Opal Ea Inventory Volume Nominations
Opal Ea Inventory Volume Nominations Sample Clauses
Related to Opal Ea Inventory Volume Nominations
Minimum Shipping Requirements for TIPS Sales Vendor shall ship, deliver, or provide ordered goods and services within a commercially reasonable time after acceptance of the order. If a delay in delivery is anticipated, Vendor shall notify the TIPS Member as to why delivery is delayed and provide an updated estimated time for completion. The TIPS Member may cancel the order if the delay is not commercially acceptable or not consistent with the Supplemental Agreement applicable to the order.
Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.
Contract Year A twelve (12) month period during the term of the Agreement commencing on the Effective Date and each anniversary thereof.
Minimum Customer Support Requirements for TIPS Sales Vendor shall provide timely and commercially reasonable support for TIPS Sales or as agreed to in the applicable Supplemental Agreement.
Minimum Site Requirements for TIPS Sales (when applicable to TIPS Sale). Cleanup: When performing work on site at a TIPS Member’s property, Vendor shall clean up and remove all debris and rubbish resulting from their work as required or directed by the TIPS Member or as agreed by the parties. Upon completion of work, the premises shall be left in good repair and an orderly, neat, clean and unobstructed condition. Preparation: Vendor shall not begin a project for which a TIPS Member has not prepared the site, unless Vendor does the preparation work at no cost, or until TIPS Member includes the cost of site preparation in the TIPS Sale Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre‐installation requirements. Registered Sex Offender Restrictions: For work to be performed at schools, Vendor agrees that no employee of Vendor or a subcontractor who has been adjudicated to be a registered sex offender will perform work at any time when students are, or reasonably expected to be, present unless otherwise agreed by the TIPS Member. Vendor agrees that a violation of this condition shall be considered a material breach and may result in the cancellation of the TIPS Sale at the TIPS Member’s discretion. Vendor must identify any additional costs associated with compliance of this term. If no costs are specified, compliance with this term will be provided at no additional charge. Safety Measures: Vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage. Smoking: Persons working under Agreement shall adhere to the TIPS Member’s or local smoking statutes, codes, ordinances, and policies.
Contract Quantity The Contract Quantity during each Contract Year is the amount set forth in the applicable Contract Year in Section D of the Cover Sheet (“Delivery Term Contract Quantity Schedule”), which amount is inclusive of outages.
SIGNIFICANT LANDS INVENTORY FINDING Find that this activity is consistent with the use classification designated by the Commission for the land pursuant to Public Resources Code section 6370 et seq.
Rolling Forecast (i) On or before the fifteenth (15th) calendar day of each month during the Term (as defined in Section 6.1 herein), Buyer shall provide Seller with an updated eighteen (18) month forecast of the Products to be manufactured and supplied (each a “Forecast”) for the eighteen (18) month period beginning on the first day of the following calendar month. The first two months of each Forecast will restate the balance of the Firm Order period of the prior Forecast, and the first three (3) months of the Forecast shall constitute the new Firm Order period for which Buyer is obligated to purchase and take delivery of the forecasted Product, and the supply required for the last month of such new Firm Order period shall not be more than one (1) full Standard Manufacturing Batch from the quantity specified for such month in the previous Forecast (or Initial Forecast, as the case may be). Except as provided in Section 2.2(a), Purchase Orders setting forth Buyer’s monthly Product requirements will be issued for the last month of each Firm Order period no later than the fifteenth calendar day of the first month of each Firm Order period, and such Purchase Order will be in agreement with the Firm Order period of the Forecast. If a Purchase Order for any month is not submitted by such deadline, Buyer shall be deemed to have submitted a Purchase Order for such month for the amount of Product set forth in Buyer’s Forecast for such month. (ii) The remainder of the Forecast shall set forth Buyer’s best estimate of its Product production and supply requirements for the remainder of the Forecast period. Each portion of such Forecast that is not deemed to be a Firm Order shall not be deemed to create a binding obligation on Buyer to purchase and take delivery of Products nor a binding obligation of Seller to deliver Products, except as otherwise provided in Section 2.2(f). (iii) Forecast and Purchase Orders shall be in full Standard Manufacturing Batches. If a Product has multiple SKUs, then the composite of the forecasted SKU must equate to the Standard Manufacturing Batch. One Purchase Order shall be issued for each full Standard Manufacturing Batch of Product and contain the required information set forth in Section 2.2(e) hereof.
Rolling Forecasts No later than ten (10) days of the Commencement Date, the Client shall provide Patheon with a written non-binding 18 month forecast of the volume of the Drug Product that the Client then anticipates will be required to be produced and delivered to the Client during each month of that 18 month period. Such forecast will be updated by the Client monthly on a rolling 18 month basis and updated forthwith upon the Client determining that the volumes contemplated in the most recent of such forecasts has changed by more than 20%. The most recent 18 month forecast shall prevail.
Sale of Inventory Purchaser shall purchase (or shall cause its Affiliates to purchase) the Inventory in separate transactions in accordance with the terms and conditions contained in the Supply Agreement. It is agreed and understood by and between the Parties that the Purchase Price does not include the Inventory.
