Category C waters definition

Category C waters means waters designated category C waters in the Merchant Shipping (Categorisation of Waters) Regulations 1992, SI 1992 No.2356 and Merchant Shipping Notice No.M.1504;
Sample 1Sample 2Sample 3
Category C waters means waters designated category C waters in the Merchant Shipping (Categorisation of Waters) Regulations 1992, (SI 1992 No. 2356), as amended, and Merchant Shipping Notice MSN 1827(M) – Categorisation of Waters;
Sample 1Sample 2Sample 3

Examples of Category C waters in a sentence

  • UK MSN 1823(M) “Safety Code for passenger Ships Operating Solely in UK Categorised Waters” as applicable to operation in Category C waters including Annex 5 & 6.b. UK MGN 306(M) “Designing and Operating Smaller Passenger Vessels: Guidance on Meeting the Needs of Persons with Reduced Mobility”.c.

  • Going “to Sea” is defined as beyond MCA Category D waters or Category C waters if there are no Category D waters.

  • A vessel should be provided with watertight bulkheads which are arranged such that minor hull damage which results in the free-flooding of any two compartments for craft operating in Category C waters and one compartment for craft in Category A & B waters up to a maximum of 250 passengers, will not cause the vessel to float at a waterline which is less than 75mm below the weather deck at any point.

  • Category "C" waters develop to more acid pH and increasing conductivity values.Backfilling parts of the pit with acid generating rock will have a profound impact on the water quality of a future pit lake.

  • If the angle of heel is less than that given in Table 6 above, and the freeboard margin is more than 150mm for Category A or B waters, or 200mm for Category C waters, the boat has passed.

  • Freeboard requirements are higher where flotation is not fitted.The following open powered boats must comply with the flotation requirements of section 6.4 and Annex B of ISO 12217-3 except the One Person test is not required for boats where the hull length is greater than 6m:− Less than 4m LH in Category A waters − Less than 4.5m LH in Category B waters − Less than 5m LH in Category C waters − All those in Category D watersBoats under 4m length may not be operated outside of MCA Category A or B waters.

  • Recognising the different operational environment of non-tidal Category C waters, it was proposed that vessels in these areas could continue to operate with their existing requirements subject to a risk assessment carried out to an agreed standard and covering an agreed set of minimum considerations.

  • The rationale for the exclusion of Class VI vessels would be based on the fact that Class VI vessels already have inbuilt operational restrictions in their certification and are therefore limited to daylight only operations between April and October in favourable weather only.) Excluding Class V vessels on non-tidal Category C waters is reflects the lower operational risk in these areas due to factors including traffic density and make up, speed limits and daylight only operation.

  • It is proposed to require all vessels operating at sea, on Category D and Category C (tidal) waters to achieve a level of damage survivability, with the exception (following revision after the first consultation) of Class VI non-subdivided vessels, and Class V vessels operating on non-tidal Category C waters in daylight.

  • This is not feasible to estimate without knowing the revenue of the affected vessels.We have not monetised any costs related to preparing risk assessments for areas of tidal Category C waters that are being assessed with respect to operational risk with a view to exemption from the proposed requirements.

Related to Category C waters

  • Category 3 means those affected lands and support facilities if those lands supported operations which were not completed or substantially completed prior to July 1, 1973 (the effective date of the Wyoming Environmental Quality Act) and any affected lands or support facilities taken out of use on or after July 1, 1973 and before May 25, 1975 (the effective date of the Division’s 1975 Rules and Regulations).

  • Category B means that the base prospectus shall include all the general principles related to the information required, and only the details which are unknown at the time of the approval of the base prospectus can be left in blank for later insertion in the final terms;

  • Low-level radioactive waste or “waste” means radioactive material that consists of or contains class A, B, or C radioactive waste as defined by 10 C.F.R. 61.55, as in effect on January 26, 1983, but does not include waste or material that is any of the following:

  • Category 4 Data is data that is confidential and requires special handling due to statutes or regulations that require especially strict protection of the data and from which especially serious consequences may arise in the event of any compromise of such data. Data classified as Category 4 includes but is not limited to data protected by: the Health Insurance Portability and Accountability Act (HIPAA), Pub. L. 104-191 as amended by the Health Information Technology for Economic and Clinical Health Act of 2009 (HITECH), 45 CFR Parts 160 and 164; the Family Educational Rights and Privacy Act (FERPA), 20 U.S.C. §1232g; 34 CFR Part 99; Internal Revenue Service Publication 1075 (xxxxx://xxx.xxx.xxx/pub/irs-pdf/p1075.pdf); Substance Abuse and Mental Health Services Administration regulations on Confidentiality of Alcohol and Drug Abuse Patient Records, 42 CFR Part 2; and/or Criminal Justice Information Services, 28 CFR Part 20.

  • Category 2 Training: This category includes services related to training state employees to understand and apply Agile concepts and tools.

  • Category A means the relevant information which shall be included in the base prospectus. This information cannot be left in blank for later insertion in the final terms;

  • Peak tube potential means the maximum value of the potential difference across the x-ray tube during an exposure.

  • Mean Sea Level means the average height of the sea for all stages of the tide. It is used as a reference for establishing various elevations within the floodplain. For the purposes of this Ordinance, the term is synonymous with the National Geodetic Vertical Datum (NGVD) of 1929, the North American Vertical Datum (NAVD) of 1988, or other datum, to which Base Flood Elevations shown on a community's Flood Insurance Rate Map are referenced.

  • Seasonal high water table means the highest zone of soil or rock that is seasonally or permanently saturated by a perched or shallow water table. A planar surface, below which all pores in rock or soil (whether primary or secondary) that is seasonally or permanently saturated.

  • Category 1 means medical education activities that have been designated as Category 1 by the Accreditation Council for Continuing Medical Education (ACCME), the American Osteopathic Association (AOA), a state medical society, or an equivalent organization.

  • Barrier Level means the Barrier Level as specified in § 1 of the Product and Underlying Data.

  • Digital Signal Level 1 (DS-1 means the 1.544 Mbps first level signal in the time division multiplex hierarchy.

  • Digital Signal Level 0 (DS-0 means the lowest-level signal in the time division multiplex digital hierarchy, and represents a voice-grade channel operating at either the 56 Kbps or 64 Kbps transmission bit rates. There are twenty-four (24) DS-0 channels in a DS-1.

  • Working level (WL) means any combination of short-lived radon daughters in 1 liter of air that will result in the ultimate emission of 1.3E+5 MeV of potential alpha particle energy. The short-lived radon daughters are—for radon-222: polonium-218, lead-214, bismuth-214, and polonium-214; and for radon-220: polonium-216, lead-212, bismuth-212, and polonium-212.

  • Tier 1 Help Desk means Customer's point of contact(s) to provide all Tier 1 Support within Customer's organization(s).

  • chemical tanker means a ship constructed or adapted and used for the carriage in bulk of any liquid product listed in chapter 17 of the International Bulk Chemical Code;

  • Digital Signal Level 3 (DS-3 means the 44.736 Mbps third level signal in the time division multiplex hierarchy.

  • Working level month (WLM) means an exposure to 1 working level for 170 hours (2,000 working hours per year divided by 12 months per year is approximately equal to 170 hours per month).

  • Sewage sludge fee weight means the weight of sewage sludge, in dry U.S. tons, excluding admixtures such as liming materials or bulking agents. Annual sewage sludge fees, as per section 3745.11(Y) of the Ohio Revised Code, are based on the reported sludge fee weight for the most recent calendar year.

  • Base Load Generation Resource means a Generation Capacity Resource that operates at least 90 percent of the hours that it is available to operate, as determined by the Office of the Interconnection in accordance with the PJM Manuals.

  • Market Participant Energy Injection means transactions in the Day-ahead Energy Market and Real-time Energy Market, including but not limited to Day-ahead generation schedules, real- time generation output, Increment Offers, internal bilateral transactions and import transactions, as further described in the PJM Manuals.

  • High global warming potential hydrofluorocarbons means any hydrofluorocarbons in a particular end use for which EPA’s Significant New Alternatives Policy (SNAP) program has identified other acceptable alternatives that have lower global warming potential. The SNAP list of alternatives is found at 40 CFR part 82, subpart G, with supplemental tables of alternatives available at (http://www.epa.gov/snap/ ).

  • eligible Categories means Categories (1), (2) and (3) set forth in the table in paragraph 1 of Schedule 1 to this Agreement;

  • Nominated Energy Efficiency Value means the amount of load reduction that an Energy Efficiency Resource commits to provide through installation of more efficient devices or equipment or implementation of more efficient processes or systems.

  • Measurement Point means the emission source for which continuous emission measurement systems (CEMS) are used for emission measurement, or the cross-section of a pipeline system for which the CO2 flow is determined using continuous measurement systems;

  • Nominal tomographic section thickness means the full width at half-maximum of the sensitivity profile taken at the center of the cross-sectional volume over which x-ray transmission data are collected.