Accessibility of Web-Based Information and Applications For State Agency Authorized User Acquisitions: Any web-based information and applications development, or programming delivered pursuant to the contract or procurement, will comply with New York State Enterprise IT Policy NYS-P08-005, Accessibility of Web-Based Information and Applications as follows: Any web-based information and applications development, or programming delivered pursuant to the contract or procurement, will comply with New York State Enterprise IT Policy NYS-P08- 005, Accessibility of Web-Based Information and Applications as such policy may be amended, modified or superseded, which requires that state agency web-based information and applications are accessible to persons with disabilities. Web-based information and applications must conform to New York State Enterprise IT Policy NYS-P08-005 as determined by quality assurance testing. Such quality assurance testing will be conducted by the State Agency Authorized User and the results of such testing must be satisfactory to the Authorized User before web-based information and applications will be considered a qualified deliverable under the contract or procurement.
Information Technology Accessibility Standards Any information technology related products or services purchased, used or maintained through this Grant must be compatible with the principles and goals contained in the Electronic and Information Technology Accessibility Standards adopted by the Architectural and Transportation Barriers Compliance Board under Section 508 of the federal Rehabilitation Act of 1973 (29 U.S.C. §794d), as amended. The federal Electronic and Information Technology Accessibility Standards can be found at: xxxx://xxx.xxxxxx-xxxxx.xxx/508.htm.
Access Toll Connecting Trunk Group Architecture 9.2.1 If CBB chooses to subtend a Verizon access Tandem, CBB’s NPA/NXX must be assigned by CBB to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG.
Infrastructure Vulnerability Scanning Supplier will scan its internal environments (e.g., servers, network devices, etc.) related to Deliverables monthly and external environments related to Deliverables weekly. Supplier will have a defined process to address any findings but will ensure that any high-risk vulnerabilities are addressed within 30 days.
Technical Requirements for SCPs/Databases 10.5.3.1 BellSouth shall provide physical access to SCPs through the SS7 network and protocols with TCAP as the application layer protocol.
Access to Network Interface Device (NID 2.4.3.1. Due to the wide variety of NIDs utilized by BellSouth (based on subscriber size and environmental considerations), Mpower may access the on-premises wiring by any of the following means: BellSouth shall allow Mpower to connect its loops directly to BellSouth’s multi-line residential NID enclosures that have additional space and are not used by BellSouth or any other telecommunications carriers to provide service to the premise. Mpower agrees to install compatible protectors and test jacks and to maintain the protection system and equipment and to indemnify BellSouth pursuant to Section 8 of the General Terms and Conditions of this Agreement.
Accessibility Supplier warrants that all Products will meet the requirements set forth in all federal, state, local and foreign laws, rules, and regulations applicable to accessibility of information technology for people with disabilities. Supplier agrees to use personnel trained and knowledgeable in supporting the needs of persons with disabilities in performance of Services under this Order.
Technical Standards Applicable to a Wind Generating Plant i. Low Voltage Ride-Through (LVRT) Capability A wind generating plant shall be able to remain online during voltage disturbances up to the time periods and associated voltage levels set forth in the standard below. The LVRT standard provides for a transition period standard and a post-transition period standard.
ROAD TOLERANCES Purchaser shall perform road work within the tolerances listed below. The tolerance class for each road is listed on the TYPICAL SECTION SHEET. Tolerance Class A B C Road and Subgrade Width (feet) +1.5 +1.5 +2.0 Subgrade Elevation (feet +/-) 0.5 1.0 2.0 Centerline alignment (feet lt./rt.) 1.0 1.5 3.0 1-6 ORDER OF PRECEDENCE Any conflict or inconsistency in the road plan will be resolved by giving the documents precedence in the following order:
Accessibility of Information Technology Contractor represents and warrants that any software/ hardware/ communications system/ equipment (collectively “technology”), if any, provided under this Agreement adheres to the standards and/or specifications as may be set forth in the Section 508 of the Rehabilitation Act of 1973 standards guide and is fully compliant with WCAG 2.0 AA standards for accessibility and compliant with any applicable FCC regulations. Technology that will be used on a mobile device must also be navigable with Voiceover on iOS devices in addition to meeting WCAG 2.0 level AA. If portions of the technology or user experience are alleged to be non-compliant or non- accessible at any point, District will provide Contractor with notice of such allegation and Contractor shall use its best efforts to make the technology compliant and accessible. If a state or federal department, office or regulatory agency, or if any other third party administrative agency or organization (“Claimants”), make a claim, allegation, initiates legal or regulatory process, or if a court finds or otherwise determines that technology is non-compliant or non-accessible, Contractor shall indemnify, defend and hold harmless the District from and against any and all such claims, allegations, liabilities, damages, penalties, fees, costs (including but not limited to reasonable attorneys’ fees), arising out of or related to Xxxxxxxxx’ claims. Contractor shall also fully indemnify District for the full cost of any user accommodation that is found to be necessary due to an identifiable lack of accessibility in the Contractor’s technology. If necessary, an independent 3rd party accessibility firm using POUR standards (Perceivable, Operable, Understandable and Robust) may be used to validate the accessibility of the technology.
