SystemWeaver2EAXML Transformation Sample Clauses

SystemWeaver2EAXML Transformation. The figure shown below is a demonstration for the transformation between SystemWeaver and EAXML. The above transformation is divided into Auxiliary and main transformations. The main transformation is the transformation where different analysis is required. As the references and the size of the meta-model are big, the rules and mappings are more in number and in complexity than it is shown at the table. Mapping for the main transformation of the export is shown below. Items TOP-LEVEL-PACKAGES Item Elements, EA-PACKAGES, SUB-PACKAGES , Dependability etc Part HARDWARE-COMPONENT-PROTOTYPE, prototypes, ports etc Id UUID Name Name shortName SHORT-NAME Node instanceRef Type isOfType
AutoNDA by SimpleDocs
SystemWeaver2EAXML Transformation. The figure shown below is a demonstration for the transformation between SystemWeaver and EAXML. The above transformation is divided into Auxiliary and main transformations. The main transformation is the transformation where different analysis is required. As the references and the size of the meta-model are big, the rules and mappings are more in number and in complexity than it is shown at the table. Mapping for the main transformation of the export is shown below. Name Mapped to Items TOP-LEVEL-PACKAGES Item Elements, EA-PACKAGES, SUB-PACKAGES SENSOR, NODE, POWER-SUPPLY, ACTUATOR etc. Part HARDWARE-COMPONENT-PROTOTYPE Id UUID Name Name shortName SHORT-NAME Node instanceRef Type isOfType

Related to SystemWeaver2EAXML Transformation

  • Unbundled Channelization (Multiplexing) 5.7.1 To the extent NewPhone is purchasing DS1 or DS3 or STS-1 Dedicated Transport pursuant to this Agreement, Unbundled Channelization (UC) provides the optional multiplexing capability that will allow a DS1 (1.544 Mbps) or DS3 (44.736 Mbps) or STS-1 (51.84 Mbps) Network Elements to be multiplexed or channelized at a BellSouth central office. Channelization can be accomplished through the use of a multiplexer or a digital cross-connect system at the discretion of BellSouth. Once UC has been installed, NewPhone may request channel activation on a channelized facility and BellSouth shall connect the requested facilities via COCIs. The COCI must be compatible with the lower capacity facility and ordered with the lower capacity facility. This service is available as defined in NECA 4. 5.7.2 BellSouth shall make available the following channelization systems and interfaces: 5.7.2.1 DS1 Channelization System: channelizes a DS1 signal into a maximum of twenty- four (24)

  • Start-Up and Synchronization Consistent with the mutually acceptable procedures of the Developer and Connecting Transmission Owner, the Developer is responsible for the proper synchronization of the Large Generating Facility to the New York State Transmission System in accordance with NYISO and Connecting Transmission Owner procedures and requirements.

  • System Logging The system must maintain an automated audit trail which can 20 identify the user or system process which initiates a request for PHI COUNTY discloses to 21 CONTRACTOR or CONTRACTOR creates, receives, maintains, or transmits on behalf of COUNTY, 22 or which alters such PHI. The audit trail must be date and time stamped, must log both successful and 23 failed accesses, must be read only, and must be restricted to authorized users. If such PHI is stored in a 24 database, database logging functionality must be enabled. Audit trail data must be archived for at least 3 25 years after occurrence.

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CSTC chooses to subtend a Verizon access Tandem, CSTC’s NPA/NXX must be assigned by CSTC to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG. 9.2.2 CSTC shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from CSTC’s Customers. 9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office CSTC utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA. 9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow CSTC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.

  • Signaling Link Transport 9.2.1 Signaling Link Transport is a set of two or four dedicated 56 kbps transmission paths between Global Connection-designated Signaling Points of Interconnection that provide appropriate physical diversity.

  • Fabrication Making up data or results and recording or reporting them.

  • INTERNATIONAL TRANSPORT 1. Profits of an enterprise of a Contracting State from the operation of ships, aircraft or road-transport vehicles in international traffic shall be taxable only in that State. 2. The provisions of paragraph 1 shall also apply to profits from participation in a pool, a joint business or an international operating agency.

  • Manufacturing (a) The Supplier shall without limitation be responsible, at no additional cost to the Purchaser, for: sourcing and procuring all raw materials for the Products; obtaining all necessary approvals, permits and licenses for the manufacturing of the Products; providing sufficient qualified staff and workers to perform the obligations under this Purchase Agreement; implementing and maintaining effective inventory and production control procedures with respect to the Products; and handling other matters as reasonably requested by the Purchaser from time to time. (b) The Supplier shall not change any process, material, component, packaging or manufacturing location without the Purchaser’s express prior written approval.

  • Drainage Systems (1) Clear culvert inlets, outlets, and sediment catching basins. (2) Maintain waterbars, drainage dips, and other water diversion measures. (3) During active use, patrol and maintain functional drainage. (4) Repair damaged culvert ends.

  • Information Systems Acquisition Development and Maintenance a. Client Data – Client Data will only be used by State Street for the purposes specified in this Agreement.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!