Preferred implementation Sample Clauses

Preferred implementation. ‌ If the specified in this section models for the Pulser, Power Supply and Controller are used by the Supplier to implement the diode module, the CA will then provide reasonable assistance regarding the configuration and programming in LabVIEW of these devices, based on mutually agreed requirements. REQ-030016/A The Pulser used in the diode module shall be a commercially available off-the-shelf single 19-inch rack-mount device no more than 2U high with water-cooling and safety interlock, front-panel key enable and E-stop push button, and front-panel display with manual control option. It must have an Ethernet control interface and must be compatible with the CA’s LabVIEW-based control system. Within two weeks from the signature of this Contract, the Supplier shall communicate to the CA, what specific product intends to use to fulfil the requirements mentioned above. The Supplier may proceed with the manufacturing of the diode module only after such product is approved by the CA. The CA shall approve of the specific product only after the Supplier demonstrates to the CA that all the relevant requirements are met. REQ-030017/A Verification method: R – review The Power Supply used in the diode module shall be a commercially available off-the-shelf single 19-inch rack-mount device no more than 4U high with water-cooling and safety interlock, front-panel start and stop buttons, and a front-panel display with manual control option that can be disabled if remote control is used. It must have an Ethernet control interface and must be compatible with the CA’s LabVIEW-based control system. Within two weeks from the signature of this Contract, the Supplier shall communicate to the CA, what specific product intends to use to fulfil the requirements mentioned above. The Supplier may proceed with the manufacturing of the diode module only after such product is approved by the CA. The CA shall approve of the specific product only after the Supplier demonstrates to the CA that all the relevant requirements are met. REQ-030018/A Verification method: R – review The Controller shall perform all functions necessary for normal operation of the diode module that are not otherwise provided by other specifically labelled devices in Figure 3. The Controller shall be a commercially available off-the-shelf embedded controller with a real-time operating system and must include reliable FPGA-based processing of critical analog and digital signals. The Controller must have an Ethernet ...