License Agreement The Trust shall have the non-exclusive right to use the name "Invesco" to designate any current or future series of shares only so long as Invesco Advisers, Inc. serves as investment manager or adviser to the Trust with respect to such series of shares.
End User License Agreement This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivs 3.0 Unported License. xxxx://xxxxxxxxxxxxxxx.xxx/licenses/by-nc-nd/3.0/ You are free to: Share: to copy, distribute and transmit the work Under the following conditions: Attribution: You must attribute the work in the manner specified by the author (but not in any way that suggests that they endorse you or your use of the work).
Sublicense Agreements Sublicenses under this Section 2.3 shall be granted only pursuant to written agreements, which shall be subject to and consistent with the terms and conditions of this Agreement. Such Sublicense agreements shall contain, among other things, provisions to the following effect:
2.3.2.1 all provisions necessary to ensure Licensee’s ability to comply with Licensee’s obligation under or not violate the provisions of Sections 4.4, 4.5, 4.6, 5.1, 5.3, 5.4, 8.1 and 11.1;
2.3.2.2 a section substantially the same as Article 9 (Indemnification), which also shall state that the Indemnitees (as defined in Section 9.1) are intended third party beneficiaries of such Sublicense agreement for the purpose of enforcing such indemnification;
2.3.2.3 in the event of termination of the license set forth in Section 2.1.1 above (in whole or in part (e.g., termination of the license as to a Licensed Product or in a particular country)), any existing Sublicense shall terminate to the extent of such terminated license; provided, however, that, for each Sublicensee, upon termination of the license, if the Sublicensee is not then in breach of the Sublicense agreement such that Licensee would have the right to terminate such Sublicense agreement, such Sublicensee shall have the right to obtain a license from Harvard on the same terms and conditions as set forth herein, which shall not impose any representations, warranties, obligations or liabilities on Harvard that are not included in this Agreement, provided that (a) the scope of the license granted directly by Harvard to such Sublicensee shall be coextensive with the scope of the license granted by Licensee to such Sublicensee, (b) if the Sublicense granted to such Sublicensee was non-exclusive, such Sublicensee shall not have the right to participate in the prosecution or enforcement of the Patent Rights under the license granted to it directly by Harvard and (c) if there are more than one Sublicensee, each Sublicensee that is granted a direct license shall be responsible for a pro rata share of the reimbursement due under Section 6.2.3 of this Agreement (based on the number of direct licenses under the Patent Rights in effect on the date of reimbursement);
2.3.2.4 the Sublicensee shall only be entitled to sublicense its rights under such Sublicense agreement on the terms set forth in this Section 2.3; and
2.3.2.5 the Sublicensee shall not be entitled to assign the Sublicense agreement without the prior written consent of Harvard, except that Sublicensee may assign the Sublicense agreement to a successor in connection with the merger, consolidation or sale of all or substantially all of its assets or that portion of its business to which the Sublicense agreement relates; provided, however, that any permitted assignee agrees in writing in a manner reasonably satisfactory to Harvard to be bound by the terms of such Sublicense agreement.
Software License Agreement 1) Customers acquiring software licenses under the Contract shall hold, use and operate such software subject to compliance with the Software License Agreement set forth in Appendix D of this Contract. No changes to the Software License Agreement terms and conditions may be made unless previously agreed to between Vendor and DIR. Customers may not add, delete or alter any of the language in Appendix D; provided however, that a Customer and Vendor may agree to additional terms and conditions that do not diminish a term or condition in the Software License Agreement, or in any manner lessen the rights or protections of Customer or the responsibilities or liabilities of Vendor. Order Fulfiller shall make the Software License Agreement terms and conditions available to all Customers at all times.
2) Compliance with the Software License Agreement is the responsibility of the Customer. DIR shall not be responsible for any Customer’s compliance with the Software License Agreement. If DIR purchases software licenses for its own use under this Contract, it shall be responsible for its compliance with the Software License Agreement terms and conditions.
Manufacturing Technology Transfer Upon AbbVie’s written request with respect to a given Collaboration CAR-T Product and Licensed Product, Caribou shall effect a full transfer to AbbVie or its designee (which designee may be an Affiliate or a Third Party Provider) of all Materials and Know-How Controlled by Caribou relating to the then-current process for the Manufacture of such Collaboration CAR-T Product and any corresponding Licensed Products (each, a “Manufacturing Process”). Caribou shall provide, shall cause its Affiliates to provide, and shall use Commercially Reasonable Efforts to assist AbbVie in causing all Third Party Providers to provide, all reasonable assistance requested by AbbVie to enable AbbVie (or its Affiliate or designated Third Party Provider, as applicable) to implement each Manufacturing Process at the facilities designated by AbbVie. If requested by AbbVie, such assistance shall include facilitating the entering into of agreements with applicable Third Party suppliers relating to such Collaboration CAR-T Product and any corresponding Licensed Products. Without limitation of the foregoing, in connection with the Manufacturing Process and related transfer:
(a) Caribou shall, and shall cause its Affiliates to, make available to AbbVie (or its Affiliate or designated Third Party Provider, as applicable), and shall use Commercially Reasonable Efforts to assist AbbVie in causing all Third Party Providers to make available to AbbVie, from time to time as AbbVie may request, all Materials and Manufacturing-related Know-How Controlled by Caribou relating to each Manufacturing Process, including methods, reagents and processes and testing/characterization Know-How, and all documentation constituting material support, performance advice, shop practice, standard operating procedures, specifications as to Materials to be used, and control methods, that are necessary or reasonably useful to enable AbbVie (or its Affiliate or designated Third Party manufacturer, as applicable) to use and practice such Manufacturing Process;
(b) Caribou shall cause all appropriate employees and representatives of Caribou and its Affiliates, and shall use Commercially Reasonable Efforts to assist AbbVie in causing all appropriate employees and representatives of Third Party Providers, to meet with employees or representatives of AbbVie (or its Affiliate or designated Third Party Provider, as applicable) at the applicable manufacturing facility at mutually convenient times to assist with the working up and use of each Manufacturing Process and with the training of the personnel of AbbVie (or its Affiliate or designated Third Party Provider, as applicable) to the extent necessary or reasonably useful to enable AbbVie (or its Affiliate or designated Third Party Provider, as applicable) to use and practice such Manufacturing Process;
(c) Without limiting the generality of this Section 4.4.2, Caribou shall cause all appropriate analytical and quality control laboratory employees and representatives of Caribou and its Affiliates, and shall use Commercially Reasonable Efforts to assist AbbVie in causing all appropriate analytical and quality control laboratory employees and representatives of Third Party Providers, to meet with employees or representatives of AbbVie (or its Affiliate or designated Third Party Provider, as applicable) at the applicable manufacturing facility and make available all necessary equipment, at mutually convenient times, to support and execute the provision of all applicable analytical methods and the validation thereof (including all applicable Know-How, Information and Materials Controlled by Caribou, and sufficient supplies of all primary and other reference standards);
(d) Caribou shall, and shall cause its Affiliates to, take such steps, and shall use Commercially Reasonable Efforts to assist AbbVie in causing Third Party Providers take such steps, as are necessary or reasonably useful to assist AbbVie (or its Affiliate or designated Third Party Provider, as applicable) in obtaining any necessary licenses, permits or approvals from Regulatory Authorities with respect to the Manufacture of the applicable Collaboration CAR-T Products and corresponding Licensed Products at the applicable facilities; and
(e) Caribou shall, and shall cause its Affiliates to, provide, and shall use Commercially Reasonable Efforts to assist AbbVie in causing Third Party Providers to provide, such other assistance as AbbVie (or its Affiliate or designated Third Party Provider, as applicable) may reasonably request to enable AbbVie (or its Affiliate or designated Third Party Provider, as applicable) to use and practice each Manufacturing Process and otherwise to Manufacture the applicable Collaboration CAR-T Products and corresponding Licensed Products.
Technology Transfer (a) Sublicensee acknowledges and agrees that ECC has delivered and made to Sublicensee a disclosure of a general introduction to the Technology and to its commercial feasibility prior to the execution of this Agreement. Except to the extent such information falls within one or more of the exceptions to the definition of "Confidential Information", all information disclosed by ECC to Sublicensee prior to the execution of this Agreement shall be deemed to constitute part of the Technology and shall be deemed to be confidential. The timing and extent of additional disclosure by ECC to Sublicensee shall be as set forth in subparagraph 22(b) hereof.
(b) Upon execution of this Agreement, ECC shall provide Sublicensee with copies of the patents listed in Section B of Exhibit "B" hereto. Beyond that, ECC shall not be required to provide additional information concerning, or disclosure of, the Technology to Sublicensee until Sublicensee provides to ECC (i) written notice of Sublicensee's intent to commercialize a Product, which written notice shall include detailed specifications for the designated Product, and (ii) evidence, reasonably satisfactory to ECC, of Sublicensee's intent to commercialize the designated Product in the form of written documentation of orders placed by Sublicensee of the equipment needed by Sublicensee to produce and commercialize the designated Product or in the form of written documentation from Sublicensee confirming the dedication and/or modification of existing equipment necessary to produce the designated Product. Within ninety (90) days after ECC's receipt of the items described in the preceding sentence, ECC shall provide to Sublicensee the following additional disclosure: (w) a Product specific recipe for the production of the designated Product; (x) Product specific process specifications for the production of the designated Product; (y) copies of all patent applications listed in the Exhibits hereto that ECC deems relevant to the production of the designated Product; and (z) a list of known raw materials suppliers and preferred equipment vendors.
Collaboration Agreement The Collaboration Agreement shall not have been terminated in accordance with its terms and shall be in full force and effect.
License Agreements (a) Each Borrower and Guarantor shall (i) promptly and faithfully observe and perform all of the material terms, covenants, conditions and provisions of the material License Agreements to which it is a party to be observed and performed by it, at the times set forth therein, if any, (ii) not do, permit, suffer or refrain from doing anything that could reasonably be expected to result in a default under or breach of any of the terms of any material License Agreement, (iii) not cancel, surrender, modify, amend, waive or release any material License Agreement in any material respect or any term, provision or right of the licensee thereunder in any material respect, or consent to or permit to occur any of the foregoing; except, that, subject to Section 9.19(b) below, such Borrower or Guarantor may cancel, surrender or release any material License Agreement in the ordinary course of the business of such Borrower or Guarantor; provided, that, such Borrower or Guarantor (as the case may be) shall give Agent not less than thirty (30) days prior written notice of its intention to so cancel, surrender and release any such material License Agreement, (iv) give Agent prompt written notice of any material License Agreement entered into by such Borrower or Guarantor after the date hereof, together with a true, correct and complete copy thereof and such other information with respect thereto as Agent may request, (v) give Agent prompt written notice of any material breach of any obligation, or any default, by any party under any material License Agreement, and deliver to Agent (promptly upon the receipt thereof by such Borrower or Guarantor in the case of a notice to such Borrower or Guarantor and concurrently with the sending thereof in the case of a notice from such Borrower or Guarantor) a copy of each notice of default and every other notice and other communication received or delivered by such Borrower or Guarantor in connection with any material License Agreement which relates to the right of such Borrower or Guarantor to continue to use the property subject to such License Agreement, and (vi) furnish to Agent, promptly upon the request of Agent, such information and evidence as Agent may reasonably require from time to time concerning the observance, performance and compliance by such Borrower or Guarantor or the other party or parties thereto with the material terms, covenants or provisions of any material License Agreement.
(b) Each Borrower and Guarantor will either exercise any option to renew or extend the term of each material License Agreement to which it is a party in such manner as will cause the term of such material License Agreement to be effectively renewed or extended for the period provided by such option and give prompt written notice thereof to Agent or give Agent prior written notice that such Borrower or Guarantor does not intend to renew or extend the term of any such material License Agreement or that the term thereof shall otherwise be expiring, not less than sixty (60) days prior to the date of any such non-renewal or expiration. In the event of the failure of such Borrower or Guarantor to extend or renew any material License Agreement to which it is a party, Agent shall have, and is hereby granted, the irrevocable right and authority, at its option, to renew or extend the term of such material License Agreement, whether in its own name and behalf, or in the name and behalf of a designee or nominee of Agent or in the name and behalf of such Borrower or Guarantor, as Agent shall determine at any time that an Event of Default shall exist or have occurred and be continuing. Agent may, but shall not be required to, perform any or all of such obligations of such Borrower or Guarantor under any of the License Agreements, including, but not limited to, the payment of any or all sums due from such Borrower or Guarantor thereunder. Any sums so paid by Agent shall constitute part of the Obligations.
(c) No Borrower or Guarantor shall assign, sell, mortgage, lease, transfer, pledge, hypothecate, grant a security interest in or lien upon, encumber, grant an exclusive or non-exclusive license relating to any Intellectual Property, or otherwise dispose of any Intellectual Property, in each case without the prior written consent of Agent, except that any Borrower or Guarantor may, after written notice to Agent, grant a non-exclusive license relating to any Intellectual Property to another Borrower or Guarantor in the ordinary course of business.
Termination of License Agreement This Agreement will terminate automatically in the event that the License Agreement is terminated, provided that prior to such termination of this Agreement becoming effective, the Parties shall cooperate to wind down the activities being conducted hereunder as set forth in Section 15.5(b).
Technology License 4.1 Unless any event described in Article 2.2 or 2.3 of this Agreement occurs, all of the technology required to be licensed for any of Party B’s business shall be provided by Party A on an exclusive basis. Party A will try its best to license Party B to use the technology owned by Party A, or re-license Party B to use the technology as approved by the owner.
4.2 The Parties shall negotiate with each other to enter into specific technology license contracts to expressly specify the detail matters such as the technology to be licensed, the method to license the technology, license fees and payment.
