Room Condition 2 Sample Clauses

Room Condition 2. 2.1 We will give you inventory of contents on the date you occupy your Room. You must check the inventory within five days and return it to the Accommodation Office within seven days. Failure to do so means you accept the inventory is accurate. The inventory will be checked on or immediately prior to the date on which you vacate the Room. 2.2.2 You accept the Accommodation and contents as being clean and in good condition, fit for the purpose. You are must keep them in good order and clean condition except for fair wear and tear (the inventory referred to in this Clause being evidence of the existing condition). 2.2.3 It is your responsibility to notify us as soon as possible of any defects, breakages in or repairs needed to the Room, the Flat Common Areas or the contents. If you fail to notify us you may be held liable for the cost in whole or in part of repairs when discovered by us.
AutoNDA by SimpleDocs

Related to Room Condition 2

  • Room Condition The university agrees to provide and the resident agrees to maintain the assigned room and all public areas in and around the immediate building(s) accessible to the resident in a clean, safe and sanitary condition. Upon termination of this agreement, the student should leave the assigned room, its furnishings, and its equipment in as good an order and condition as the same were upon commencement of the student’s occupancy, ordinary wear and tear excepted. University staff will complete an inventory of furnishings and an assessment of damages; charges will be assessed to the responsible individual(s). Personal property left in a room following the termination of occupancy will be deemed abandoned. Students will be charged for the removal of such property.

  • Termination Conditions This Agreement terminates upon the earlier of any of the following events: 18.1. Podmínky ukončení platnosti smlouvy Platnost této smlouvy skončí, jakmile nastane kterákoliv z následujících událostí:

  • BASIC CONDITIONS The State shall have no obligation to disburse money for the Project under this Grant Agreement until the Grantee has satisfied the following conditions:

  • WORK CONDITIONS The Contractor agrees to accept sole responsibility to comply with all federal, provincial and municipal legislation which may have application to the Work and agrees to comply with all provincial and federal legislation affecting conditions of work and wage rates including the Employment Standards Act R.S.P.E.I. 1988, Cap. E-6.2, the Workers Compensation Act R.S.P.E.I. 1988, Cap. W-7.1, or any other laws that impose obligations in the nature of employers’ obligations. The Contractor agrees to follow the Public Service Commission Human Resource Policies 9.05 Violence in the Workplace Policy; 9.08 Drug, Alcohol, and Medication Policy, and 11.01 Policy for the Prevention and Resolution of Harassment in the Workplace while working on Government sites, in Government vehicles or alongside Government staff. xxxxx://xxx.xxxx.xx/sites/xxx.xxxx.xx/files/HRPolicy/HRManual_9.05.pdf xxxxx://xxx.xxxx.xx/sites/xxx.xxxx.xx/files/9.08%20DrugAlcoholAndMedicationPolicy.pdf xxxxx://xxx.xxxx.xx/files/PDF%20Files/hrp-manual/hrppm_11.01.pdf The Contractor agrees to accept the full cost of doing those things required under this paragraph and will not charge or seek reimbursement from the Owner in any way, such costs having been taken into consideration and included in the rates of payment stipulated in this Agreement.

  • Space Conditions All pipes passing through floors, walls, and ceilings shall be installed with sufficient space between them to permit installation of pipe insulation and floor, wall, and ceiling plates without cutting of insulation or plates. Roughed-in dimensions shall be prepared by the Contractor to accomplish this requirement. The Contractor shall locate all equipment that must be serviced, operated, or maintained in fully accessible positions. This provision includes but is not limited to valves, traps, cleanouts, motors, controllers, switchgear, drain points, filter, access doors, and fire dampers. If spaces, dimensions, or other design conditions do not permit compliance with the present article, the Contractor shall file a request in writing with the Design Professional for additional instructions, furnishing a copy to the Owner.

  • PROJECT CONDITIONS A. The Grantee agrees to the following Project Conditions:

  • SUPERIOR CONDITIONS 21.01 All existing benefits, rights, privileges, practices, terms or conditions of employment which may be considered to be superior to those contained herein and which are set out in Appendix 4 are specifically retained by this Agreement unless otherwise agreed by the local parties. The parties agree to remove from Appendix 4 those superior conditions which no longer have application. Where the parties cannot agree on whether a superior condition continues to have application, the issue will be reduced to a grievance and referred to arbitration.

  • Release Conditions As used in this Agreement, "Release Conditions" shall mean the following:

  • Existing Conditions Tenant accepts the Property in its condition as of the execution of the Lease, subject to all recorded matters, laws, ordinances, and governmental regulations and orders. Except as provided herein, Tenant acknowledges that neither Landlord nor any agent of Landlord has made any representation as to the condition of the Property or the suitability of the Property for Tenant's intended use. Tenant represents and warrants that Tenant has made its own inspection of and inquiry regarding the condition of the Property and is not relying on any representations of Landlord or any Broker with respect thereto. If Landlord or Landlord's Broker has provided a Property Information Sheet or other Disclosure Statement regarding the Property, a copy is attached as an exhibit to the Lease.

  • Service Conditions Customer acknowledges that in the event of a service issue, Customer is responsible for on-site cooperative testing with LightEdge Technical Support to assist in the diagnosis of the trouble. Customer agrees to be bound to current terms of LightEdge Acceptable Use Policy. Terms of the Acceptable Use Policy are subject to change without notice. Current Acceptable Use Policy can be found here: xxxx://xxx.xxxxxxxxx.xxx/legal Customer agrees that any service complaints including concerns regarding level of support, products, service reliability, or any other concerns related to LightEdge or Services being provided by LIghtEdge will be communicated to LightEdge by sending an email to xx@xxxxxxxxx.xxx.

Time is Money Join Law Insider Premium to draft better contracts faster.