Tyre load. The static load on each axle shall remain the same throughout the test procedure. The static load on each tyre shall lie between 60 per cent and 100 per cent of the candidate tyre's load capacity. This value shall not exceed 100 per cent of the load capacity of the reference tyre. Tyre load on the same axle should not differ by more than 10 per cent. The use of fitting as per Configurations 2 and 3 shall fulfil the following additional requirements:
Appears in 7 contracts
Samples: Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles, Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles, Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles
Tyre load. The static load on each axle shall remain the same throughout the test procedure. The static load on each tyre shall lie between 60 per cent and 100 90 per cent of the candidate tyre's tested tyre load capacity. This value shall not exceed 100 per cent of the load capacity of the reference tyre. Tyre load loads on the same axle should not differ by more than 10 per cent. The use It is prohibited to exceed the maximum axle load of fitting as per Configurations 2 and 3 shall fulfil the following additional requirements:vehicle.
Appears in 4 contracts
Samples: Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles, Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles, Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles
Tyre load. The static load on each axle shall remain the same throughout the test procedure. The static load on each tyre shall lie between 60 per cent and 100 90 per cent of the candidate tyre's tested tyre load capacity. This value shall not exceed 100 per cent of the load capacity of the reference tyre. Tyre load loads on the same axle should not differ by more than 10 per cent. The use of fitting as per Configurations 2 and 3 shall fulfil the following additional requirements:.
Appears in 4 contracts
Samples: Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles, Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles, Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles
Tyre load. The static load on each axle shall remain the same throughout the test procedure. The static load on each tyre shall lie between 60 per cent and 100 90 per cent of the candidate tyre's tested tyre load capacity. This value shall not exceed 100 per cent of the load capacity of the reference tyre. Tyre load loads on the same axle should not differ by more than 10 per cent. The use It is prohibited to exceed the maximum axle load of fitting as per Configurations 2 and 3 shall fulfil the following additional requirements:vehicle."
Appears in 2 contracts
Samples: Agreement Concerning the Adoption of Harmonized Technical United Nations Regulations for Wheeled Vehicles, Agreement Concerning the Adoption of Harmonized Technical United Nations Regulations for Wheeled Vehicles
Tyre load. The static load on each axle shall remain the same throughout the test procedure. The static load on each tyre shall lie between 60 per cent and 100 per cent of the candidate tyre's load capacity. This value shall not exceed 100 per cent of the load capacity of the reference tyre. Tyre load on the same axle should not differ by more than 10 per cent. The use of fitting as per Configurations 2 configurations Conf.2 and 3 Conf.3 shall fulfil the following additional requirements:
Appears in 1 contract
Samples: Proposal for Supplement 5 to the 02 Series of Amendments to Regulation No. 117
