Vehicles and Equipment Consultant will furnish all vehicles, equipment, tools, and materials used to provide the Services required by this Agreement. Client will not require Consultant to rent or purchase any equipment, product, or service as a condition of entering into this Agreement.
FURNITURE CLASSIFICATIONS Furniture classifications include but not limited to: Cafeteria, Dormitory, Library Shelving and Library Related, Lounge, Systems (Modular), School (Classroom), Freestanding, Seating, Filing Systems and Equipment, and Technology Support.
Additional Requirements for Sleeping Rooms The Contractor shall provide departing Attendees a secured area for storing belongings.
Tools and Equipment As established by current practices, the Employer may determine and provide necessary tools, tool allowance, equipment and foul weather gear. The Employer will repair or replace employer-provided tools and equipment if damaged or worn out beyond usefulness in the normal course of business. Employees are accountable for equipment and/or tools assigned to them and will maintain them in a clean and serviceable condition.
Classroom Visitation To provide patrons of the District the opportunity to visit classrooms with the least interruption to the teaching process, the following guidelines are set forth: A. All visitors to a school and/or classroom shall obtain the approval of the principal, and if the visit is to a classroom, the time will be arranged after the principal or his designee has conferred with the employee, if possible. B. Whenever possible, the employee shall be afforded the opportunity to confer with the classroom visitor before and/or after the visitation. C. This provision does not apply to administrators and Board of Directors members.
Leave for Writing Examinations Leave of absence with pay shall be granted to allow employees time to write examinations for courses approved by the Employer. Employees shall advise the Employer of the time and place of the examination when they are made aware of the time and place.
Maintenance and Use of Property Borrower shall cause the Property to be maintained in a good and safe condition and repair. The Improvements and the Personal Property shall not be removed, demolished or materially altered (except for normal replacement of the Personal Property or as permitted in the PETsMART Lease) without the consent of Lender. Except as provided in Section 3.8(f) hereof, Borrower shall promptly repair, replace or rebuild or cause to be repaired, replaced or rebuilt, any part of the Property which may be destroyed by any casualty, or become damaged, worn or dilapidated or which may be affected by any proceeding of the character referred to in Section 3.6 hereof and shall complete and pay for any structure at any time in the process of construction or repair on the Land. Borrower shall not initiate, join in, acquiesce in, or consent to any change in any private restrictive covenant, zoning law or other public or private restriction, limiting or defining the uses which may be made of the Property or any part thereof, provided, that Borrower shall be permitted to enter into easement agreements or grant rights of way so long as such agreements or grants do not reduce the value of the Property or impair its use, and so long as Borrower has delivered to Lender a title endorsement satisfactory to Lender with respect to such agreements and/or rights of way. If under applicable zoning provisions the use of all or any portion of the Property is or shall become a nonconforming use, Borrower will not cause or permit the nonconforming use to be discontinued or the nonconforming Improvement to be abandoned without the express written consent of Lender.
Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.
Maintenance of Total Unencumbered Assets The Company and its Subsidiaries will maintain Total Unencumbered Assets of not less than 200% of the aggregate outstanding principal amount of the Unsecured Debt of the Company and its Subsidiaries on a consolidated basis.
Equipment Testing and Inspection 2.1.1 The Interconnection Customer shall test and inspect its Small Generating Facility and Interconnection Facilities prior to interconnection. The Interconnection Customer shall notify the NYISO and the Connecting Transmission Owner of such activities no fewer than five Business Days (or as may be agreed to by the Parties) prior to such testing and inspection. Testing and inspection shall occur on a Business Day. The Connecting Transmission Owner may, at its own expense, send qualified personnel to the Small Generating Facility site to inspect the interconnection and observe the testing. The Interconnection Customer shall provide the NYISO and Connecting Transmission Owner a written test report when such testing and inspection is completed. The Small Generating Facility may not commence parallel operations if the NYISO, in consultation with the Connecting Transmission Owner, finds that the Small Generating Facility has not been installed as agreed upon or may not be operated in a safe and reliable manner. 2.1.2 The NYISO and Connecting Transmission Owner shall each provide the Interconnection Customer written acknowledgment that it has received the Interconnection Customer’s written test report. Such written acknowledgment shall not be deemed to be or construed as any representation, assurance, guarantee, or warranty by the NYISO or Connecting Transmission Owner of the safety, durability, suitability, or reliability of the Small Generating Facility or any associated control, protective, and safety devices owned or controlled by the Interconnection Customer or the quality of power produced by the Small Generating Facility.