Sanitary Facilities Construction (a) Closets shall be soundly constructed and roofed with weatherproof material. The floor of each closet shall be well drained and constructed of concrete, bricks and cement, or of other approved materials which shall be impervious to water. Every closet shall be well lighted by natural or artificial light and shall be ventilated. Each closet shall have a hinged door, capable of being fastened on the inside, lift seats/flaps and toilet paper. (b) If closets are of single unit construction (only to be used for the formwork process), not contained within a purpose built ablution block, privacy walls which shield the closet/s from outside view shall be installed. (Privacy walls are not required for purpose built ablution blocks eg ATCO huts). (c) Where practicable, toilets to be connected to sewerage before commencement of the job. (d) Closet/urinal location to be conveniently accessible to Employees, but not so close as to cause a nuisance to those persons. (e) Where necessary, portable water seal toilets of an approved standard are to be provided and regularly serviced. (f) Conveniently accessible closets and urinals are to be distributed every 5th floor on multi storey constructions. (g) Closets and urinals are to be washed daily with disinfectant and kept in clean, hygienic condition. (h) Adequate washing facilities, suitably drained, and wash basins/troughs are to be supplied with hot and cold running water. (i) Soap and towels are to be supplied.
Laundry Facilities Washers and dryers are installed in each apartment for the exclusive use of students in the apartment. Any other use is prohibited. The use of washers and dryers are free. LINEN: Brighton provides a mattress cover on all mattresses. Students need to bring their own bedding. All beds are regular twin size. The typical cost for replacing a mattress cover is $25.00. MAINTENANCE: Students are responsible to notify the manager in writing as soon as possible if they notice anything in an apartment that requires repair work or maintenance. See “Property Conditions” section 12 of the BYU-Idaho Student Landlord Housing Contract.
Necessary Filings 3 2.2. No Liens.........................................................3 2.3.
Building Permits All building permits required for the construction of the Improvements have been obtained prior to the commencement of the construction of the Improvements and copies of same will be delivered to Lessor.
Ancillary Facilities (a) If any Borrower and any Ancillary Lender agree, subject to compliance with the requirements set forth in this Section 2.23, such Ancillary Lender shall be permitted to provide an Ancillary Facility on a bilateral basis to such Borrower. To the extent any Ancillary Facility exists, the following shall apply: (i) The applicable Revolving Commitment of the Ancillary Lender shall: (A) be deemed to be utilized by its applicable Ancillary Commitment for purposes of (1) calculating the commitment fee payable to such Ancillary Lender pursuant to Section 2.12(a) and (2) calculating the aggregate remaining amount of Revolving Exposure of all applicable Revolving Lenders available under the Revolving Facility (it being understood the commitment fee payable pursuant Section 2.12(a) to Lenders without an Ancillary Facility shall not be modified by the existence of any Ancillary Facility and for purposes of such calculation it shall be assumed that each such Lender’s Revolving Commitments have not been reduced as a result of such Ancillary Facility) (such remaining amount, the “Remaining Revolving Exposure”) and (B) not be deemed to be utilized by the Ancillary Commitment of the applicable Ancillary Lender for purposes of determining whether the Dollar Equivalent of such Ancillary Lender’s Revolving Exposure exceeds its applicable Revolving Commitment (and therefor whether such Ancillary Lender is required to make or participate in a Loan or Letter of Credit under this Agreement). (ii) Borrowings of the Remaining Revolving Exposure shall be made on a pro rata basis among the Revolving Lenders of the applicable Class (including the applicable Ancillary Lenders) pursuant to and subject to the limitations set forth in Section 2.01. (b) To request the creation of an Ancillary Facility, any Borrower shall deliver to the Administrative Agent not later than five (5) Business Days (or such shorter period agreed to by the Administrative Agent) prior to the first date on which such Ancillary Facility is proposed to be made available: (i) a notice in writing specifying: (A) the Borrower or Borrowers to which extensions of credit will be made available thereunder; (B) the first Business Day on which such Ancillary Facility shall be made and the expiration date of such Ancillary Facility (which shall be no later than the Revolving Maturity Date); (C) the type of Ancillary Facility being provided; (D) the identity of the Ancillary Lender(s); and (E) the amount and currency of the Ancillary Commitment with respect to such Ancillary Facility (which shall be expressed in any currency to which such Ancillary Lenders may agree) and shall not exceed such Ancillary Lender’s Revolving Commitment; (ii) a copy of the Ancillary Facility Documents with respect to such Ancillary Facility, together with a certificate of a Responsible Officer of the applicable Borrower(s) certifying that the terms of such Ancillary Facility satisfy the requirements set forth in this Section 2.23 (including any applicable definitions used herein); and (iii) such other information that the Administrative Agent may reasonably request in connection with such Ancillary Facility. The Administrative Agent shall give notice to each Revolving Lender of such Ancillary Facility notice. (i) Subject to the terms of this Agreement, an Affiliate of any Revolving Lender (other than a Disqualified Institution) may become an Ancillary Lender, in which case such Revolving Lender and such Affiliate shall be treated as a single Revolving Lender whose Revolving Commitment is as set forth in Schedule 2.01 or in the Assignment and Assumption pursuant to which such Revolving Lender assumed its Revolving Commitment. (ii) To the extent that this Agreement or any other Loan Document imposes any obligation on any Ancillary Lender and such Ancillary Lender is an Affiliate of a Revolving Lender and not a party thereto, the relevant Revolving Lender shall ensure that such obligation is performed by such Affiliate in compliance with the terms hereof or such other Loan Document. (iii) Each Ancillary Lender, in its capacity as such, hereby appoints the Administrative Agent as its agent for purposes of the Loan Documents and for the avoidance of doubt agrees the Administrative Agent may rely on the applicable protections and indemnities set forth herein (including those set forth in Article IX) with respect to its role as agent under the Loan Documents for such Ancillary Lender. (d) The terms and conditions of any Ancillary Facility shall be as agreed by the applicable Ancillary Lenders and the applicable Borrower thereunder; provided that such terms shall at all times: (i) permit extensions of credit thereunder to be made only to the applicable Borrower; (ii) provide that the Ancillary Commitment of the applicable Ancillary Lenders under such Ancillary Facility shall not exceed such Ancillary Lender’s USD Only Revolving Commitment or USD/Multicurrency Revolving Commitment, as applicable, and that, in the event and on such occasion that such Ancillary Commitment exceeds such USD Only Revolving Commitment or USD/Multicurrency Revolving Commitment, as applicable, such Ancillary Commitment shall be automatically reduced by the amount of such excess; (iii) provide that the Ancillary Facility Exposure shall not exceed the Ancillary Commitment with respect to such Ancillary Facility and (iv) provide that the Ancillary Commitment under such Ancillary Facility shall be canceled, and that all extensions of credit under such Ancillary Facility shall be repaid, not later than the Revolving Maturity Date unless cash collateralized or supported by the issuance of a “back to back” letter of credit in a manner meeting the requirements of clause (iv) of the definition of “Date of Full Satisfaction”. (e) (i) Each Ancillary Facility shall terminate on the Revolving Maturity Date or such earlier date (A) as provided in the relevant Ancillary Facility Document or (B) on which its expiry date occurs or on which it is cancelled in accordance with the terms of this Agreement.
Employee Facilities Employee Facilities. Restrooms and attendant facilities shall be provided as required in the orders and regulations of the State of Washington Department of Labor and Industries. A good faith effort will be made by the Employer to provide facilities for employees’ personal belongings.
Building Permit The Owner shall pay for all permits. The Owner and AE shall be required to provide such information to the Permitting Authority as is necessary to obtain approval from the Permitting Authority to commence construction prior to beginning construction. The CM shall pull the Building Permit, and shall be responsible for delivering and posting the Building Permit at the Project Site prior to the commencement of construction. The Owner and AE shall fully cooperate with the CM when and where necessary.
PUBLIC FACILITIES Supplier’s employees may be required to perform work at government- owned facilities, including schools. Supplier’s employees and agents must conduct themselves in a professional manner while on the premises, and in accordance with Participating Entity policies and procedures, and all applicable laws.
Office Facilities During the period of employment, Executive shall have his office where the Corporation’s principal executive offices are located from time to time, which currently are at 3000 Xxxx Xxxxxxxxxx Xxxxxx, Xxxxx Xxxxx, Xxxxx Xxxxxx, and the Corporation shall furnish Executive with office facilities reasonably suitable to his position at such location.
Foreign-Owned Companies in Connection with Critical Infrastructure If Texas Government Code, Section 2274.0102(a)(1) (relating to prohibition on contracts with certain foreign-owned companies in connection with critical infrastructure) is applicable to this Contract, pursuant to Government Code Section 2274.0102, Contractor certifies that neither it nor its parent company, nor any affiliate of Contractor or its parent company, is: (1) majority owned or controlled by citizens or governmental entities of China, Iran, North Korea, Russia, or any other country designated by the Governor under Government Code Section 2274.0103, or (2) headquartered in any of those countries.