MULTI-SPAN ROOF BEAM EXAMPLE Sample Clauses

MULTI-SPAN ROOF BEAM EXAMPLE. StruCalc sets the default load deflection criteria to the code required live load (L/240) and total load (L/180) deflection limits as well as setting the duration factor to 1.15 for snow loading duration. For non-snow regions, the duration factor is set to 1.25. See section 4.2.5 for snow/non-snow commentary. See section 4.2.7 for roof pitch commentary. See section 5.2.2 for the incising factor commentary.
AutoNDA by SimpleDocs

Related to MULTI-SPAN ROOF BEAM EXAMPLE

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CBB chooses to subtend a Verizon access Tandem, CBB’s NPA/NXX must be assigned by CBB to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG.

  • Multiple Bedroom Spaces If this Housing Agreement expressly identifies more than one bedroom space in a multi-bedroom apartment as assigned to Resident on page 1, then: (a) references to a “space” or “spaces” will be deemed to refer to all of the spaces assigned to Resident, or to the entire apartment if all of the bedrooms in an apartment are assigned to Resident; and (b) if Resident is assigned fewer than all of the bedroom spaces in an apartment, use of common areas will continue to be shared with other residents of the apartment and any calculation of Resident’s share of any charges assessed pro rata to all residents of an apartment will be made by dividing the number of bedroom spaces assigned to Resident by the total number of occupied bedroom spaces within the apartment.

  • Revenue Metering The Connecting Transmission Owner’s revenue metering will be located on the generator side of the 115kV breaker at the Xxxxx Solar Collector Substation and will consist of: • three (3) combination current/voltage transformer (“CT/VT”) units (manufacturer and model ABB/Xxxxxxx KXM-550, GE Grid Solutions KOTEF 000.XX, or other equivalent specified by Connecting Transmission Owner); and • one (1) revenue meter. The ratios of the CTs and VTs will be provided by Connecting Transmission Owner upon its review of the Interconnection Customer’s design documents. (Note: Connecting Transmission Owner’s revenue metering CTs and VTs cannot be used to feed the Interconnection Customer’s check meter.) SERVICE AGREEMENT NO. 2556

  • Traffic Measurement and Billing over Interconnection Trunks 6.1 For billing purposes, each Party shall pass Calling Party Number (CPN) information on at least ninety-five percent (95%) of calls carried over the Interconnection Trunks.

  • Use of Basement and Service Areas The basement(s) and service areas, if any, as located within the (project name), shall be earmarked for purposes such as parking spaces and services including but not limited to electric sub-station, transformer, DG set rooms, underground water tanks, pump rooms, maintenance and service rooms, fire fighting pumps and equipment's etc. and other permitted uses as per sanctioned plans. The Allottee shall not be permitted to use the services areas and the basements in any manner whatsoever, other than those earmarked as parking spaces, and the same shall be reserved for use by the association of allottees formed by the Allottees for rendering maintenance services.

  • Contract Database Metadata Elements Title: Whitesville Central School District and Whitesville Central School Educational Support Staff Association (2003) Employer Name: Whitesville Central School District Union: Whitesville Central School Educational Support Staff Association Local: Effective Date: 07/01/2003 Expiration Date: 06/30/2006 PERB ID Number: 10699 Unit Size: Number of Pages: 23 For additional research information and assistance, please visit the Research page of the Catherwood website - xxxx://xxx.xxx.xxxxxxx.xxx/library/research/ For additional information on the ILR School - xxxx://xxx.xxx.xxxxxxx.xxx/ AGREEMENT BETWEEN WHITESVILLE CENTRAL SCHOOL EDUCATIONAL SUPPORT STAFF ASSOCIATION AND THE WHITESVILLE CENTRAL SCHOOL DISTRICT JULY 1, 2003 THROUGH JUNE 30, 2006 TABLE OF CONTENTS ARTICLE TITLE PAGE Preamble 1 I Recognition 1 II Collective Bargaining U n i t 1 III Dues/Agency Fee Ckoffand Payroll Deduction 1 IV Rights of Employees 2 V Rights of Employer ------------- 2 VI Personnel F i l e 2 VII Employee Definitions 3 VIII Permanent Status/Seniority 4 IX Wages 5 X Overtime 7 XI Vacation 7 XII Holidays 8 XIII Sick Leave and Leavesof A b s e n c e 8 XIV Conference, Workshops,Required Courses 10 XV Meal Allowance and M i l e a g e 11 XVI Retirement 11 XVII Insurance 12 XVIII Cafeteria P l a n 14 .XIX Uniform Allowance------------------ 14 XX Hours of W o r k 14 XXI Transfers/Promotions 15 XXII Job Descriptions 15 XXIII Grievance Procedure 15 XIV Copies of the Contract 18 XV Zipper C x x x x x 18 XXVI Legislative Clause 18 XXVII Duration 19 SIGNATURES 19 APPENDIX A Grievance F o r m 20 APPENDIX B Dues Authorization F o r m 21

  • Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.

  • Dollar Limits Per Service Agreement Cost to diagnose, repair and/or replace - Geothermal and water source systems $1,500 Water cooled air conditioners, high velocity and hydronic systems $1,500 Concrete encased or concealed ductwork $500 Refrigerant lines $500 Appliances l Standard/Seller Coverage S Supreme Coverage l S Appliance color matchSM l S Built-in microwave l S Dishwasher l S Garbage disposal l S Range, oven, cooktop and vent hood l S Refrigerator - INCLUDING ICE MAKER! S Washer and dryer S Range, oven, cooktop, hood: handles, hinges, clocks, rotisseries, racks, knobs and dials, interior lining, glass/ceramic cooktops, self cleaning mechanisms and latch assemblies S Kitchen Refrigerator: handles, hinges, ice crusher, beverage dispenser and respective equipment S Built-in microwave: handles, hinges, interior lining, clocks and shelves, turntable platforms and rollers S Dishwasher: handles, hinges, racks, baskets, rollers, tub and interior lining, springs, latch assemblies and soap dispensers S Permits up to $250 per Service Agreement S Modifications up to $250 per Service Agreement S Haul away/disposal fees S Items under manufacturer’s warranty Excluded Items: ✖ Appliances not located in the primary kitchen (except washer and dryer) and duplicate appliances, unless additional refrigerator option(s) are purchased. ✖ Meat probe assemblies, door glass, sensi-heat burners will only be replaced with standard burners for range, oven, cooktop. ✖ Multimedia center including technology convenience items like LCD screens, Wi-Fi and cameras. ✖ Racks, hinges, shelves, interior thermal shells, food spoilage and freezers which are not an integral part of the kitchen refrigerator. ✖ Door glass, portable or counter top units, trim kits, meat probe assemblies, rotisseries for built-in microwave. ✖ Damage to clothing, plastic mini-tub, soap dispensers, filter screens, knobs, dials, hinges and lint screen for washer or dryer. ✖ Gas supply line to stove.

  • PREVAILING WAGE RATES - PUBLIC WORKS AND BUILDING SERVICES CONTRACTS If any portion of work being Bid is subject to the prevailing wage rate provisions of the Labor Law, the following shall apply:

  • System for Award Management (XXX) Requirement Alongside a signed copy of this Agreement, Grantee will provide Florida Housing with a XXX.xxx proof of registration and Commercial and Government Entity (CAGE) number. Grantee will continue to maintain an active XXX registration with current information at all times during which it has an active award under this Agreement.

Time is Money Join Law Insider Premium to draft better contracts faster.