NON-REMOTE METER READS FROM HAND HELD EQUIPMENT. 3.1 If :-
NON-REMOTE METER READS FROM HAND HELD EQUIPMENT Sample Clauses
Related to NON-REMOTE METER READS FROM HAND HELD EQUIPMENT
Inventory Report – Remote Premises The locations of the Remote Premises (e.g., Feeder Distribution Interfaces, "FDI") and the End User Customer addresses served by each Remote Premises are available to CLEC through the Raw Loop Data Tool. Remote Premises with digital loop carrier and pair gain equipment will be provided on the web site in the ICONN database. (ICONN is available through the Qwest web site located at xxxx://xxx.xxxxx.xxx/iconn.) If CLEC is unable to determine the information it seeks regarding the Remote Premises after using such database tools, Qwest will provide CLEC with a report that contains the information. The Parties agree that a charge may apply to such report, based on time and material, unless the database information is inaccurate or unusable for the Remote Premises then no charge would apply. Qwest will provide CLEC access to relevant plats, maps, engineering records and other data in accordance with Section 10.8.2.4. In addition, CLEC can request a copy of Qwest's distribution area map associated with the Remote Premises, with a charge for time and material.
Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract.
Additional Acceptable Uses of Student Data Contractor is prohibited from using Student Data for any secondary use not described in this agreement except:
CONDITIONS FOR EMERGENCY/HURRICANE OR DISASTER - TERM CONTRACTS It is hereby made a part of this Invitation for Bids that before, during and after a public emergency, disaster, hurricane, flood, or other acts of God that Orange County shall require a “first priority” basis for goods and services. It is vital and imperative that the majority of citizens are protected from any emergency situation which threatens public health and safety, as determined by the County. Contractor agrees to rent/sell/lease all goods and services to the County or other governmental entities as opposed to a private citizen, on a first priority basis. The County expects to pay contractual prices for all goods or services required during an emergency situation. Contractor shall furnish a twenty-four (24) hour phone number in the event of such an emergency.
Violations - Remote Scaling Requirement If PURCHASER violates any of the log accountability requirements of this contract, STATE may require all logs from timber sold under the terms and conditions of this contract to be scaled at a ramp provided by PURCHASER, in a location designated by STATE. All costs associated with this additional scaling requirement shall be paid by PURCHASER. Cost of Scaling. All costs of scaling and all costs in connection with reports furnished to STATE shall be paid by PURCHASER. PURCHASER shall require the scaling organization to furnish copies each week to STATE of all scaled certificates showing gross and net volumes, by species and grade, of all logs scaled during the week. Upon request by STATE, PURCHASER shall also require the scaling organization to furnish and attach a log detail listing to each weekly scale certificate showing all STATE logs included on the certificate. Scaling Instructions. PURCHASER agrees that STATE shall provide instructions to the approved third-party scaling organization for the scaling practices to be used for timber removed from the timber sale area. Instructions shall conform to the terms of this contract, including special scales as necessary. PURCHASER shall acknowledge and sign such instructions and shall be provided a copy. Minimum Products Specifications and Special Scale information are shown on Exhibit G. Logs Damaged During Handling. Mechanical damage to logs shall be prevented during log handling. Deductions for handling damage shall not be allowed. Add-Back Volume. Scaling deduction for deterioration due to abnormal delay in removal of logs from the timber sale area shall not be allowed in determining net volume. Volume of material deteriorated due to delay in removal shall be reported to STATE and paid for at the contract price. Cost for separate reports shall be paid by PURCHASER. Special Scaling Instructions. Segment scaling or grading of logs in excess of 40 feet in gross scaling length shall use actual taper. Procedures are set forth in "Segment Scaling and Grading of Long Logs - All Species - State Forestry Department Scaling Instructions" (Westside).
Additional Requirements from Authorized Users An Authorized User may have distinct requirements that must be met by all individuals employed by or working for the Authorized User. The Contractor’s Staff Members will be expected to comply with these requirements as a condition of the placement.
Overstory Removal Units All trees within “Overstory Removal Units” are designated for cutting when they meet Utilization Standards and equal or exceed the diameter limits shown on Sale Area Map. B2.34 Understory Removal Units. All trees within “Understory Removal Units” are designated for cutting when they meet Utilization Standards and are smaller than the diameter limits shown on Sale Area Map. B2.35 Individual Trees. All trees to be cut, other than in the units described in B2.31, B2.32, B2.33, and B2.34, are Marked or designated by description. Trees are “Marked” when individually designated by Forest Service with paint marks above and below xxxxx height. Sale Area Map indicates areas plainly identified on the ground where leave trees are Marked to be left uncut. B2.36 Incompletely Marked Timber. Trees within incompletely Marked subdivisions shown on Sale Area Map at time of timber sale advertisement shall be designated in accordance with C2.36. A representative sample of the timber to be designated has been Marked prior to timber sale advertisement in accordance with such rules. The approximate locations of the representa- tive sample areas are shown on Sale Area Map.
GOODS RE-ENTERED AFTER REPAIR OR ALTERATION 1. No Party may apply a customs duty to a good, regardless of its origin, that re-enters its territory after that good has been temporarily exported from its territory to the territory of another Party for repair or alteration, regardless of whether such repair or alteration could be performed in the territory of the Party from which the good was exported for repair or alteration.
CREDIT UNION LIABILITY FOR FAILURE TO MAKE TRANSFERS If we do not complete a transfer to or from your account on time or in the correct amount according to our agreement with you, we may be liable for your losses or damages. However, we will not be liable for direct or consequential damages in the following events: - If, through no fault of ours, there is not enough money in your accounts to complete the transaction, if any funds in your accounts necessary to complete the transaction are held as uncollected funds pursuant to our Funds Availability Policy Disclosure, or if the transaction involves a loan request exceeding your credit limit. - If you used your card or access code in an incorrect manner. - If the ATM where you are making the transfer does not have enough cash. - If the ATM was not working properly and you knew about the problem when you started the transaction. - If circumstances beyond our control (such as fire, flood, or power failure) prevent the transaction. - If the money in your account is subject to legal process or other claim. - If funds in your account are pledged as collateral or frozen because of a delinquent loan. - If the error was caused by a system of any participating ATM network. - If the electronic transfer is not completed as a result of your willful or negligent use of your card, access code, or any EFT facility for making such transfers. - If the telephone or computer equipment you use to conduct audio response, online/PC, or mobile banking transactions is not working properly and you know or should have known about the breakdown when you started the transaction. - If you have xxxx payment services, we can only confirm the amount, the participating merchant, and date of the xxxx payment transfer made by the Credit Union. For any other error or question you have involving the billing statement of the participating merchant, you must contact the merchant directly. We are not responsible for investigating such errors. - Any other exceptions as established by the Credit Union.
