, amend to read. 6.1.1.1. The section width shall be calculated by the following formula: 𝑆 = 𝑆1 + 𝐾 ∙ (𝐴 − 𝐴1), where: S is the section width rounded to the nearest millimetre; S1 is the nominal section width (in mm) as shown on the side wall of the tyre in the designation of the tyre as prescribed; A is the width (expressed in mm) of the measuring rim, as shown by the manufacturer in the descriptive note; 5/ A1 is the width (expressed in mm) of the theoretical rim. A1 shall be taken to equal S1 multiplied by the factor x, as specified by the manufacturer, and K shall be taken to equal 0.4." Footnote 5/, amend to read: "5/ When the rim width is given by code, the value in mm is obtained by multiplying such number by 25.4."
, amend to read. For motorcycles having a cylinder capacity > 125 cm3 One or two of approved type according to:
, amend to read. 6.1. Main-beam headlamp (UN Regulations Nos. 98, 112 and [RID])"
, amend to read. 2.1. The vehicle shall include a specific indicator on the dashboard that informs the driver when reagent levels are below the threshold values specified in paragraph 3.5. of this appendix."
, amend to read. 3.1. The vehicle shall include a warning system consisting of visual alarms that informs the driver when an abnormality is detected in the reagent dosing e.g. when emissions are too high, the reagent level is low, reagent dosing is interrupted, or the reagent is not of a quality specified by the manufacturer. The warning system may also include an audible component to alert the driver." Paragraph 3.4., amend the last sentence to read:
, amend to read. In the case of a single lamp containing more than one light source when all light sources are illuminated the maximum intensities shall not be exceeded."
, amend to read. The warning system shall activate at a distance equivalent to a driving range of at least 2,400 km in advance of the reagent tank becoming empty, or at the choice of the manufacturer at the latest when the level of reagent in the tank reaches one of the following levels:
, amend to read. Together with the application, the manufacturer shall provide a documentation package that fully explains any element of design which affects emissions, the emission control strategy of the engine system, the means by which the engine system controls the output variables which have a bearing upon emissions, whether that control is direct or indirect, anti-tampering measures and fully explains the warning and inducement system required by paragraphs 4. and 5. of Annex 11. The documentation package shall be identified and dated by the approval authority and kept by that authority for at least 10 years after the approval is granted. The documentation package shall consist of the following parts:
, amend to read. If, in the case … standard light source."
, amend to read. 1.1. This Regulation applies to new pneumatic tyres of Classes C1, C2 and C3 with regard to their sound emissions, rolling resistance and to adhesion performance on wet surfaces (wet adhesion). It does not, however, apply to:"
