Normative References. This section contains those documents that are required for understanding this document. These referenced documents may contain requirements that are implicitly included in this document.
Normative References. 3.8.1 The solution offered must be compliant with SABS 1524, the STS Specifications, SABS IEC 1036 and any other relevant guidelines and standards in the industry to ensure compliance and STS standards for Water and Electricity (as and when required).
Normative References. This MRA was signed based on the references below. If not dated, the latest versions will apply, out of transition period if exists. • EFSG terms of reference • EN 1143-1 Secure storage units – Requirements, classification and methods of tests for resistance to burglary – Part 1: Safes, ATM safes, strongroom doors and strongrooms. • EN 1143-2 Secure storage units – Requirements, classification and methods of test for resistance to burglary – Part 2: Deposit systems • EN 14450 Secure storage units - Requirements, classification and methods of test for resistance to burglary - Secure safe cabinets • EN ISO 9001 Quality management system – Requirements
Normative References. Atom: RFC 4287 The Atom Syndication Format. December 2005.
Normative References. [1], [2] and [3] are normative documents that contain provisions which constitute provisions of the SysML specification. Refer to the OMG site [4] for subsequent amendments to, or revisions of any of these publications.
Normative References. This MRA was signed based on the references below. If not dated, the latest versions will apply, out of transition period if exists. EFSG terms of reference EN 1300:2013 Secure storage units – Classification for high security locks according to their resistance against unauthorized opening, without distributed Systems EN ISO 9001 Quality management system – Requirements
Normative References. ISO/TS 16949 : Quality System Requirements • ISO 14001 : Environmental Management Systems • AIAG CQI-9 : Special Process “Heat Treat Assessment” • AIAG CQI-11 : Special Process “Plating System Assessment” • AIAG CQI-12 : Special Process “Coating System Assessment” • AIAG CQI-15 : Special Process “Welding System Assessment” • AIAG CQI-17 : Special Process “Soldering System Assessment” • AIAG PPAP : Production Part Approval Process • AIAG APQP : Advanced Product Quality Planning and Control Plan • AIAG FMEA : Potential Failure Modes and Effects Analysis • AIAG MSA : Measurement Systems Analysis • AIAG SPC : Fundamental Statistical Process Control • VDA Volume 2 : Quality Assurance of Suppliers
Normative References. 98 The following documents are referred to in the text in such a way that some or all of their content 99 constitutes requirements of this document. For dated references, only the edition cited applies. For 100 undated references, the latest edition of the referenced document (including any amendments) applies.
Normative References. The indispensable referenced documents for the application of this Standard are referred to EN 545:2010. TERMS AND DEFINITIONS The terms and definitions in the EN 545:2010 also apply for this Standard. TECHNICAL REQUIREMENTS GENERAL DUCTILE IRON PIPES, FITTINGS AND ACCESSORIES
Normative References. 1) These Regulations are developed on the basis of the following external regulatory documents: - The Law of the Republic of Kazakhstan dated July 27, 2007 No. 319-III “On Education” (with amendments and additions as of April 19, 2019); - The Code of the Republic of Kazakhstan dated September 18, 2009 No. 193-IV “On the Health of the People and the Health Care System” (as amended and supplemented as of April 19, 2019); - The Labor Code of the Republic of Kazakhstan dated November 23, 2015 No. 414- V (as amended and supplemented as of 01.01.2019).
