Common use of Metering and Communications Systems Clause in Contracts

Metering and Communications Systems. To the extent applicable as set forth in Appendix VIII, Seller shall install all metering, communications systems, and equipment for the Project (“Communications Systems”) at Seller’s sole cost and expense that is necessary to, at all times during the Delivery Term, (a) enable Seller to meet Buyer’s instructions in accordance with Section 4.7, (b) enable Buyer to remotely monitor the status of the Project on an aggregate and individual resource basis, (c) permit Buyer to have real time information access to the operations of the Project, including the ability to measure increases and decreases in real time load, and (d) provide Distribution Services during the Delivery Term. All electric metering equipment and submeters, whether owned by Seller or by a third party, which are installed on Seller’s side of the Delivery Point, as applicable, shall be operated, maintained and tested by and/or on behalf of Seller in accordance with Prudent Electrical Practices; provided that if the electric metering equipment test is conducted by the interconnecting utility or the Transmission Provider, testing shall be conducted in accordance with the procedures and the standards generally applied by such utility or the Transmission Provider, as applicable. In the event that, during the Delivery Term, Buyer develops its own system that allows Buyer to exercise greater monitoring or more efficient dispatch of the Project, upon Buyer’s notice Seller shall take reasonable actions to enable its Communications Systems to interface with Buyer’s system such that Buyer may monitor and dispatch the Project through Buyer’s system.

Metering and Communications Systems. To the extent applicable as set forth in Appendix VIIIX, Seller shall install all metering, communications systems, systems and equipment for the Project (“Communications Systems”) at Seller’s sole cost and expense that is necessary to, at all times during the Delivery Term, (ai) enable Seller to meet Buyer’s instructions in accordance with Section 4.74.8, (bii) enable Buyer to remotely dispatch (e.g. immediately disconnect for safety and reliability) and monitor the status of the Project on an aggregate and individual resource basis, (ciii) permit Buyer to have real time information access to the operations of the Project, including the ability to measure increases and decreases in real time load/production, and (div) provide Distribution Services during the Delivery TermServices. All electric metering equipment and submeters, whether owned by Seller or by a third party, which are installed on Seller’s side of the Delivery Point, as applicable, shall be operated, maintained and tested by and/or on behalf of Seller in accordance with Prudent Electrical Practices; provided that if the electric metering equipment test is conducted by the interconnecting utility or the Transmission Providerutility, testing shall be conducted in accordance with the procedures and the standards generally applied by such utility or the Transmission Provider, as applicableutility. In the event that, during the Delivery Term, Buyer develops its own system that allows Buyer to exercise greater monitoring or more efficient dispatch of the Project, upon Buyer’s notice Seller shall take reasonable actions to shall, at Seller’s expense, promptly enable its Communications Systems to interface with Buyer’s system such that Buyer may monitor and dispatch the Project through Buyer’s system.

Metering and Communications Systems. To the extent applicable as set forth in Appendix VIIIX, Seller shall install all metering, communications systems, systems and equipment for the Project (“Communications Systems”) at Seller’s sole cost and expense that is necessary to, at all times during the Delivery Term, (ai) enable Seller to meet Buyer’s instructions in accordance with Section 4.74.8, (bii) enable Buyer to remotely monitor the status of the Project on an aggregate and individual resource basis, (ciii) permit Buyer to have real time information access to the operations of the Project, including the ability to measure increases and decreases in real time load, and (div) provide Distribution Services during the Delivery Term. All electric metering equipment and submeters, whether owned by Seller or by a third party, which are installed on Seller’s side of the Delivery Point, as applicable, shall be operated, maintained and tested by and/or on behalf of Seller in accordance with Prudent Electrical Practices; provided that if the electric metering equipment test is conducted by the interconnecting utility or the Transmission Provider, testing shall be conducted in accordance with the procedures and the standards generally applied by such utility or the Transmission Provider, as applicable. In the event that, during the Delivery Term, Buyer develops its own system that allows Buyer to exercise greater monitoring or more efficient dispatch of the Project, upon Buyer’s notice Seller shall take reasonable actions to promptly enable its Communications Systems to interface with Buyer’s system such that Buyer may monitor and dispatch the Project through Buyer’s system.

Metering and Communications Systems. To the extent applicable as set forth in Appendix III and Appendix VIII, Seller shall install all metering, communications systems, systems and equipment for the Project (“Communications Systems”) at Seller’s sole cost and expense that is necessary to, at all times during the Delivery Term, (ai) enable Seller to meet Buyer’s instructions in accordance with Section 4.7, (bii) enable Buyer to remotely dispatch (e.g. immediately disconnect for safety and reliability) and monitor the status of the Project on an aggregate and individual resource basis, (ciii) permit Buyer to have real time information access to the operations of the Project, including the ability to measure increases and decreases in real time load/production, and (div) provide Distribution Services during the Delivery TermServices. All electric metering equipment and submeters, whether owned by Seller or by a third party, which are installed on Seller’s side of the Delivery Point, as applicable, shall be operated, maintained and tested by and/or on behalf of Seller in accordance with Prudent Electrical Practices; provided that if the electric metering equipment test is conducted by the interconnecting utility or the Transmission Providerutility, testing shall be conducted in accordance with the procedures and the standards generally applied by such utility or the Transmission Provider, as applicableutility. In the event that, during the Delivery Term, Buyer develops its own system that allows Buyer to exercise greater monitoring or more efficient dispatch of the Project, upon Buyer’s notice Seller shall take reasonable actions to shall, at Seller’s expense, promptly enable its Communications Systems to interface with Buyer’s system such that Buyer may monitor and dispatch the Project through Buyer’s system.

Metering and Communications Systems. To the extent applicable as set forth in Appendix VIIIX, Seller shall install all metering, communications systems, systems and equipment for the Project (“Communications Systems”) at Seller’s sole cost and expense that is necessary to, at all times during the Delivery Term, (ai) enable Seller to meet Buyer’s instructions in accordance with Section 4.74.8, (bii) enable Buyer to remotely dispatch (e.g. immediately disconnect for safety and reliability) and monitor the status of the Project on an aggregate and individual resource basis, (ciii) permit Buyer to have real time information access to the operations of the Project, including the ability to measure increases and decreases in real time load/production, and (div) provide Distribution Services during the Delivery TermServices. All electric metering equipment and submeters, whether owned by Seller or by a third party, which are installed on Seller’s side of the Delivery Point, as applicable, shall be operated, maintained and tested by and/or on behalf of Seller in accordance with Prudent Electrical Practices; provided that if the electric metering equipment test is conducted by the interconnecting utility or the Transmission Providerutility, testing shall be conducted in accordance with the procedures and the standards generally applied by such utility or the Transmission Provider, as applicableutility. In the event that, during the Delivery Term, Buyer develops its own system that allows Buyer to exercise greater monitoring or more efficient dispatch of the Project, upon Buyer’s notice Seller shall take reasonable actions to shall, at Seller’s expense, promptly enable its Communications Systems to interface with Buyer’s system such that Buyer may monitor and dispatch the Project through Buyer’s system.. 22

Metering and Communications Systems. To the extent applicable as set forth in Appendix VIII, Seller shall install all metering, communications systems, and equipment for the Project (“Communications Systems”) at Seller’s sole cost and expense that is necessary to, at all times during the Delivery Term, (a) enable Seller to meet Buyer’s instructions in accordance with Section 4.74.6, (b) enable Buyer to remotely monitor the status of the Project on an aggregate and individual resource basis, (c) permit Buyer to have real time information access to the operations of the Project, including the ability to measure increases and decreases in real time load, and (d) provide Distribution Services during the Delivery Term. All electric metering equipment and submeters, whether owned by Seller or by a third party, which are installed on Seller’s side of the Delivery Pointdelivery point, as applicable, shall be operated, maintained and tested by and/or on behalf of Seller in accordance with Prudent Electrical Practices; provided that if the electric metering equipment test is conducted by the interconnecting utility or the Transmission Provider, testing shall be conducted in accordance with the procedures and the standards generally applied by such utility or the Transmission Provider, as applicable. In the event that, during the Delivery Term, Buyer develops its own system that allows Buyer to exercise greater monitoring or more efficient dispatch of the Project, upon Buyer’s notice Seller shall take reasonable actions to enable its Communications Systems to interface with Buyer’s system such that Buyer may monitor [and dispatch request that the Seller dispatch] the Project through via Buyer’s system.. [energy efficiency delete bracketed language referring to dispatch]