Additional Requirements for Sleeping Rooms The Contractor shall provide departing Attendees a secured area for storing belongings.
Requirements for Protection In compliance with NPCC requirements and Good Utility Practice, Developer shall provide, install, own, and maintain relays, circuit breakers and all other devices necessary to remove any fault contribution of the Large Generating Facility to any short circuit occurring on the New York State Transmission System not otherwise isolated by Connecting Transmission Owner’s equipment, such that the removal of the fault contribution shall be coordinated with the protective requirements of the New York State Transmission System. Such protective equipment shall include, without limitation, a disconnecting device or switch with load- interrupting capability located between the Large Generating Facility and the New York State Transmission System at a site selected upon mutual agreement (not to be unreasonably withheld, conditioned or delayed) of the Developer and Connecting Transmission Owner. Developer shall be responsible for protection of the Large Generating Facility and Developer’s other equipment from such conditions as negative sequence currents, over- or under-frequency, sudden load rejection, over- or under-voltage, and generator loss-of-field. Developer shall be solely responsible to disconnect the Large Generating Facility and Developer’s other equipment if conditions on the New York State Transmission System could adversely affect the Large Generating Facility.
Arrangements for Sales Arrangements for sales of Contract Securities will be made only through the Manager acting either directly or through Dealers (including Underwriters acting as Dealers), and you authorize the Manager to act on your behalf in making such arrangements. The aggregate number or amount of Securities to be purchased by the several Underwriters will be reduced by the respective number or amounts of Contract Securities attributed to such Underwriters as hereinafter provided. Subject to the provisions of Section 4.2 hereof, the aggregate number or amount of Contract Securities will be attributed to the Underwriters as nearly as practicable in proportion to their respective Underwriting Percentages, except that, as determined by the Manager in its discretion: (a) Contract Securities directed and allocated by a purchaser to specific Underwriters will be attributed to such Underwriters, and (b) Contract Securities for which arrangements have been made for sale through Dealers will be attributed to each Underwriter approximately in the proportion that Securities of such Underwriter held by the Manager for sales to Dealers bear to all Securities so held. The fee with respect to Contract Securities payable to the Manager for the accounts of the Underwriters pursuant to the Underwriting Agreement will be credited to the accounts of the respective Underwriters in proportion to the Contract Securities attributed to such Underwriters pursuant to the provisions of this Section 4.1, less, in the case of each Underwriter, the concession to Dealers on Contract Securities sold through Dealers and attributed to such Underwriter.
Requirements for E- Bidders 3.1. For Individual/ Joint E-Bidders, the following documents shall be uploaded during online registration; 3.1.1. Copy of Identification Documents (both sides) 3.1.2. Evidence of deposit payment 3.2. For Agent acting for Individual/ Joint Online Bidders, the following documents shall be uploaded during online registration; 3.2.1. Copy of Identification Documents (both sides) of Individual/ Joint Online Bidder 3.2.2. Copy of Identification Documents (both sides) of Agent 3.2.3. Copy of letter of authorization to bid 3.2.4. Evidence of deposit payment 3.3. For Company, the following documents shall be uploaded during online registration: 3.3.1. Copy of Identification Documents (both sides) of the representative. 3.3.2. Copy of letter of authorization to bid under the Company’s Letter Head 3.3.3. Form 24; Form 44; Form 49 (or their equivalent forms under the Companies Act 2016)
Requirements for Transfer (a) This Warrant and the Warrant Shares shall not be sold or transferred unless either (i) they first shall have been registered under the Securities Act of 1933, as amended (the "Act"), or (ii) the Company first shall have been furnished with an opinion of legal counsel, reasonably satisfactory to the Company, to the effect that such sale or transfer is exempt from the registration requirements of the Act. (b) Notwithstanding the foregoing, no registration or opinion of counsel shall be required for (i) a transfer by a Registered Holder which is a corporation to a wholly owned subsidiary, parent or affiliate of such corporation, a transfer by a Registered Holder which is a partnership to a partner of such partnership or a retired partner of such partnership or to the estate of any such partner or retired partner, or a transfer by a Registered Holder which is a limited liability company to a member of such limited liability company or a retired member or to the estate of any such member or retired member, provided that the transferee in each case agrees in writing to be subject to the terms of this Section 4, or (ii) a transfer made in accordance with Rule 144 under the Act. (c) Each certificate representing Warrant Shares shall bear a legend substantially in the following form: "The securities represented by this certificate have not been registered under the Securities Act of 1933, as amended, and may not be offered, sold or otherwise transferred, pledged or hypothecated unless and until such securities are registered under such Act or an opinion of counsel satisfactory to the Company is obtained to the effect that such registration is not required." The foregoing legend shall be removed from the certificates representing any Warrant Shares, at the request of the holder thereof, at such time as they become eligible for resale pursuant to Rule 144(k) under the Act.
Certain State Law Requirements for Contracts The contents of this Section are required by Texas Law and are included by County regardless of content. For purposes of Sections 2252.152, 2271.002, and 2274.002, Texas Government Code, as amended, C&T hereby verifies that C&T and any parent company, wholly owned subsidiary, majority-owned subsidiary, and affiliate: a. Unless affirmatively declared by the United States government to be excluded from its federal sanctions regime relating to Sudan or Iran or any federal sanctions regime relating to a foreign terrorist organization, is not identified on a list prepared and maintained by the Texas Comptroller of Public Accounts under Sections 806.051, 807.051, or 2252.153 of the Texas Government Code. b. If employing ten (10) or more full-time employees and this Agreement has a value of
Disbursements for Site Improvements All payments made by the OPWC for site improvements or other work shall be made directly to the Contractor that performed the work and originated the invoice, unless the request is for disbursement to the Recipient.
Audit Requirements for Recipients of State Financial Assistance For purposes of this paragraph, the word "Contractor" shall be deemed to mean "nonstate entity," as that term is defined in section 4-230 of the Connecticut General Statutes. The Contractor shall provide for an annual financial audit acceptable to the Client Agency for any expenditure of State awarded funds made by the Contractor. Such audit shall include management letters and audit recommendations. The State Auditors of Public Accounts shall have access to all records and accounts for the fiscal year(s) in which the award was made. The Contractor shall comply with federal and State single audit standards as applicable.
Solicitations for Subcontracts, Including Procurements of Materials and Equipment In all solicitations either by competitive bidding or negotiation made by the Engineer for work to be performed under a subcontract, including procurements of materials or leases of equipment, each potential subcontractor or supplier shall be notified by the Engineer of the Engineer's obligations under this contract and the Regulations relative to nondiscrimination on the grounds of race, color, or national origin.
Packing Materials and Containers for Shipment Packing materials and containers in which the good is packed for shipment shall be disregarded in determining whether-- (i) the non-originating materials used in the production of the good undergo an applicable change in tariff classification set out in subdivision (t) of this note; and (ii) the good satisfies a regional value-content requirement.
