii) memeriksa hartanah tersebut (iii) membuat pertanyaan sekiranya hakmilik individu xxx hakmilik strata telah dikeluarkan (iv) membuat carian hakmilik secara rasmi di Pejabat Tanah xxx/atau Pihak Berkuasa yang lain (v) membuat pertanyaan yang diperlukan dengan pihak Pemaju xxx/atau Pemilik xxx/atau Pihak Berkuasa Negeri, xxx/atau badan-badan yang berkenaan mengenai pengesahan-pengesahan / terma-terma kebenaran yang diperlukan untuk jualan sebelum jualan lelong (Vi) membuat xxx bergantung pada carian sendiri, pertanyaan, penyiasatan xxx penentusahan mengenai ketepatan xxx kebenaran butir-butir xxx maklumat yang dikemukakan. Xxxxx-Xxxxx pembeli adalah dinasihatkan bahawa pergantungan tidak boleh dibuat pada kenyataan- kenyataan atau representasi-representasi yang dibuat pada Perisytiharan Jualan ini atau oleh Pelelong pada masa lelongan berkenaan dengan hartanah yang diperihalkan xxx mana-mana bakal pembeli yang memilih untuk bergantung pada kenyataan-kenyataan atau representasi-representasi tersebut berbuat demikian atas risiko sendiri. Penawar yang 2erjaya (”Pembeli”) sebaik sahaja selepas jualan mengaku janji untuk memohon xxx mendapatkan pengesahan/kebenaran yang diperlukan untuk pindahmilik atau xxxxx xxx (jika ada) daripada Pemaju xxx/atau Pemilik xxx/atau Pihak Berkuasa Negeri xxx/atau badan-badan yang berkenaan. NO. HAKMILIK XXXXXXX XXX NO. LOT : Master Title No. H.S.(M) 18672, Parent Lot No. PT 31376 SEKSYEN/BANDAR/DAERAH/NEGERI : Mukim Batu, Daerah Gombak, Selangor Darul Ehsan KELUASAN LANTAI : 486.53 kaki persegi (45.20 meter persegi) PEGANGAN Pajakan PEMAJU/PEMILIK BERDAFTAR : Shah Alam Properties Berhad BEBANAN : Diserahhak kepada MALAYSIA BUILDING SOCIETY BERHAD Harta tersebut adalah sebuah Rumah Pangsa Kos Rendah Dua (2) Bilik yang dikenali sebagaiPetak No. G-1-15, Tingkat No. 1, Bangunan No. G Bandar Baru Selayangdan beralamat No. G-000, Xxxx X, Apartment Xxxxx, Xxxxx 0/0, Xxxxxx Xxxx Xxxxxxxx, 00000 Xxxx Xxxxx, Xxxxxxxx.
