Georgia Security and Immigration Compliance Act Requirements No bid will be considered unless the Contractor certifies its compliance with the Immigration reform and Control Act of 1986 (IRCA), D.L. 99-603 and the Georgia Security Immigration Compliance Act OCGA 13-10-91 et seq. The Contractor shall execute the Georgia Security and Immigration Compliance Act Affidavit, as found in Section 7 of the Construction Contract. Contractor also agrees that it will execute any affidavits required by the rules and regulations issued by the Georgia Department of Audits and Accounts. If the Contractor is the successful bidder, contractor warrants that it will include a similar provision in all written agreements with any subcontractors engaged to perform services under the Contract.
Federal Medicaid System Security Requirements Compliance Party shall provide a security plan, risk assessment, and security controls review document within three months of the start date of this Agreement (and update it annually thereafter) in order to support audit compliance with 45 CFR 95.621 subpart F, ADP System Security Requirements and Review Process.
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
Subsidy Requests and Reporting Requirements 1. The Grantee or Management Company shall complete a CRF Subsidy Request Report - Recap of Tenant Income Certification, which provides a unit-by-unit listing of all units in the Development for whom assistance is being requested and gives detailed information including the occupants’ eligibility, set-aside requirements, amount of household rent paid, utility allowance and amount of CRF Rental Subsidy requested.
Fingerprinting Requirements Contractor hereby acknowledges that, if applicable, it is required to comply with the requirements of Education Code Section 45125.1 with respect to fingerprinting of employees who may have contact with the District's students. The Contractor shall also ensure that its Contractors on the Project also comply with the requirements of Section 45125.1. If required by Education Code Section 45125.1, the Contractor must provide for the completion of a Fingerprint Certification form, in the District’s required format, prior to any of the Contractor's employees, or those of any other Contractors, coming into contact with the District's students. Contractor further acknowledges that other fingerprinting requirements may apply, as set forth in Education Code Section 45125 et seq., and will comply with any such requirements.
RECORDS USAGE, DUPLICATION AND REDISCLOSURE RESTRICTIONS USAC and the Department agree to these restrictions on use, duplication, and disclosure of information furnished by the other Party:
Certification of Meeting or Exceeding Tobacco-Free Workplace Policy Minimum Standards A. Grantee certifies that it has adopted and enforces a Tobacco-Free Workplace Policy that meets or exceeds all of the following minimum standards of:
Compliance with Xxxxx-Xxxxx and Related Act requirements All rulings and interpretations of the Xxxxx-Xxxxx and Related Acts contained in 29 CFR parts 1, 3, and 5 are herein incorporated by reference in this contract.
ADMINISTRATIVE AND REPORTING REQUIREMENTS Contractor shall furnish a report of all services provided under the Contract during each quarterly period, no later than the 15th of the month following the close of each quarter. Purchases by Non-State agencies, political subdivisions and others authorized by law shall be reported in the same report and indicated as required. A template for such report is included herein as Attachment 5 – Report of Contract Usage. The report must be submitted electronically via electronic mail utilizing the template provided. All fields of information shall be accurate and complete. The report is to be submitted electronically in Microsoft Excel 2007 or 2003 (or as otherwise directed by OGS), via electronic mail to the attention of the individual identified on the front page of the Contract Award Notification and shall reference the Group Number, the Award Number, Contract Number, sales period, and Contractor’s (or other authorized agent) name, and all other fields required, using the report template provided. OGS reserves the right to amend the report template. Additional related sales information and/or detailed Authorized User purchases may be required by OGS and must be supplied within 30 days upon request.
SMALL BUSINESS PARTICIPATION AND DVBE PARTICIPATION REPORTING REQUIREMENTS a. If for this Contract Contractor made a commitment to achieve small business participation, then Contractor must within 60 days of receiving final payment under this Contract (or within such other time period as may be specified elsewhere in this Contract) report to the awarding department the actual percentage of small business participation that was achieved. (Govt. Code § 14841.)