Common use of Section width Clause in Contracts

Section width. 7.1.1.1. The section width shall be calculated by the following formula: S = S1 + K (A - A1) where: S : is the actual section width in millimetres as measured on the test rim; S1: is the value of the 'Design Section Width', referred to the measuring rim, as quoted in the International Tyre Standard specified by the retreader for the tyre size in question; A : is the width of the test rim in millimetres; A1: is the width in millimetres of the measuring rim as quoted in the International Tyre Standard specified by the retreader for the tyre size in question; K : is a factor and shall be taken to equal 0.4. 7.1.1.1.1 In the case of tyres identified by the tyre to rim fitment configuration symbol "A" (see paragraph 2.21.4.) the factor "K" shall be 0.6.

Section width. 7.1.1.1. The section width shall be calculated by the following formula: S = S1 + K (A - A1) where: S : is the actual section width in millimetres as rounded to the nearest millimetre and measured on the test rim; S1: is the value of the 'Design Section Width', referred to the measuring rim, as quoted in the International Tyre Standard specified by the retreader for the tyre size in question; A : is the width of the test rim in millimetres; A1: is the width in millimetres of the measuring rim as quoted in the International Tyre Standard specified by the retreader for the tyre size in question; K : is a factor and shall be taken to equal 0.4. 7.1.1.1.1 7.1.1.1.1. In the case of tyres identified by the tyre to rim fitment configuration symbol "A" (see paragraph 2.21.42.26.4.1.) the factor "K" shall be 0.6.

Section width. 7.1.1.1. The section width shall be calculated by the following formula: S = S1 + K (A - A1) where: S : is the actual section width in millimetres as measured on the test rim; S1: is the value of the 'Design Section Width', referred to the measuring rim, as quoted in the International Tyre Standard specified by the retreader for the tyre size in question; A : is the width of the test rim in millimetres; A1: is the width in millimetres of the measuring rim as quoted in the International Tyre Standard specified by the retreader for the tyre size in question; K . K: is a factor and shall be taken to equal 0.4. 7.1.1.1.1 In the case of tyres identified by the tyre to rim fitment configuration symbol "A" (see paragraph 2.21.4.) the factor "K" shall be 0.6.

Section width. 7.1.1.1. The section width shall be calculated by the following formula: S = S1 + K (A - A1) where: S : is the actual section width in millimetres as rounded to the nearest millimetre and measured on the test rim; S1: is the value of the 'Design Section Width', referred to the measuring rim, as quoted in the International Tyre Standard specified by the retreader for the tyre size in question; A : is the width of the test rim in millimetres; A1: is the width in millimetres of the measuring rim as quoted in the International Tyre Standard specified by the retreader for the tyre size in question; K : is a factor and shall be taken to equal 0.4. 7.1.1.1.1 7.1.1.1.1. In the case of tyres identified by the tyre to rim fitment configuration symbol "A" (see paragraph 2.21.42.26.4.1.) the factor "K" shall be 0.6.