Place of Closing and Transfer. The Closing and Transfer shall take place at City Hall, Yonkers, New York, or at the offices of the Company's Institutional Lender or the Institutional Lender's attorneys.
Place of Closing and Transfer Sample Clauses
Related to Place of Closing and Transfer
Place of Closing The Closing shall take place at Seller's offices located at 0000 Xxxxxxxx Xxxxx, Xxxxxxxx, Xxxxx, or such other place as the Parties may agree in writing.
Time and Place of Closing The closing of the transactions contemplated hereby (the "Closing") will take place at 9:00 A.M. on the date that the Effective Time occurs (or the immediately preceding day if the Effective Time is earlier than 9:00 A.M.), or at such other time as the Parties, acting through their authorized officers, may mutually agree. The Closing shall be held at such location as may be mutually agreed upon by the Parties.
Place of delivery Every notice or other communication relating to this Agreement shall be in writing, and shall be mailed to or delivered to the party for whom or which it is intended at such address as may from time to time be designated by it in a notice mailed or delivered to the other party as herein provided; provided, that unless and until some other address be so designated, all notices and communications by Employee to the Company shall be mailed or delivered to the Company at its principal executive office, and all notices and communications by the Company to Employee may be given to Employee personally or may be mailed to Employee at Employee’s last known address, as reflected in the Company’s records.
Closing and Possession (a) Closing shall be held within 10 days after Seller’s abstracting obligations under this Agreement have been met at Xxxxxx Cooperative, of Ames, Iowa or at such other place as may be mutually agreed upon by Seller and Buyer.
PROMOTION AND TRANSFER 9:1 Employees may file requests, in writing, for promotion to the Working Xxxxxxx classification or for a Employees may file requests, in writing, for promotion to the Working Xxxxxxx classification or for a transfer to a new location in their present classification with the Office of the Company. Whenever a vacancy occurs, the Company will, before filling such vacancy, first give consideration to such requests and the following factors being sufficient give preference on the basis of seniority.
Certain Notifications Until Closing From the Signing Date until the Closing, the Company shall promptly notify the Investor of (i) any fact, event or circumstance of which it is aware and which would reasonably be expected to cause any representation or warranty of the Company contained in this Agreement to be untrue or inaccurate in any material respect or to cause any covenant or agreement of the Company contained in this Agreement not to be complied with or satisfied in any material respect and (ii) except as Previously Disclosed, any fact, circumstance, event, change, occurrence, condition or development of which the Company is aware and which, individually or in the aggregate, has had or would reasonably be expected to have a Company Material Adverse Effect; provided, however, that delivery of any notice pursuant to this Section 3.4 shall not limit or affect any rights of or remedies available to the Investor; provided, further, that a failure to comply with this Section 3.4 shall not constitute a breach of this Agreement or the failure of any condition set forth in Section 1.2 to be satisfied unless the underlying Company Material Adverse Effect or material breach would independently result in the failure of a condition set forth in Section 1.2 to be satisfied.
Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.
Compliance with Federal, State and Local Laws a. The Grantee and all its agents shall comply with all federal, state and local regulations, including, but not limited to, nondiscrimination, wages, social security, workers’ compensation, licenses, and registration requirements. The Grantee shall include this provision in all subcontracts issued as a result of this Agreement.
GAG AND EAG 4.1 The Secretary of State agrees to pay GAG and EAG to the Company in relation to the Academy in accordance with the Master Agreement.
Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. Purchaser may buck out cull material when necessary to produce pieces meeting Utilization Standards. Such bucked out material shall contain a minimum amount of sound wood, not in excess of the net scale in percentage of gross scale, or based on the merchantability factor, whichever is stated in A2. If necessary to assess extent of defect, Purchaser shall make sample saw cuts or wedges. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.
