Common use of Salvaged Materials Clause in Contracts

Salvaged Materials. Subject to clause 8.21, unless expressly stated to the contrary in the Subcontract or directed by the Contractor’s Representative, all materials, plant, equipment, fixtures and other things salvaged from the Site or from the Subcontract Works are the property of the Subcontractor. Clause 8.26 does not apply unless the Subcontract Particulars state that it applies. The Subcontractor must provide the number of project signboards specified in the Subcontract Particulars, each of which must: be in the dimensions specified in the Subcontract Particulars; set out: the name of the project; the names of the parties to the Subcontract; the name of the Contractor’s Representative; a general description of the Subcontract Works; a contact name and phone number (including after hours number) for the principal contractor pursuant to the WHS Legislation; a contact name and phone number for the Subcontractor; the Date for Completion; the location of the Site office (if any); an 'Acknowledgement of Country' in accordance with the requirements set out in the website specified in the Subcontract Particulars; and any additional information: specified in the Subcontract Particulars; or required by the Contractor’s Representative. The Subcontractor must, within 14 days of the commencement of the Subcontractor’s Activities on Site, submit the proposed location, layout and content of the project signboards to the Contractor’s Representative for approval. Once approved by the Contractor’s Representative, the Subcontractor must: fix the project signboards in the locations approved by the Contractor’s Representative; maintain the project signboards until the last Date of Completion; and dismantle and remove the project signboards within 7 days of the last Date of Completion. Without limiting clause 8.14: the Subcontractor must obtain and check all relevant measurements and dimensions on Site before proceeding with the Subcontractor’s Activities; the layout of plant, equipment, ductwork, pipework and cabling shown in the Subcontract Works Description (if any) is to be taken as diagrammatic only and all measurements and dimension information concerning the Site required to carry out the Subcontractor’s Activities must be obtained and checked by the Subcontractor; and to the extent permitted by law, the Subcontractor will not be entitled to make (nor will the Contractor be liable upon) any Claim arising out of or in connection with the Subcontractor’s failure to obtain and check measurements and dimension information concerning the Site as required by clause 8.27.

Salvaged Materials. Subject to clause 8.216.8, unless expressly stated to the contrary in the Subcontract or directed by the Contractor’s 's Representative, all materials, plant, equipment, fixtures and other things salvaged from the Site or from the Subcontract Works are the property of the Subcontractor. Clause 8.26 6.11 does not apply unless the Subcontract Particulars state that it applies. The Subcontractor must provide the number of project signboards specified in the Subcontract Particulars, each of which must: be in the dimensions specified in the Subcontract Particulars; set out: the name of the project; the names of the parties to the Subcontract; the name of the Contractor’s 's Representative; a general description of the Subcontract Works; a contact name and phone number (including after hours number) for the principal contractor pursuant to the WHS Legislation; a contact name and phone number for the Subcontractor; the Date for Completion; the location of the Site office (if any); an 'Acknowledgement of Country' in accordance with the requirements set out in the website specified in the Subcontract Particulars; and any additional information: specified in the Subcontract Particulars; or required by the Contractor’s 's Representative. The Subcontractor must, within 14 days of the commencement of the Subcontractor’s 's Activities on Site, submit the proposed location, layout and content of the project signboards to the Contractor’s 's Representative for approval. Once approved by the Contractor’s 's Representative, the Subcontractor must: fix the project signboards in the locations approved by the Contractor’s 's Representative; maintain the project signboards until the last Date date of Completion; and dismantle and remove the project signboards within 7 days of the last Date date of Completion. Without limiting clause 8.14: the Subcontractor must obtain and check all relevant measurements and dimensions on Site before proceeding with the Subcontractor’s Activities; the layout of plant, equipment, ductwork, pipework and cabling shown in the Subcontract Works Description (if any) is to be taken as diagrammatic only and all measurements and dimension information concerning the Site required to carry out the Subcontractor’s Activities must be obtained and checked by the Subcontractor; and to the extent permitted by law, the Subcontractor will not be entitled to make (nor will the Contractor be liable upon) any Claim arising out of or in connection with the Subcontractor’s failure to obtain and check measurements and dimension information concerning the Site as required by clause 8.27.

Salvaged Materials. Subject to clause 8.216.9, unless expressly stated to the contrary in the Subcontract or directed by the Contractor’s 's Representative, all materials, plant, equipment, fixtures and other things salvaged from the Site or from the Subcontract Works are the property of the Subcontractor. Clause 8.26 does not apply unless If requested by the Subcontract Particulars state that it applies. The Contractor's Representative, the Subcontractor must provide the number of project signboards specified in the Subcontract Particulars, each of which must: be in the dimensions specified in the Subcontract Particulars; set out: the name of the project; the names of the parties to the Subcontract; the name of the Contractor’s 's Representative; a general description of the Subcontract Works; a contact name and phone number (including after hours number) for the principal contractor pursuant to the WHS Legislation; a contact name and phone number for the Subcontractor; the Date for Completion; the location of the Site office (if any); an 'Acknowledgement of Country' in accordance with the requirements set out in the website specified in the Subcontract Particulars; and any additional information: specified in the Subcontract Particulars; or required by the Contractor’s 's Representative. The Subcontractor must, within 14 days of the commencement of the Subcontractor’s 's Activities on Site, submit the proposed location, layout and content of the project signboards to the Contractor’s 's Representative for approval. Once approved by the Contractor’s 's Representative, the Subcontractor must: fix the project signboards in the locations approved by the Contractor’s 's Representative; maintain the project signboards until the last Date date of Completion; and dismantle and remove the project signboards within 7 days of the last Date date of Completion. Without limiting clause 8.14: the Subcontractor must obtain and check all relevant measurements and dimensions on Site before proceeding with the Subcontractor’s Activities; the layout of plant, equipment, ductwork, pipework and cabling shown in the Subcontract Works Description (if any) is to be taken as diagrammatic only and all measurements and dimension information concerning the Site required to carry out the Subcontractor’s Activities must be obtained and checked by the Subcontractor; and to the extent permitted by law, the Subcontractor will not be entitled to make (nor will the Contractor be liable upon) any Claim arising out of or in connection with the Subcontractor’s failure to obtain and check measurements and dimension information concerning the Site as required by clause 8.27.

Salvaged Materials. Subject to clause 8.216.9, unless expressly stated to the contrary in the Subcontract or directed by the Contractor’s 's Representative, all materials, plant, equipment, fixtures and other things salvaged from the Site or from the Subcontract Works are the property of the Subcontractor. Clause 8.26 does not apply unless If requested by the Subcontract Particulars state that it applies. The Contractor's Representative, the Subcontractor must provide the number of project signboards specified in the Subcontract Particulars, each of which must: be in the dimensions specified in the Subcontract Particulars; set out: the name of the project; the names of the parties to the Subcontract; the name of the Contractor’s 's Representative; a general description of the Subcontract Works; a contact name and phone number (including after hours numberhours) for the principal contractor pursuant to the WHS Legislation; a contact name and phone number for the Subcontractor; the Date for Completion; the location of the Site office (if any); an 'Acknowledgement of Country' in accordance with the requirements set out in the website and any other information specified in the Subcontract Particulars; and any additional information: specified in the Subcontract Particulars; or required by the Contractor’s Representative. The Subcontractor must, within 14 days of the commencement of the Subcontractor’s 's Activities on Site, submit the proposed location, layout and content of the project signboards to the Contractor’s 's Representative for approval. Once approved by the Contractor’s 's Representative, the Subcontractor must: fix the project signboards in the locations approved directed by the Contractor’s 's Representative; maintain the project signboards until the last Date date of Completion; and dismantle and remove the project signboards within 7 days of the last Date date of Completion. Without limiting clause 8.14: the Subcontractor must obtain and check all relevant measurements and dimensions on Site before proceeding with the Subcontractor’s Activities; the layout of plant, equipment, ductwork, pipework and cabling shown in the Subcontract Works Description (if any) is to be taken as diagrammatic only and all measurements and dimension information concerning the Site required to carry out the Subcontractor’s Activities must be obtained and checked by the Subcontractor; and to the extent permitted by law, the Subcontractor will not be entitled to make (nor will the Contractor be liable upon) any Claim arising out of or in connection with the Subcontractor’s failure to obtain and check measurements and dimension information concerning the Site as required by clause 8.27.

Salvaged Materials. Subject to clause 8.218.22, unless expressly stated to the contrary in the Subcontract or directed by the Contractor’s 's Representative, all materials, plant, equipment, fixtures and other things salvaged from the Site or from the Subcontract Works are the property of the Subcontractor. Clause 8.26 does not apply unless If requested by the Subcontract Particulars state that it applies. The Contractor's Representative, the Subcontractor must provide the number of project signboards specified in the Subcontract Particulars, each of which must: be in the dimensions specified in the Subcontract Particulars; set out: the name of the project; the names of the parties to the Subcontract; the name of the Contractor’s 's Representative; a general description of the Subcontract Works; a contact name and phone number (including after hours number) for the principal contractor pursuant to the WHS Legislation; a contact name and phone number for the Subcontractor; the Date for Completion; the location of the Site office (if any); an 'Acknowledgement of Country' in accordance with the requirements set out in the website and any other information specified in the Subcontract Particulars; and any additional information: specified in the Subcontract Particulars; or required by the Contractor’s Representative. The Subcontractor must, within 14 days of the commencement of the Subcontractor’s 's Activities on Site, submit the proposed location, layout and content of the project signboards to the Contractor’s 's Representative for approval. Once approved by the Contractor’s 's Representative, the Subcontractor must: fix the project signboards in the locations approved directed by the Contractor’s 's Representative; maintain the project signboards until the last Date of Completion; and dismantle and remove the project signboards within 7 days of the last Date of Completion. Without limiting clause 8.14: the Subcontractor must obtain and check all relevant measurements and dimensions on Site before proceeding with the Subcontractor’s 's Activities; the layout of plant, equipment, ductwork, pipework and cabling shown in the Subcontract Works Description (if any) is to be taken as diagrammatic only and all measurements and dimension information concerning the Site required to carry out the Subcontractor’s 's Activities must be obtained and checked by the Subcontractor; and to the extent permitted by law, the Subcontractor Contractor will not be entitled to make (nor will the Contractor be liable upon) upon any Claim arising out of or in connection with by the Subcontractor resulting from the Subcontractor’s 's failure to obtain and check measurements and dimension information concerning the Site as required by clause 8.27this clause.

Salvaged Materials. Subject to clause 8.218.22, unless expressly stated to the contrary in the Subcontract or directed by the Contractor’s Representative, all materials, plant, equipment, fixtures and other things salvaged from the Site or from the Subcontract Works are the property of the Subcontractor. Clause 8.26 does not apply unless If requested by the Subcontract Particulars state that it applies. The Contractor’s Representative, the Subcontractor must provide the number of project signboards specified in the Subcontract Particulars, each of which must: be in the dimensions specified in the Subcontract Particulars; set out: the name of the project; the names of the parties to the Subcontract; the name of the Contractor’s Representative; a general description of the Subcontract Works; a contact name and phone number (including after hours number) for the principal contractor pursuant to the WHS Legislation; a contact name and phone number for the Subcontractor; the Date for Completion; the location of the Site office (if any); an 'Acknowledgement of Country' in accordance with the requirements set out in the website specified in the Subcontract Particulars; and any additional information: specified in the Subcontract Particulars; or required by the Contractor’s Representative. The Subcontractor must, within 14 days of the commencement of the Subcontractor’s Activities on Site, submit the proposed location, layout and content of the project signboards to the Contractor’s Representative for approval. Once approved by the Contractor’s Representative, the Subcontractor must: fix the project signboards in the locations approved by the Contractor’s Representative; maintain the project signboards until the last Date of Completion; and dismantle and remove the project signboards within 7 days of the last Date of Completion. Without limiting clause 8.14: the Subcontractor must obtain and check all relevant measurements and dimensions on Site before proceeding with the Subcontractor’s Activities; the layout of plant, equipment, ductwork, pipework and cabling shown in the Subcontract Works Description (if any) is to be taken as diagrammatic only and all measurements and dimension information concerning the Site required to carry out the Subcontractor’s Activities must be obtained and checked by the Subcontractor; and to the extent permitted by law, the Subcontractor will not be entitled to make (nor will the Contractor be liable upon) any Claim arising out of or in connection with the Subcontractor’s failure to obtain and check measurements and dimension information concerning the Site as required by clause 8.278.28.