Amendments to Servicing Agreements, Modification of Standard Provisions (a) Subject to the prior written consent of the Trustee pursuant to Section 3.07(b), the Master Servicer from time to time may, to the extent permitted by the applicable Servicing Agreement, make such modifications and amendments to such Servicing Agreement as the Master Servicer deems necessary or appropriate to confirm or carry out more fully the intent and purpose of such Servicing Agreement and the duties, responsibilities and obligations to be performed by the Servicer thereunder. Such modifications may only be made if they are consistent with the REMIC Provisions, as evidenced by an Opinion of Counsel. Prior to the issuance of any modification or amendment, the Master Servicer shall deliver to the Trustee such Opinion of Counsel and an Officer's Certificate setting forth (i) the provision that is to be modified or amended, (ii) the modification or amendment that the Master Servicer desires to issue and (iii) the reason or reasons for such proposed amendment or modification. (b) The Trustee shall consent to any amendment or supplement to a Servicing Agreement proposed by the Master Servicer pursuant to Section 3.07(a), which consent and amendment shall not require the consent of any Certificateholder if it is (i) for the purpose of curing any mistake or ambiguity or to further effect or protect the rights of the Certificateholders or (ii) for any other purpose, provided such amendment or supplement for such other purpose cannot reasonably be expected to adversely affect Certificateholders. The lack of reasonable expectation of an adverse effect on Certificateholders may be established through the delivery to the Trustee of (i) an Opinion of Counsel to such effect or (ii) written notification from each Rating Agency to the effect that such amendment or supplement will not result in reduction of the current rating assigned by that Rating Agency to the Certificates. Notwithstanding the two immediately preceding sentences, the Trustee may, in its discretion, decline to enter into or consent to any such supplement or amendment if its own rights, duties or immunities shall be adversely affected. (i) Notwithstanding anything to the contrary in this Section 3.07, the Master Servicer from time to time may, without the consent of any Certificateholder or the Trustee, enter into an amendment (A) to an Other Servicing Agreement for the purpose of (i) eliminating or reducing Month End Interest and (ii) providing for the remittance of Full Unscheduled Principal Receipts by the applicable Servicer to the Master Servicer not later than the 24th day of each month (or if such day is not a Business Day, on the previous Business Day) or (B) to the WFHM Servicing Agreement for the purpose of changing the applicable Remittance Date to the 18th day of each month (or if such day is not a Business Day, on the previous Business Day). (ii) The Master Servicer may direct WFHM to enter into an amendment to the WFHM Servicing Agreement for the purposes described in Sections 3.07(c)(i)(B) and 10.01(b)(iii).
Restrictions on Activities of the Trust Notwithstanding any other provision of this Agreement and any provision of law that otherwise so empowers the Trust, so long as any Certificates are outstanding, the Trust shall not, and none of the Trustee, the Delaware Trustee, the Company or the Servicer shall knowingly cause the Trust to, do any of the following: (i) engage in any business or activity other than those set forth in Section 2.01; (ii) incur or assume any indebtedness except for such indebtedness that may be incurred by the Trust in connection with the execution or performance of this Agreement or any other agreement contemplated hereby; (iii) guarantee or otherwise assume liability for the debts of any other party; (iv) do any act in contravention of this Agreement or any other agreement contemplated hereby to which the Trust is a party; (v) do any act which would make it impossible to carry on the ordinary business of the Trust; (vi) confess a judgment against the Trust; (vii) possess or assign the assets of the Trust for other than a Trust purpose; (viii) cause the Trust to lend any funds to any entity, except as contemplated by this Agreement; or (ix) change the purposes and powers of the Trust from those set forth in this Agreement.
CFR Part 200 or Federal Provision - Xxxx Anti-Lobbying Amendment - Continued If you answered "No, Vendor does not certify - Lobbying to Report" to the above attribute question, you must download, read, execute, and upload the attachment entitled "Disclosure of Lobbying Activities - Standard Form - LLL", as instructed, to report the lobbying activities you performed or paid others to perform. Compliance with all applicable standards, orders, or requirements issued under section 306 of the Clean Air Act (42 U.S.C. 1857(h)), section 508 of the Clean Water Act (33 U.S.C. 1368), Executive Order 11738, and Environmental Protection Agency regulations (40 CFR part 15). (Contracts, subcontracts, and subgrants of amounts in excess of $100,000) Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, ESC Region 8 and TIPS Members requires the proposer certify that in performance of the contracts, subcontracts, and subgrants of amounts in excess of $250,000, the vendor will be in compliance with all applicable standards, orders, or requirements issued under section 306 of the Clean Air Act (42 U.S.C. 1857(h)), section 508 of the Clean Water Act (33 U.S.C. 1368), Executive Order 11738, and Environmental Protection Agency regulations (40 CFR part 15). Does vendor certify compliance? Yes
How Are Contributions to a Xxxx XXX Reported for Federal Tax Purposes You must file Form 5329 with the IRS to report and remit any penalties or excise taxes. In addition, certain contribution and distribution information must be reported to the IRS on Form 8606 (as an attachment to your federal income tax return.)
Restrictions on Payments An employee shall not be entitled to payment for inclement weather as provided for in this clause unless the employee remains on the job until the provisions set out in this clause have been observed.
COMPLIANCE WITH TAX LAW SECTION 5-a The following provisions apply to Contractors that have entered into agreements in an amount exceeding $100,000 for the purchase of goods and services: a) Before such agreement can take effect, the Contractor must have on file with the New York State Department of Taxation and Finance a Contractor Certification form (ST-220-TD). b) Prior to entering into such an agreement, the Contractor is required to provide NYSERDA with a completed Contractor Certification to Covered Agency form (Form ST-220-CA). c) Prior to any renewal period (if applicable) under the agreement, the Contractor is required to provide NYSERDA with a completed Form ST-220-CA. Certifications referenced in paragraphs (b) and (c) above will be maintained by NYSERDA and made a part hereof and incorporated herein by reference. NYSERDA reserves the right to terminate this agreement in the event it is found that the certification filed by the Contractor in accordance with Tax Law Section 5-a was false when made.
Total Payments to Other Dist & Govt Units Tuition (In State) 2500 2600 2600 2900 2000 3000 4000 4100 4200 4300 4000 5000 5100 5200 5000 6000
Restrictions to Safeguard the Balance of Payments 1. The Parties shall endeavour to avoid the imposition of restrictions to safeguard the balance of payments. 2. The rights and obligations of the Parties in respect of such restrictions shall be governed by paragraphs 1 to 3 of Article XII of the GATS, which are hereby incorporated into and made part of this Chapter, mutatis mutandis. 3. A Party adopting or maintaining such restrictions shall promptly notify the Joint Committee.
Payments Subject to Section 409A (a) Subject to this Section 4.3, payments or benefits under Section 4.1 shall begin only upon the date of a “separation from service” of the Executive (determined as set forth below) that occurs on or after the termination of the Executive’s employment. The following rules shall apply with respect to distribution of the payments and benefits, if any, to be provided to the Executive under Section 4.1: (i) It is intended that each installment of the payments and benefits provided under Section 4.1 shall be treated as a separate “payment” for purposes of Section 409A of the Code and the guidance issued thereunder (“Section 409A”). Neither the Company nor the Executive shall have the right to accelerate or defer the delivery of any such payments or benefits except to the extent specifically permitted or required by Section 409A. (ii) If, as of the date of the “separation from service” of the Executive from the Company, the Executive is not a “specified employee” (within the meaning of Section 409A), then each installment of the payments and benefits shall be made on the dates and terms set forth in Section 4.1. (iii) If, as of the date of the “separation from service” of the Executive from the Company, the Executive is a “specified employee” (within the meaning of Section 409A), then: (A) Each installment of the severance payments and benefits due under Section 4.1 that, in accordance with the dates and terms set forth herein, will in all circumstances, regardless of when the separation from service occurs, be paid within the short-term deferral period (as defined in Section 409A) shall be treated as a short-term deferral within the meaning of Treasury Regulation Section 1.409A-1(b)(4) to the maximum extent permissible under Section 409A; and (B) Each installment of the payments and benefits due under Section 4.1 that is not described in Section 4.3(a)(iii)(A) and that would, absent this subsection, be paid within the six-month period following the “separation from service” of the Executive from the Company shall not be paid until the date that is six months and one day after such separation from service (or, if earlier, the Executive’s death), with any such installments that are required to be delayed being accumulated during the six-month period and paid in a lump sum on the date that is six months and one day following the Executive’s separation from service and any subsequent installments, if any, being paid in accordance with the dates and terms set forth herein; provided, however, that the preceding provisions of this sentence shall not apply to any installment of payments and benefits if and to the maximum extent that that such installment is deemed to be paid under a separation pay plan that does not provide for a deferral of compensation by reason of the application of Treasury Regulation 1.409A-1(b)(9)(iii) (relating to separation pay upon an involuntary separation from service). Any installments that qualify for the exception under Treasury Regulation Section 1.409A-1(b)(9)(iii) must be paid no later than the last day of the Executive’s second taxable year following his taxable year in which the separation from service occurs. (b) The determination of whether and when a separation from service of the Executive from the Company has occurred shall be made in a manner consistent with, and based on the presumptions set forth in, Treasury Regulation Section 1.409A-1(h). Solely for purposes of this Section 4.3(b), “Company” shall include all persons with whom the Company would be considered a single employer as determined under Treasury Regulation Section 1.409A-1(h)(3).
XXXXX-XXXXX AND RELATED ACT PROVISIONS This section is applicable to all Federal-aid construction projects exceeding $2,000 and to all related subcontracts and lower-tier subcontracts (regardless of subcontract size). The requirements apply to all projects located within the right-of- way of a roadway that is functionally classified as Federal-aid highway. This excludes roadways functionally classified as local roads or rural minor collectors, which are exempt. Contracting agencies may elect to apply these requirements to other projects. The following provisions are from the U.S. Department of Labor regulations in 29 CFR 5.5 “Contract provisions and related matters” with minor revisions to conform to the FHWA- 1273 format and FHWA program requirements.