Procuring In-Person Voting Equipment. The Board shall be responsible for the selection, procurement, management, and maintenance of all equipment and contracts necessary for the administration of in-person voting.
Procuring In-Person Voting Equipment Sample Clauses
Related to Procuring In-Person Voting Equipment
Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.
Metering Equipment 13.01. Utility will furnish, install, own and maintain metering equipment capable of measuring the flow of kilowatt-hours (kWh) of energy. The Customer's service associated with the CRG will be metered at a single metering point. The metering equipment will measure energy delivered by Utility to Customer and also measure energy delivered by Customer to Utility. Customer agrees to provide safe and reasonable access to the premises for installation of this equipment and its future maintenance or removal.
LOSS OF PERSONAL PROPERTY The board will not be responsible for any employee’s loss of personal property brought to a school or work site; however, in the event an employee’s personal property is lost or damaged as a direct result of a disaster, such as hurricane, fire, flood, etc., the board will reimburse the employee’s loss or damage in an amount not to exceed $500 per occurrence. In order for an employee to be eligible for such reimbursement, the personal property for which the employee makes a claim must have been pre-approved for use by the employee in connection with the employee’s duties, as evidenced by a written approval form signed by the employee’s principal or site supervisor and by the employee. In addition to the approval form, the employee must attach to the form proof of the property’s value, i.e. receipt, etc. The employee will be responsible for presenting a copy of the approval form in order to secure payment for loss. Payment will not be made unless the form is presented. The maximum amount an employee may receive for loss in any single occurrence is a total of $500, regardless of the amount or number of items approved for use in connection with the employee’s duties.
Initiating Interconnection 4.1 If ENT determines to offer Telephone Exchange Services and to interconnect with Verizon in any LATA in which Verizon also offers Telephone Exchange Services and in which the Parties are not already interconnected pursuant to this Agreement, ENT shall provide written notice to Verizon of the need to establish Interconnection in such LATA pursuant to this Agreement.
Removal of Personal Property All articles of personal property owned by Tenant or installed by Tenant at its expense in the Premises (including business and trade fixtures, furniture and movable partitions) shall be, and remain, the property of Tenant, and shall be removed by Tenant from the Premises, at Tenant's sole cost and expense, on or before the expiration or sooner termination of this Lease. Tenant shall repair any damage caused by such removal.
Protective Clothing & Equipment While not being part of any issue of protective clothing/equipment, the company shall be required to provide the following protective equipment (SAA approved) for use, when necessary, by employees during the performance of their required duties:
MEASURING EQUIPMENT 1. Seller will maintain and operate, at its own, expense and at the point of delivery of gas hereunder, a meter or meters and other necessary equipment by which the volume of gas delivered hereunder shall be measured. Such meters and equipment shall remain the property of the Seller.
Transfer of Title and Risk (a) The parties acknowledge that despite the receipt by the Merchant pursuant to this Agreement, title and risk in respect of the Produce shall only pass in accordance with subclause 2.3(b).
Watercraft Watercraft means any vessel, craft, vehicle or appliance made or intended to float on or in or travel on or through or under water.
Fittings & Fixtures Except those provided by the Promoter, all fitouts to be put-up, erected and installed at or inside the Designated Apartment including the interior decoration shall be done and completed by the Allottee at its own costs and expenses. In doing and carrying out the said fitout works, the Allottee shall be obliged to do all works in a good and xxxxxxx-like manner and without violating any laws, rules or regulations of the municipal, National Building Code and Fire rules and others and with minimum noise and without causing any disturbance or annoyance to the other Co-owners. The Allottee shall ensure that there shall be no stacking of debris or materials in any Common Areas and there shall be regular clearing of all debris arising out of the Fitout works. The Allottee hereby unequivocally and categorically undertakes not to drill, break, maim, hammer or in anyway damage or destroy the beams and columns on the floor, ceiling and walls of the Designated Apartment. The Allottee shall be responsible for all consequences, loss of life and property, damages or accidents that may occur due to breach or default on the part of the Allottee while carrying out any fitout or other activity.
