Other Methods of Procurement of Goods and Works. The following table specifies the methods of procurement, other than International Competitive Bidding, which may be used for goods and works. The Procurement Plan shall specify the circumstances under which such methods may be used: (a) National Competitive Bidding (b) Shopping (c) Direct Contracting
Other Methods of Procurement of Goods and Works The following table specifies the methods of procurement, other than International Competitive Bidding, which may be used for goods and works. The Procurement Plan shall specify the circumstances under which such methods may be used: (a) National Competitive Bidding (b) Shopping (c) Direct Contracting
Particular Methods of Procurement of Goods Works and Services (other than Consultants’ Services)
Particular Methods of Procurement of Goods and Works International Competitive Bidding. Goods and works shall be procured under contracts awarded on the basis of International Competitive Bidding.
Procurement of Goods and Services (a) If the HSP is subject to the procurement provisions of the BPSAA, the HSP will abide by all directives and guidelines issued by the Management Board of Cabinet that are applicable to the HSP pursuant to the BPSAA. (b) If the HSP is not subject to the procurement provisions of the BPSAA, the HSP will have a procurement policy in place that requires the acquisition of supplies, equipment or services valued at over $25,000 through a competitive process that ensures the best value for funds expended. If the HSP acquires supplies, equipment or services with the Funding it will do so through a process that is consistent with this policy.
Procurement of Goods Part A: General Goods shall be procured in accordance with the provisions of Section I of the "Guidelines for Procurement under IBRD Loans and XXX Credits" published by the Bank in January 1995 and revised in January 1996 (the Guidelines) and the following provisions of this Section, as applicable. Part B: International Competitive Bidding
Procurement of Goods and Works Except as ADB may otherwise agree, Goods and Works shall only be procured on the basis of the methods of procurement set forth below:
Other Methods of Procurement of Consultants’ Services The following table specifies the methods of procurement, other than Quality and Cost-based Selection, which may be used for consultants’ services. The Procurement Plan shall specify the circumstances under which such methods may be used. (a) Quality-based Selection (b) Selection under a Fixed Budget
Goods and Services 4.3.1. The Supplier shall ensure that the Goods and/or the Services provided are fit for the purposes that may reasonably be inferred from the technical specifications and in accordance with the timetable for performance defined in the Contract. In any event the Supplier commits himself to achieve performance and results stipulated in the Contract. 4.3.2. The Goods and/or Services shall be delivered in a state of full completion with the complete “Documentation” (any operation and maintenance manuals, drawings, calculations, technical data, logic diagrams, progress reports, quality documentation, conformity certificates, test reports, bill of lading, certificates of origin, export control classification list number as per any applicable export regulation - such as the European Council Regulation 428/2009 (as amended) and/or the U.S. Export Administration Regulations (“EAR”), percentage of U.S. origin content, U.S. Export Control Classification Number (“ECCN”) or U.S. Munitions List category (“USML”) (if applicable) export authorizations and licenses, Harmonized Tariff Code - and any such other documents required under the Contract and/or applicable Laws) associated therewith as well as all instructions, recommendationsandother indicationsnecessaryin orderfor themtobeused correctly and under the appropriate safety conditions. If so required by the Purchaser, the Supplier shall submit any such Documentation to the Purchaserwith sufficient timeforreview andapproval by the Customer, in accordancewith the time-lines agreed between the Purchaser and the Customer. Where the Documentation provided by the Supplier is not compliant with Purchaser’s contractual requirements, the Supplier must make the necessary modifications, and indemnify the Purchaser for any costs, liabilities or penalties incurred by the Purchaser as a result of the non-compliance and/or delay. 4.3.3. Goods or Services that donotmeetall the requirements set in this Article 4.3 shall be considered as having a Non-Conformity as per Article 10 of these General Conditions and may be recorded as a non-conformity event (NCE) as defined in the Supplier Quality Manual. 4.3.4. If the Supplier is not certain that the results of the Services or Goods comply with the requirements defined in this Article 4.3, it shall inform immediately the Purchaser thereof in writing, providing all the needed indications concerning the risks of non- compliance and the measures that the Supplier intends to take in order to remedy the situation. The Purchaser shall notify its acceptance or rejection of the Supplier’s proposals as soon as possible and in writing. 4.3.5. If the Purchaser assesses on its part that the Supplier is not performing the Services and/or supplying the Goods in accordance with the Contract, itmay require the Supplier to indicate to it, in writing, the measures that the Supplier intends to take to remedy the situation. The Purchaser shall notify the Supplier in writing as soon as possible of its acceptance or rejection of the Supplier’s proposals.
Particular Methods of Procurement of Consultants’ Services 1. Quality- and Cost-based Selection. Except as otherwise provided in paragraph 2 below, consultants’ services shall be procured under contracts awarded on the basis of Quality and Cost-based Selection.
