Pre-Ordering 2.2.1 BellSouth will provide electronic access to its OSS and the information contained therein in order that OneTone can perform the following pre-ordering functions: service address validation, telephone number selection, service and feature availability, due date information, customer record information and loop makeup information. Mechanized access is provided by electronic interfaces whose specifications for access and use are set forth at BellSouth’s Interconnection Web site. The process by which BellSouth and OneTone will manage these electronic interfaces to include the development and introduction of new interfaces will be governed by the change management process as described in Section 2.7 below. OneTone shall provide to BellSouth access to customer record information, Version: 2Q05 Resale Agreement 07/21/05 including circuit numbers associated with each telephone number where applicable. OneTone shall provide such information within four (4) hours after request via electronic access where available. If electronic access is not available, OneTone shall provide to BellSouth paper copies of customer record information, including circuit numbers associated with each telephone number where applicable. If BellSouth requests the information before noon, the customer record information shall be provided the same day. If BellSouth requests the information after noon, the customer record information shall be provided by noon the following day. 2.2.2 The Parties agree not to view, copy, or otherwise obtain access to the customer record information of any customer without that customer's permission. OneTone will obtain access to customer record information only in strict compliance with applicable laws, rules, or regulations of the state in which the service is provided. BellSouth reserves the right to audit OneTone’s access to customer record information. If a BellSouth audit of OneTone’s access to customer record information reveals that OneTone is accessing customer record information without having obtained the proper End User authorization, BellSouth upon reasonable notice to OneTone may take corrective action, including but not limited to suspending or terminating OneTone’s electronic access to BellSouth’s OSS functionality. All such information obtained through an audit shall be deemed Information covered by Section 7, Proprietary and Confidential Information in General Terms and Conditions.
Ordering 7.4.1 When ordering LIS, the ordering Party shall specify requirements on the Access Service Request (ASR): 1) the type and number of Interconnection facilities to terminate at the Point of Interconnection in the Serving Wire Center; 2) the type of interoffice transport, (i.e., direct trunked transport or tandem switched transport); 3) the number of Ports to be provisioned at an End Office Switch or local Tandem Switch; and 4) any optional features. When the ordering Party requests facilities, routing, or optional features different than those determined to be available, the Parties will work cooperatively in determining an acceptable configuration, based on available facilities, equipment and routing plans. 7.4.2 For each NXX Code assigned to CLEC by the NANPA, CLEC will provide CenturyLink with the CLLI codes of the CenturyLink Tandem Switches and CLEC's Point of Interface to which traffic associated with the NXX will be routed. For NXX Codes assigned to existing LIS trunk groups, CLEC will also provide CenturyLink with the CenturyLink assigned two-six code (TGSN) to which each NXX will be routed. Information that is not currently available in the LERG may be provided via the NPA NXX Code Request Routing Form available on the CenturyLink web site: Either Party shall respond to a special request for a NPA NXX Code Request Routing Form when a single Switch is served by multiple trunk groups. 7.4.3 When either Party has ordered a DS3 Entrance Facility or private line facility, that Party will order the appropriate DS1 facility required and identify the channels of the DS3 to be used to provide connecting facility assignments (CFA). Also, if either Party has provided or ordered a DS1 Entrance Facility or private line facility, that Party will be responsible for identification of the DS0 channels of the DS1 private line to be used to provide CFA. 7.4.4 A joint planning meeting will precede initial trunking orders. These meetings will result in agreement and commitment that both Parties can implement the proposed plan and the transmittal of Access Service Requests (ASRs) to initiate order activity. The Parties will provide their best estimate of the traffic distribution to each End Office Switch subtending the Tandem Switch. 7.4.5 If CLEC uses a method of interconnection of one POI in the LATA or the access tandem for local traffic in accordance with Section 7.1.2 and/or 7.2.2.9.6, CenturyLink and CLEC will work together to review CLEC’s network configuration in order to ensure correct and complete ASR ordering. 7.4.6 Service intervals and Due Dates for initial establishment of trunking arrangements at each new Switch location of Interconnection between the Parties will be determined on an Individual Case Basis. 7.4.7 CenturyLink will establish intervals for the provision of LIS trunks that conform to the performance objectives set forth in Section 20. CenturyLink will provide notice to CLEC of any changes to the LIS trunk intervals consistent with the Change Management Process (CMP) applicable to the PCAT. Operational processes within CenturyLink work centers are discussed as part of the CMP. CenturyLink agrees that CLEC shall not be held to the requirements of the PCAT. 7.4.8 The ordering Party may cancel an order at any time prior to notification that service is available. If the ordering Party is unable to accept service within thirty (30) Days after the Service Date, the provider has the following options:
ORDERING PROCEDURES All task orders under OASIS SB must: 1. Be awarded by an OCO with a Delegation of Procurement Authority (DPA) or by a Contractor authorized to use the OASIS SB Contracts as a Government Source of Supply 2. Be within the scope of Section C and all other terms and conditions of the OASIS SBcontract 3. Be solicited and awarded under the proper NAICS Code and corresponding OASIS SB MA-IDIQ Contract Number (See Section H.4.) 4. Identify the proper Product Service Code (See Section H.5.) and, 5. Comply with the OASIS SB Contract, OASIS SB DPA Training, OASIS SB Ordering Guide, the Ordering Procedures in FAR Subpart 16.505, Ordering, and other applicable agency specific regulatorysupplements
Ordering Process 6.4.1 CLEC, or CLEC's agent, shall act as the single point of contact for its End User Customers' service needs, including without limitation, sales, service design, order taking, Provisioning, change orders, training, maintenance, trouble reports, repair, post-sale servicing, Billing, collection and inquiry. CLEC's End User Customers contacting Qwest in error will be instructed to contact CLEC; and Qwest's End User Customers contacting CLEC in error will be instructed to contact Qwest. In responding to calls, neither Party shall make disparaging remarks about each other. To the extent the correct provider can be determined, misdirected calls received by either Party will be referred to the proper provider of local Exchange Service; however, nothing in this Agreement shall be deemed to prohibit Qwest or CLEC from discussing its products and services with CLEC's or Qwest's End User Customers who call the other Party seeking such information. 6.4.2 CLEC shall transmit to Qwest all information necessary for the ordering (Billing, Directory Listing and other information), installation, repair, maintenance and post-installation servicing according to Qwest's standard procedures, as described in the Qwest Product Catalog (PCAT) available on Qwest's public web site located at xxxx://xxx.xxxxx.xxx/wholesale/pcat. Information shall be provided using Qwest's designated Local Service Request (LSR) format which may include the LSR, End User Customer and resale forms. 6.4.3 Qwest will use the same performance standards and criteria for installation, Provisioning, maintenance, and repair of services provided to CLEC for resale under this Agreement as Qwest provides to itself, its Affiliates, its subsidiaries, other Resellers, and Qwest retail End User Customers. The installation, Provisioning, maintenance, and repair processes for CLEC's resale service requests are detailed in the Access to OSS Section of this Agreement, and are applicable whether CLEC's resale service requests are submitted via Operational Support System or by facsimile. 6.4.4 CLEC is responsible for providing to Qwest complete and accurate End User Customer Directory Listing information including initial and updated information for Directory Assistance Service, white pages directories, and E911/911 Emergency Services. The Ancillary Services Section of this Agreement contains complete terms and conditions for Directory Listings for Directory Assistance Services, white pages directories, and E911/911 Emergency Services. 6.4.5 If Qwest's retail End User Customer, or the End User Customer's New Service Provider orders the discontinuance of the End User Customer's existing Qwest service in anticipation of the End User Customer moving to a New Service Provider, Qwest will render its closing xxxx to the End User Customer, discontinuing Billing as of the date of the discontinuance of Qwest's service to the End User Customer. If the Current Service Provider, or if the End User Customer's New Service Provider orders the discontinuance of existing resold service from the Current Service Provider, Qwest will xxxx the Current Service Provider for service through the date the End User Customer receives resold service from the Current Service Provider. Qwest will notify CLEC by Operational Support System interface, facsimile, or by other agreed-upon processes when an End User Customer moves from the Current Service Provider to a New Service Provider. Qwest will not provide the Current Service Provider with the name of the New Service Provider selected by the End User Customer. 6.4.6 CLEC shall provide Qwest and Qwest shall provide CLEC with points of contact for order entry, problem resolution and repair of the resold services. These points of contact will be identified for both CLEC and Qwest in the event special attention is required on a service request. 6.4.7 Prior to placing orders on behalf of the End User Customer, CLEC shall be responsible for obtaining and having in its possession Proof of Authorization (POA), as set forth in the POA Section of this Agreement. 6.4.8 Due Date intervals for CLEC's resale service requests are established when service requests are received by Qwest through Operational Support Systems or by facsimile. Intervals provided to CLEC shall be equivalent to intervals provided by Qwest to itself, its Affiliates, its subsidiaries, other Resellers, and to Qwest's retail End User Customers.
Timeliness of Submitting Orders You are obliged to date and indicate the time of receipt of all orders you receive from your customers and to transmit promptly all orders to us in time to provide for processing at the price next determined after receipt by you, in accordance with the Prospectuses. You are not to withhold placing with us orders received from any customers for the purchase of shares. You shall not purchase shares through us except for the purpose of covering purchase orders already received by you, or for your bona fide investment.
No Weapons or Firearms Except as provided by statute and District policy, all District properties are weapons- and firearms-free zones; Contractor is prohibited from possessing on its persons or in its vehicles any weapons or firearms while on District property.
Informal Resolution Outcomes a. When a complainant approaches an administrative officer and alleges harassment by another BCTF member, the following shall apply: i. All discussions shall be solely an attempt to mediate the complaint; ii. Any and all discussions shall be completely off the record and will not form part of any record; iii. Only the complainant, respondent, and administrative officer shall be present at such meetings iv. No discipline of any kind would be imposed on the respondent; and v. The BCTF and its locals, based on the foregoing, will not invoke the notice of investigation and other discipline provisions of the collective agreement at meetings pursuant to Article E.2.5.a. b. Should a resolution be reached between the complainant and the respondent at Step One under the circumstances of Article E.2.5.a, it shall be written up and signed by both. Only the complainant and the respondent shall have copies of the resolution and they shall be used only for the purpose of establishing that a resolution was reached. No other copies of the resolution shall be made. c. In the circumstances where a respondent has acknowledged responsibility pursuant to Article E.
METHOD OF ORDERING The County shall issue Delivery Orders against the contract on an as needed basis for the goods or services listed on the Bid Response Form.
Sale Order The Sale Order shall, among other things, (a) approve, pursuant to sections 105, 363 and 365 of the Bankruptcy Code, (i) the execution, delivery and performance by Sellers of this Agreement, (ii) the sale of the Acquired Assets to Buyer on the terms set forth herein and free and clear of all Encumbrances (other than Permitted Encumbrances), and (iii) the performance by Sellers of their obligations under this Agreement, (b) authorize and empower Sellers to assume and assign to Buyer the Transferred Contracts, (c) find that Buyer is a “good faith” purchaser within the meaning of section 363(m) of the Bankruptcy Code, find that Buyer is not a successor to any Seller, and grant Buyer the protections of section 363(m) of the Bankruptcy Code, (d) find that Buyer shall have no Liability or responsibility for any Liability or other obligation of any Seller arising under or related to the Acquired Assets other than as expressly set forth in this Agreement, including successor or vicarious Liabilities of any kind or character, including any theory of antitrust, environmental, successor, or transferee Liability, labor law, de facto merger, or substantial continuity, (e) find that Buyer has provided adequate assurance (as that term is used in section 365 of the Bankruptcy Code) of future performance in connection with the assumption of the Transferred Contracts, (f) find that Buyer shall have no Liability for any Excluded Liability, (g) find that the consideration provided by Buyer pursuant to this Agreement constitutes reasonably equivalent value and fair consideration for the Acquired Assets, (h) find that Buyer and Sellers did not engage in any conduct which would allow this Agreement to be set aside pursuant to section 363(n) of the Bankruptcy Code and (i) order that, notwithstanding the provisions of the Federal Rules of Bankruptcy Procedures 6004(h) and 6006(d), the Sale Order is not stayed and is effective immediately upon entry. Buyer agrees that it will promptly take such actions as are reasonably requested by any Seller to assist in obtaining Bankruptcy Court approval of the Sale Order, including furnishing affidavits or other documents or information for filing with the Bankruptcy Court for purposes, among others, of (A) demonstrating that Buyer is a “good faith” purchaser under section 363(m) of the Bankruptcy Code and (B) establishing adequate assurance of future performance within the meaning of section 365 of the Bankruptcy Code.
Solicitations for Subcontracts, Including Procurement of Materials and Equipment In all solicitations either by competitive bidding or negotiation made by the Local Government for work to be performed under a subcontract, including procurement of materials or leases of equipment, each potential subcontractor or supplier will be notified by the Local Government of the Local Government’s obligations under this Agreement and the Acts and Regulations relative to Nondiscrimination on the grounds of race, color, or national origin.
