Your General Obligations 6.1 Full information You must give us any information we reasonably require for the purposes of this contract. The information must be correct, and you must not mislead or deceive us in relation to any information provided to us. 6.2 Updating information You must tell us promptly if information you have provided to us changes, including if your billing address changes or if your use of energy changes (for example, if you start running a business at the premises).
State of California Public Liability and Workers’ Compensation Program A. The Judicial Council has elected to be self-insured for its motor vehicle, aircraft liability and general liability exposures. B. The Judicial Council administers workers’ compensation benefits for its employees through a Third Party agreement.
Maintenance of PMI Policy; Claims With respect to each Mortgage Loan with a loan-to-value ratio in excess of 80% for which a PMI Policy is both required and has been issued, the Servicer shall, to the extent permitted by Accepted Servicing Practices, maintain or cause the Mortgagor to maintain in full force and effect a PMI Policy insuring that portion of the Mortgage Loan in excess of 75% of value, and shall cause the Mortgagor to pay the premium thereon on a timely basis, until the loan-to-value ratio of such Mortgage Loan is reduced to 80% or PMI can otherwise no longer be mandated pursuant to applicable law. In the event that such PMI Policy shall be terminated, the Servicer shall attempt to obtain from another Qualified Insurer a comparable replacement policy, with a total coverage equal to the remaining coverage of such terminated PMI Policy. The Servicer shall not take any action which would result in noncoverage under any applicable PMI Policy of any loss which, but for the actions of the Servicer would have been covered thereunder. In connection with any assumption or substitution agreement entered into or to be entered into pursuant to this Agreement, the Servicer shall promptly notify the insurer under the related PMI Policy, if any, of such assumption or substitution of liability in accordance with the terms of such PMI Policy and shall take all actions which may be required by such insurer as a condition to the continuation of coverage under such PMI Policy. If such PMI Policy is terminated as a result of such assumption or substitution of liability, the Servicer shall obtain a replacement PMI Policy as provided above. With respect to each Mortgage Loan covered by a PMI Policy or LPMI Policy, the Servicer shall take all such actions on behalf of the Owner as are necessary to service, maintain and administer the related Mortgage Loan in accordance with such Policy and to enforce the rights under such Policy. Except as expressly set forth herein, the Servicer shall have full authority on behalf of the Owner to do anything it deems appropriate or desirable in connection with the servicing, maintenance and administration of such Policy; provided that the Servicer shall not take any action to permit any modification or assumption of a Mortgage Loan covered by a LPMI or PMI Policy, or take any other action with respect to such Mortgage Loan, which would result in non-coverage under such Policy of any loss which, but for actions of the Servicer, would have been covered thereunder. The Servicer shall cooperate with the PMI insurers and shall furnish all reasonable evidence and information in the possession of the Servicer to which the Servicer has access with respect to the related Mortgage Loan. The Servicer agrees to prepare and present, on behalf of itself and the Owner, claims to the insurer under any PMI Policy or LPMI Policy in a timely fashion in accordance with the terms of such PMI Policy or LPMI Policy and, in this regard, to take such action as shall be necessary to permit recovery under any PMI Policy or LPMI Policy respecting a defaulted Mortgage Loan. Pursuant to Section 3.04, any amounts collected by the Servicer under any PMI Policy or LPMI Policy shall be deposited in the Collection Account, subject to withdrawal pursuant to Section 3.05.
Limitation on Out-of-State Litigation - Texas Business and Commerce Code § 272 This is a requirement of the TIPS Contract and is non-negotiable. Texas Business and Commerce Code § 272 prohibits a construction contract, or an agreement collateral to or affecting the construction contract, from containing a provision making the contract or agreement, or any conflict arising under the contract or agreement, subject to another state’s law, litigation in the courts of another state, or arbitration in another state. If included in Texas construction contracts, such provisions are voidable by a party obligated by the contract or agreement to perform the work. By submission of this proposal, Vendor acknowledges this law and if Vendor enters into a construction contract with a Texas TIPS Member under this procurement, Vendor certifies compliance.
Laws Applicable to Construction The interpretation, performance and enforcement of this Agreement shall be governed by the laws of the State of Delaware as applied to contracts executed in and performed wholly within the State of Delaware, without reference to principles of conflict of laws.
New Hampshire Specific Data Security Requirements The Provider agrees to the following privacy and security standards from “the Minimum Standards for Privacy and Security of Student and Employee Data” from the New Hampshire Department of Education. Specifically, the Provider agrees to: (1) Limit system access to the types of transactions and functions that authorized users, such as students, parents, and LEA are permitted to execute; (2) Limit unsuccessful logon attempts; (3) Employ cryptographic mechanisms to protect the confidentiality of remote access sessions; (4) Authorize wireless access prior to allowing such connections; (5) Create and retain system audit logs and records to the extent needed to enable the monitoring, analysis, investigation, and reporting of unlawful or unauthorized system activity; (6) Ensure that the actions of individual system users can be uniquely traced to those users so they can be held accountable for their actions; (7) Establish and maintain baseline configurations and inventories of organizational systems (including hardware, software, firmware, and documentation) throughout the respective system development life cycles; (8) Restrict, disable, or prevent the use of nonessential programs, functions, ports, protocols, and services; (9) Enforce a minimum password complexity and change of characters when new passwords are created; (10) Perform maintenance on organizational systems; (11) Provide controls on the tools, techniques, mechanisms, and personnel used to conduct system maintenance; (12) Ensure equipment removed for off-site maintenance is sanitized of any Student Data in accordance with NIST SP 800-88 Revision 1; (13) Protect (i.e., physically control and securely store) system media containing Student Data, both paper and digital; (14) Sanitize or destroy system media containing Student Data in accordance with NIST SP 800-88 Revision 1 before disposal or release for reuse; (15) Control access to media containing Student Data and maintain accountability for media during transport outside of controlled areas; (16) Periodically assess the security controls in organizational systems to determine if the controls are effective in their application and develop and implement plans of action designed to correct deficiencies and reduce or eliminate vulnerabilities in organizational systems; (17) Monitor, control, and protect communications (i.e., information transmitted or received by organizational systems) at the external boundaries and key internal boundaries of organizational systems; (18) Deny network communications traffic by default and allow network communications traffic by exception (i.e., deny all, permit by exception); (19) Protect the confidentiality of Student Data at rest; (20) Identify, report, and correct system flaws in a timely manner; (21) Provide protection from malicious code (i.e. Antivirus and Antimalware) at designated locations within organizational systems; (22) Monitor system security alerts and advisories and take action in response; and (23) Update malicious code protection mechanisms when new releases are available.
Maintenance of PMI Policy and/or LPMI Policy; Claims The Servicer shall comply with all provisions of applicable state and federal law relating to the cancellation of, or collection of premiums with respect to, PMI Policies, including, but not limited to, the provisions of the Homeowners Protection Act of 1998, and all regulations promulgated thereunder, as amended from time to time. With respect to each Mortgage Loan (other than LPMI Loans) with a loan to value ratio at origination in excess of 80%, the Servicer shall maintain or cause the Mortgagor to maintain (to the extent that the Mortgage Loan requires the Mortgagor to maintain such insurance) in full force and effect a PMI Policy, and shall pay or shall cause the Mortgagor to pay the premium thereon on a timely basis, until the LTV of such Mortgage Loan is reduced to 80%. In the event that such PMI Policy shall be terminated, the Servicer shall obtain from another Qualified Insurer a comparable replacement policy, with a total coverage equal to the remaining coverage of such terminated PMI Policy, at substantially the same fee level. The Servicer shall not take any action which would result in noncoverage under any applicable PMI Policy of any loss which, but for the actions of the Servicer would have been covered thereunder. In connection with any assumption or substitution agreements entered into or to be entered into with respect to a Mortgage Loan, the Servicer shall promptly notify the insurer under the related PMI Policy, if any, of such assumption or substitution of liability in accordance with the terms of such PMI Policy and shall take all actions which may be required by such insurer as a condition to the continuation of coverage under such PMI Policy. If such PMI Policy is terminated as a result of such assumption or substitution of liability, the Servicer shall obtain a replacement PMI Policy as provided above. The Servicer shall take all such actions as are necessary to service, maintain and administer the LPMI Loans in accordance with the LPMI Policy and to perform and enforce the rights of the insured under such LPMI Policy. Except as expressly set forth herein, the Servicer shall have full authority on behalf of the Trust Fund to do anything it reasonably deems appropriate or desirable in connection with the servicing, maintenance and administration of the LPMI Policy. The Servicer shall not modify or assume a Mortgage Loan covered by the LPMI Policy or take any other action with respect to such Mortgage Loan which would result in non-coverage under the LPMI Policy of any loss which, but for the actions of the Servicer, would have been covered thereunder. If the LPMI Insurer fails to pay a claim under the LPMI Policy as a result of breach by the Servicer of its obligations hereunder or under the LPMI Policy, the Servicer shall be required to deposit in the Custodial Account on or prior to the next succeeding Remittance Date an amount equal to such unpaid claim from its own funds without any right to reimbursement from the Trust Fund. The Servicer shall cooperate with the LPMI Insurer and the Master Servicer and shall use its best efforts to furnish all reasonable aid, evidence and information in the possession of the Servicer to which the Servicer has access with respect to any LPMI Loan; provided, however, notwithstanding anything to the contrary contained in any LPMI Policy, the Servicer shall not be required to submit any reports to the LPMI Insurer until a reporting date that is at least 15 days after the Servicer has received sufficient loan level information from the Seller, the Master Servicer or the LPMI Insurer to appropriately code its servicing system in accordance with the LPMI Insurer’s requirements. In connection with its activities as servicer, the Servicer agrees to prepare and present, on behalf of itself and the Trustee, claims to the insurer under any PMI Policy or LPMI Policy in a timely fashion in accordance with the terms of such PMI Policy or LPMI Policy and, in this regard, to take such action as shall be necessary to permit recovery under any PMI Policy or LPMI Policy respecting a defaulted Mortgage Loan. Any amounts collected by the Servicer under any PMI Policy or LPMI Policy shall be deposited in the Custodial Account, subject to withdrawal pursuant to Section 3.04.
Manner of Conveyance; Limited Warranty; Nonrecourse; Etc THE CONVEYANCE OF ALL ASSETS, INCLUDING REAL AND PERSONAL PROPERTY INTERESTS, PURCHASED BY THE ASSUMING INSTITUTION UNDER THIS AGREEMENT SHALL BE MADE, AS NECESSARY, BY RECEIVER'S DEED OR RECEIVER'S XXXX OF SALE, "AS IS", "WHERE IS", WITHOUT RECOURSE AND, EXCEPT AS OTHERWISE SPECIFICALLY PROVIDED IN THIS AGREEMENT, WITHOUT ANY WARRANTIES WHATSOEVER WITH RESPECT TO SUCH ASSETS, EXPRESS OR IMPLIED, WITH RESPECT TO TITLE, ENFORCEABILITY, COLLECTIBILITY, DOCUMENTATION OR FREEDOM FROM LIENS OR ENCUMBRANCES (IN WHOLE OR IN PART), OR ANY OTHER MATTERS.
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “ (1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “ (1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
General Obligations 1. Each Party shall apply its measures relating to the provisions of this Chapter in accordance with Article 116 (General Principles) and, in particular, shall expeditiously apply those measures so as to avoid unduly impairing or delaying trade in goods or services or conduct of investment activities under this Agreement. 2. Nothing in this Chapter shall be construed to prevent a Party from applying measures to regulate the entry of natural persons into, or their temporary stay in, its territory, including those measures necessary to protect the integrity of, and to ensure the orderly movement of natural persons across, its borders, provided that such measures are not applied in such a manner as to unduly impair or delay trade in goods or services or conduct of investment activities under this Agreement.
