Contract Modifications It is understood that changes are inherent in operations of the type covered by this contract. The number of changes, the scope of those changes, and the impact they have on the progress of the original operations cannot be defined at this time. The PURCHASER is notified that changes are anticipated and that there will be no compensation made to the PURCHASER directly related to the number of changes made. Each change will be evaluated for extension of contract time and increase or decrease in compensation based on its own merit. STATE reserves the right to make, at any time during the contract, such modifications as are necessary or desirable; provided such modifications shall not change the character of the operations to be done nor increase the cost, unless such operations or cost increase is approved in writing by PURCHASER. Any modifications so made shall not invalidate this contract nor release PURCHASER of obligations under the performance bond. PURCHASER agrees to do the modified operations as if it had been a part of the original contract. If any change under this section causes an increase or decrease in the PURCHASER's cost of, or the time required for the performance of any part of the operations, the PURCHASER must submit a written statement setting forth the nature and specific extent of the claim. Such claim shall include all time and cost impacts against the contract and be submitted as soon as possible, but no later than 30 days after receipt of any written notice of modification of the contract. If the PURCHASER discovers site conditions which differ materially from what was represented in the contract or from conditions that would normally be expected to exist and be inherent to the activities defined in the contract, the PURCHASER shall notify the STATE's Authorized Representative immediately and before the area has been disturbed. The STATE's Authorized Representative will investigate the area and make a determination as to whether or not the conditions differ materially from either the conditions stated in the contract or those which could reasonably be expected in execution of this particular contract. If it is determined that a differing site condition exists, any compensation or credit will be determined based on an analysis by STATE's Authorized Representative. If the PURCHASER does not concur with the decision of the STATE's Authorized Representative and/or believes that it is entitled to additional compensation, the PURCHASER may proceed to file a claim. All claims shall be submitted in writing and shall include a detailed, factual statement of the basis of the claim, pertinent dates, contract provisions which support or allow the claim, reference to or copies of any documents which support the claim, the exact dollar value of the claim, and specific time extension requested for the claim. If the claim involves operations to be completed by subcontractors, the PURCHASER will analyze and evaluate the merits of the subcontractor's claim. PURCHASER shall forward the subcontractor's claim and PURCHASER's evaluation of such claim to STATE's Authorized Representative. The STATE's Authorized Representative will not consider direct claims from subcontractors, suppliers, manufacturers, or others not a party to this contract. The decision of the STATE shall be final and binding unless the PURCHASER requests mediation.
Withdrawal, Substitution, and Modification of Tenders 23.1 A Tenderer may withdraw, substitute, or modify its Tender after it has been submitted by sending a written notice, duly signed by an authorized representative, and shall include a copy of the authorization (the power of attorney) in accordance with ITT19.3, (except that withdrawal notices do not require copies). The corresponding substitution or modification of the Tender must accompany the respective written notice. All notices must be: a) prepared and submitted in accordance with ITT 20 and 21 (except that withdrawal notices do not require copies), and in addition, the respective envelopes shall be clearly marked “WITHDRAWAL,” “SUBSTITUTION,” or “MODIFICATION;” and b) received by the Procuring Entity prior to the deadline prescribed for submission of Xxxxxxx, in accordance with ITT 22. 23.3 Tenders requested to be withdrawn in accordance with ITT 23.1 shall be returned unopened to the Tenderers. 23.4 No Tender may be withdrawn, substituted, or modified in the interval between the deadline for submission of Tenders and the expiration of the period of Tender validity specified by the Tenderer on the Form of Tender or any extension thereof.
Cost Modifications The parties may agree to a reduction in the cost of the Contract at any time during which the Contract is in effect. Without intending to impose a limitation on the nature of the reduction, the reduction may be to hourly, staffing or unit costs, the total cost of the Contract or the reduction may take such other form as the State deems to be necessary or appropriate.
Contractor Changes The Contractor shall notify DAS in writing no later than ten (10) Days from the effective date of any change in: a. its certificate of incorporation or other organizational document; b. more than a controlling interest in the ownership of the Contractor; or c. the individual(s) in charge of the Performance. This change shall not relieve the Contractor of any responsibility for the accuracy and completeness of the Performance. DAS, after receiving written notice by the Contractor of any such change, may require such agreements, releases and other instruments evidencing, to DAS’s satisfaction, that any individuals retiring or otherwise separating from the Contractor have been compensated in full or that provision has been made for compensation in full, for all work performed under terms of the Contract. The Contractor shall deliver such documents to DAS in accordance with the terms of DAS’s written request. DAS may also require, and the Contractor shall deliver, a financial statement showing that solvency of the Contractor is maintained. The death of any Contractor Party, as applicable, shall not release the Contractor from the obligation to Perform under the Contract; the surviving Contractor Parties, as appropriate, must continue to Perform under the Contract until Performance is fully completed.
Waiver and Modifications Any Party may (a) waive, in whole or in part, any inaccuracy of, or consent to the modification of, any representation or warranty made to it hereunder or in any document to be delivered pursuant hereto, (b) extend the time for the performance of any of the obligations or acts of the other Parties (c) waive or consent to the modification of any of the covenants herein contained for its benefit or waive or consent to the modification of any of the obligations of the other Parties hereto or (d) waive the fulfillment of any condition to its own obligations contained herein. No waiver or consent to the modifications of any of the provisions of this Agreement will be effective or binding unless made in writing and signed by the Party or Parties purporting to give the same and, unless otherwise provided, will be limited to the specific breach or condition waived. The rights and remedies of the Parties hereunder are cumulative and are in addition to, and not in substitution for, any other rights and remedies available at law or in equity or otherwise. No single or partial exercise by a Party of any right or remedy precludes or otherwise affects any further exercise of such right or remedy or the exercise of any other right or remedy to which that Party may be entitled. No waiver or partial waiver of any nature, in any one or more instances, will be deemed or construed a continued waiver of any condition or breach of any other term, representation or warranty in this Agreement.
Mortgage Status; Waivers and Modifications Since origination and except by written instruments set forth in the related Mortgage File or as otherwise provided in the related Mortgage Loan documents (a) the material terms of such Mortgage, Mortgage Note, Mortgage Loan guaranty and related Mortgage Loan documents have not been waived, impaired, modified, altered, satisfied, canceled, subordinated or rescinded in any respect which materially interferes with the security intended to be provided by such mortgage; (b) no related Mortgaged Property or any portion thereof has been released from the lien of the related Mortgage in any manner which materially interferes with the security intended to be provided by such Mortgage or the use or operation of the remaining portion of such Mortgaged Property; and (c) neither the Mortgagor nor the guarantor has been released from its material obligations under the Mortgage Loan. With respect to each Mortgage Loan, except as contained in a written document included in the Mortgage File, there have been no modifications, amendments or waivers, that could be reasonably expected to have a material adverse effect on such Mortgage Loan consented to by the Mortgage Loan Seller on or after the Cut-off Date.
Alterations, Modifications and Additions Company will, or will cause a Permitted Lessee to, make (or cause to be made) such alterations and modifications in and additions to the Airframe and the Engines as are required from time to time to meet the applicable requirements of the FAA or any applicable government of any other jurisdiction in which the Aircraft is then registered; except for (i) immaterial and non-recurring violations with respect to which corrective measures are being taken promptly by Company (or, if a Lease is then in effect, any Permitted Lessee) upon discovery thereof and (ii) any law, rule, regulation or order the validity or application of which is being contested in good faith by Company (or, if a Lease is then in effect, any Permitted Lessee) in any manner which does not involve any material risk of sale, loss or forfeiture of the Aircraft and does not materially adversely affect Loan Trustee’s interest in the Aircraft. In addition, Company (or any Permitted Lessee), at its own expense, may from time to time add further parts or accessories and make or cause to be made such alterations and modifications in and additions to the Airframe or any Engine as Company (or any Permitted Lessee) deems desirable in the proper conduct of its business, including, without limitation, removal (without replacement) of Parts; provided that no such alteration, modification or addition shall materially diminish the value or utility of the Airframe or such Engine below its value or utility immediately prior to such alteration, modification or addition, assuming that the Airframe or such Engine was then in the condition required to be maintained by the terms of this Indenture, except that the value (but not the utility) of the Airframe or any Engine may be reduced by the value of any such Parts that are removed that Company (or such Permitted Lessee) deems obsolete or no longer suitable or appropriate for use on the Airframe or any Engine. For the avoidance of doubt, Company may make alterations in the passenger configuration of the Aircraft and such alterations shall not be subject to the immediately preceding sentence. All Parts incorporated or installed in or attached or added to the Airframe or any Engine as the result of such alteration, modification or addition shall, without further act, be subject to the Lien of this Indenture. Notwithstanding the foregoing, Company (or any Permitted Lessee) may, at any time, remove any Part from the Airframe or any Engine if such Part: (i) is in addition to, and not in replacement of or substitution for, any Part originally incorporated or installed in or attached to the Airframe or such Engine at the time of delivery thereof to Company or any Part in replacement of, or substitution for, any such Part, (ii) is not required to be incorporated or installed in or attached or added to the Airframe or such Engine pursuant to the first sentence of this Section 7.04(c) and (iii) can be removed from the Airframe or such Engine without materially diminishing the value or utility required to be maintained by the terms of this Indenture that the Airframe or such Engine would have had had such Part never been installed on the Airframe or such Engine. Upon the removal by Company (or any Permitted Lessee) of any Part as permitted by this Section 7.04(c), such removed Part shall, without further act, be free and clear of all rights and interests of Loan Trustee and the Lien of this Indenture and shall no longer be deemed a Part hereunder. Upon request of Company from time to time, Loan Trustee shall execute and deliver to Company instruments reasonably requested by Company confirming the release of any such removed Part from the Lien of this Indenture. Loan Trustee acknowledges that it has no interest in the Excluded Equipment. Notwithstanding the provisions of this Section 7.04(c) or any other term or condition of this Indenture, Company (or any Permitted Lessee) may from time to time install on, and remove from, the Aircraft equipment that is owned by, leased to or conditionally sold to Company (or any Permitted Lessee) (and title to such equipment shall remain vested in Company, such Permitted Lessee, or the lessor or the conditional vendor thereof) if (1) such equipment is Excluded Equipment and (2) the location affected by any such removal, if damaged, is repaired prior to return, in a workmanlike manner, to a condition suitable for commercial passenger service; provided that all costs of installation, removal and replacement shall be the responsibility of Company.
Change and Modifications This Agreement may not be orally changed, modified or terminated, nor shall any oral waiver of any of its terms be effective. This Agreement may be changed, modified or terminated only by an agreement in writing signed by the Company and the Optionee.
TERMINATION AND MODIFICATION 271 - This Agreement shall continue in full force and effect from the date hereof until 11:59 p.m., June 30, 2002, and from year to year thereafter unless notice of termination or modification is given as provided in Paragraphs 273, 274, and 275 below. 272 - If either party desires to terminate this Agreement, it shall, sixty (60) days prior to the termination date, give written notice of termination. If neither party shall give notice of termination of this Agreement as provided in this paragraph or notice of amendment, as hereinafter provided, or if each party giving a notice of termination withdraws the same prior to termination date, this Agreement shall continue in effect from year to year thereafter subject to notice of termination by either party on sixty (60) days written notice prior to the current year's termination date. 273 - If either party desires to modify or change this Agreement, it shall sixty (60) days prior to the termination date or any subsequent termination date, give written notice of amendment in which event the notice of amendment shall set forth the nature of the amendment or amendments desired. If notice of amendment of this Agreement has been given in accordance with this paragraph, this Agreement may be terminated by either party on ten (10) days written notice of termination but not before the effective termination date of this Agreement. Any amendments that may be agreed upon shall become and be a part of this Agreement without modifying or changing any of the other terms of this Agreement. 274 - Notice of Termination Modification. Notice shall be in writing and shall be sufficient if sent by certified mail addressed to the Union, and if to the Employer, addressed to Director, Employee Relations, or to any such address as the Union or the Employer may make available to each other. 275 - This Agreement shall be effective from and after July 1, 1999, until and including June 30, 2002, with respect to all provisions of this Agreement.
CONTRACT MODIFICATION The following is adopted as the new CTC for the Contract effective December 29, 2022:
